Rotel RSX-1065 Handleiding

Rotel Receiver RSX-1065

Lees hieronder de 📖 handleiding in het Nederlandse voor Rotel RSX-1065 (31 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/31
Owner’s Manual
RSX-1065
Surround Sound Receiver
SUR ROUN D S OUND REC EIVER RS X-1065
PO WER
VOL UME
BAS S TR EBL E
OPT COAX
DIGI TAL
PRO LO GIC
dts
RDS ZONE
PRESET
TUNED
DSP
1 2 3 4 5 A 5.1 7.1 FL C FR SL SR
SW
Sbl
Sbr
Sb ST
1 2 3 4 5
6 7 8 9 0 MEM ORYDIREC T
BAN DTUN ING
MON O
CD TUN ER TA PE VI DEO1 VIDEO2 VIDEO 3 VIDEO 4 VIDEO5
2CH
3
ST ERE O PR O
LOGIC II DS P MULT I
INP UT DYNAM IC
RAN GE RECZO NE
Important Safety Instructions
WARNING: There are no user serviceable parts inside. Refer
all servicing to qualified service personnel.
WARNING: To reduce the risk of fire or electric shock, do not
expose the unit to moisture or water. Do not allow foreign
objects to get into the enclosure. If the unit is exposed to moisture,
or a foreign object gets into the enclosure, immediately dis-
connect the power cord from the wall. Take the unit to a qualified
service person for inspection and necessary repairs.
Read all the instructions before connecting or operating the component.
Keep this manual so you can refer to these safety instructions.
Heed all warnings and safety information in these instructions and on the
product itself. Follow all operating instructions.
Clean the enclosure only with a dry cloth or a vacuum cleaner.
You must allow 10 cm or 4 inches of unobstructed clearance around the
unit. Do not place the unit on a bed, sofa, rug, or similar surface that could
block the ventilation openings. If the unit is placed in a bookcase or cabi-
net, there must be ventilation of the cabinet to allow proper cooling.
Keep the component away from radiators, heat registers, stoves, or any
other appliance that produces heat.
The unit must be connected to a power supply only of the type and voltage
specified on the rear panel. (USA: 115 V/60Hz, EC: 230V/50Hz)
Connect the component to the power outlet only with the supplied power
supply cable or an exact equivalent. Do not modify the supplied cable. Do
not defeat grounding and/or polarization provisions. The cable should be
connected to a 2-pin polarized wall outlet, matching the wide blade of the
plug to the wide slot of the receptacle. Do not use extension cords.
Do not route the power cord where it will be crushed, pinched, bent, ex-
posed to heat, or damaged in any way. Pay particular attention to the power
cord at the plug and where it exits the back of the unit.
The power cord should be unplugged from the wall outlet if the unit is to be
left unused for a long period of time.
Immediately stop using the component and have it inspected and/or ser-
viced by a qualified service agency if:
• The power supply cord or plug has been damaged.
• Objects have fallen or liquid has been spilled into the unit.
• The unit has been exposed to rain.
• The unit shows signs of improper operation
• The unit has been dropped or damaged in any way
NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna
installer’s attention to Article 820-40 of the NEC. This provides guidelines
for proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as close to the
point of cable entry as practical. See installation diagram.
NOTE: This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against interference
