QTX QTFX-B4 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor QTX QTFX-B4 (5 pagina's) in de categorie Effect machine. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/5
www.avsl.com 1 5 UK Manual 60. 64
QTFX- B4
Professional Bubble Machine
Item ref: 160.564UK
User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
www.avsl.com 1 5 UK Manu 60. 64 al
Introduction
Thank you for choosing the QTFX-B4 professional bubble machine as part of your stage effects setup. This
machine is the highest output model in the range and will provide consistent large area coverage. Please read
and keep this manual to ensure maximum performance and avoid damage through misuse.
Unpacking
Your QTFX-B4 should reach you in good condition and should be supplied with IEC mains lead(s) and a wired
handheld remote control. If there are any signs of damage or items missing from the packaging, contact your
dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on the housing or through the vents, disconnect the mains, allow the QTFX- to dry out B4
and have it checked by qualified personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open the case.
Refer all servicing to qualified service personnel.
Placement
The QTFX- has an open front fluid tank and should be operated in an upright position. B4
Choose a position where the bubble output is facing the area to be filled.
Ensure easy access to the rear panel and to the bubble fluid tank for refilling and cleaning.
When moving the unit around, take care not to spill the contents of the tank inside the machine.
Safety
• Check for correct mains voltage and condition of IEC lead before connecting to power outlet
• Check the condition of the remote lead and ensure that it is not trapped
• This unit must be earthed
Cleaning
• Use a soft dry or slightly damp cloth to clean the casing
• Do not use strong solvents for cleaning the unit
• Empty contents and rinse the bubble fluid tanks after each use
Setting up
The QTFX- requires bubble fluid to produce the effect. B4
It is recommended to use qtx bubble fluid for best results (160.574UK, 160.575UK)
For bubbles that glow in UV light, qtx UV bubble fluid may be used (160.576UK, 160.577UK)
A chart for recommended fluids is included further along in this document
• Pour bubble fluid directly into the front open tank, taking care not to spill on fans beneath the tank
• Connect the supplied remote control to the female IEC on the rear panel
• Connect the IEC mains plug
www.avsl.com 1 5 UK Manu 60. 64 al
Layout
1. Bubble wand
2. Bubble wheel
3. Tank (pour fluid in here)
4. Front fans (do not cover)
5. Carry handle
6. Castor wheels
Rear panel
7. Rear Fans
8. IEC Power Socket
9. ON/OFF/REMOTE Switch
10. Fluid drain tap
11. Remote Socket
Operation
The QTFX-B4 is operated by a 3-position rocker switch. The centre position is off.
Press this switch to the left for constant bubble output.
Press this switch to the right for remote control of the bubble effec t.
In this mode, bubbles are only produced when the switch on the remote control is pressed.
After use, switch off the machine and disconnect from the mains.
Drain the remaining fluid via the drain tap at the rear of the unit.
Rinse the bubble fluid tank with clean water and drain this also, then close the tap.


Product specificaties

Merk: QTX
Categorie: Effect machine
Model: QTFX-B4

Heb je hulp nodig?

Als je hulp nodig hebt met QTX QTFX-B4 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Effect machine QTX

Handleiding Effect machine

Nieuwste handleidingen voor Effect machine