QTX Bubble-Box Handleiding

QTX Effect machine Bubble-Box

Lees hieronder de 📖 handleiding in het Nederlandse voor QTX Bubble-Box (4 pagina's) in de categorie Effect machine. Deze handleiding was nuttig voor 87 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
www.avsl.com 1 5 UK Manual 60. 50
BUBBLE-BOX
Bubble Machine
Item ref: 160.5 50UK
User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
www.avsl.com 5 UK Manual 160. 50
Introduction
Thank you for choosing the BUBBLE- bubble m hine as part of your stage effects setup. This machine is BOX ac
a high output, compact model and will provide consistent large area coverage. Please read and keep this
manual to ensure maximum performance and avoid damage through misuse.
Unpacking
Your BUBBLE- should reach you in good condition and should be supplied with IEC mains lead(s) and BOX
wired & wireless remote contr s. If there are any signs of damage or items missing from the packaging, ol
contact your dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on the housing or through the vents, disconnect the mains, allow the BUBBLE-BOX to dry
out and have it checked by qualified personnel before further use.
A id any impact, dropping or extreme pressure to the housing. vo
No user serviceable parts inside - do not open the case.
Refer all servicing to qualified service personnel.
Placement
The BUBBLE- has an open front fluid tank and should be operated in an right position. BOX up
Choose a position where the bubble output is facing the area to be filled.
Ensure easy access to the rear panel and to the bubble fluid tank for refilling and cleaning.
When moving the unit around, take care not to spill the contents of t tank inside the machine. he
Safety
• Check for correct mains voltage and condition of IEC lead before connecting to power outlet
• Check the condition of the remote lead and ensure that it is not trapped
• This unit must be earthed
Cleaning
• Use a soft dry or slightly damp cloth to clean the casing
• Do not use strong solvents for cleaning the unit
• Empty contents and rinse the bubble fluid tanks after each use
Setting up
The BUBBLE- requires bubble fluid to produce the effect. BOX
It is recommended to use qtx b ble fluid for best results (160.574UK, 160.575UK) ub
For bubbles that glow in UV light, qtx UV bubble fluid may be used (160.576UK, 160.577UK)
A chart for recommended fluids is also provided.
• Pour bubble fluid directly into the front open tank, taking care not to spill on fans beneath the tank
• Connect the supplied remote control to the female IEC on the rear panel
• Connect the IEC mains plug
www.avsl.com 5 UK Manual 160. 50
Layout
1. Bubble wand
2. Tank (pour fluid in here)
3. Carry handle
4. Front fan vent
Rear panel
5. Rear an f vents
6. ON/OFF/REMOTE Switch
7. Remote Socket
8. IEC Power Socket
9. Fluid drain tap
Operation
The BUBBLE- is operated by a 3-position rocker switch. The centre position is off. BOX
Press this switch to the left for constant bubble output.
Press this switch to the right for remote control of the bubble effect.
In this mode, bubbles are only produced when the switch on the remote control is pressed.
After use, switch off the machine and disconnect from the mains.
Drain the remaining fluid via the drain tap at the rear of the unit.
Rinse the bubble fluid tank with clean water and drain this also, then close the tap.


Product specificaties

Merk: QTX
Categorie: Effect machine
Model: Bubble-Box

Heb je hulp nodig?

Als je hulp nodig hebt met QTX Bubble-Box stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Effect machine QTX

Handleiding Effect machine

Nieuwste handleidingen voor Effect machine