in a residential installation. This equipment generates and can radiate ra-
dio frequency energy and, if not installed and used in accordance with the
instructions, may cause interference to radio or TV communications. There
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, try to cor-
rect the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the unit and the television tuner.
• Connect the unit to an AC power outlet on a different electrical circuit.
• Consult your authorized Rotel retailer for assistance.
3
1: Controls and Connections
Y
CR
CB
REAR R
CB 2FRONT R
SUB 2 CENTER 2
2
VIDEO INTAPE
1 43 5IN
CD
OUT 2
L
R
VIDEO OUT
DIGITAL INPUT
COAXIALOPTICAL
1 2
OPTICAL
DIGITAL OUTPUT
1 3
2
COMPOSITE IN
1 43 5 2
COMPOSITE OUT
1 3 2
S-VIDEO IN
1 43 5
S-VIDEO OUT
ZONE 2
OUT
ZONE
REM
KEYPAD COMPUTER
I/O
IR
OUT
1 2
EXT
REM 12V TRIG
OUT
21 3
MON
OUT
CENTER
SUB
REAR L
CB
FRONT L
REAR R
FRONT R
L
R
21 3
COAXIAL
MULTI CH INPUT
ANTENNA
21
COMPONENT VIDEO
MON
OUT
AM
LOOP
IN
1
2
1 2 3 4 5
6 7 8 9 0 MEMORYDIRECT
BANDTUNING
MONO
CD TUNER TAPE VIDEO1 VIDEO2 VIDEO3 VIDEO4 VIDEO5
2CH
3
STEREO
PRO
LOGIC II DSP MULTI
INPUT DYNAMIC
RANGE RECZONE
SURROUND SOUND RECEIVER RSX-1065
POWER
VOLUME
BASS TREBLE
OPT COAX
DIGITAL
PRO LOGIC
dts
RDS ZONE
PRESET
TUNED
DSP
1 2 3 4 5 A 5.1 7.1 FL C FR SL SR
SW
Sbl
Sbr
Sb ST
CENT ER
SPEAKERS
SURROUND
RIGHT
FRONT FRONT
LEFT
SURROUND
MON
OUT
REAR L SUB 1 CENTER 1
CB1
FRONT L
PREOUT
SOFTWARE
UPGRADABLE
SPEAKER IMPEDANCE
4 OHMS MINIMUM
T his device complies wit h Part 15 of the FCC Rules.
Oper ation is subject to the f ollowing two c ondit ions:
Manufactured under license f rom Dolby Laboratories Licensing Corporation. "Dolby", "Pro Logic"
and the double-D symbol are trademarks of Dolby Laboraties Licensing Corporation.
Conf idential unpublished works © 1992-1997 Dolby Laboraties, Inc. All rights reserved.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTICAL SHOCK,
DO NOT EXPOSE T HIS EQUIPMENT T O RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE–NE PAS OUVRIR
WARNING:
SHOCK HAZARD DO NOT OPEN
SURROUND SOUND RECEIV R
MODEL NO. RSX-1065
POWER CONSUMPTION: 500 WAT T S
RSX-1065
SWITCHED
200W MAX
(1) T his device may not cause harmful nterference, and
(2) this device must accept any interfe ence re eived,
including interference that may cause ndesir e operation.
Manufact ured under license from Digital T heat er
System, Inc. US Pat. No. 5,451,242 and other
world-wide pat ents, issues and pending. "DTS",
DTS Digital surround", are trademarks of Digital
T heat er Sys tem, Inc. All rights reserved.
HDCD ® , High Def nition Compatible Digital ®
and Pacific Microsonicsâ„¢
are eith r registered trademarks or trademarks of Pacific Microsonics, Inc. in the
United States and/or other countries. HDCD system manufactured under license f om
Pacific Microsonics, Inc. This product is covered by one or more of the following: In the
USA: 5,479,168, 5,638,074, 5,640,161, 5,808,574, 5,838,274, 5,854,600,
5,864,311, 5,872,531, and in Australia: 669114. Other patents pending.
5
13 14
15 18
16 17 19 20
6 7 8 10 129 11
4321
42 44
46
37 40
36
24 25 32 33 34
29 3527
45
262221 23 28 30 31
38
41 4339


Product specificaties

Merk: Rotel
Categorie: Receiver
Model: RSX-1065

Heb je hulp nodig?

Als je hulp nodig hebt met Rotel RSX-1065 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Receiver Rotel

Handleiding Receiver

Nieuwste handleidingen voor Receiver