QTX MBM-1 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor QTX MBM-1 (2 pagina's) in de categorie Verlichting. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
www.avsl.com 153.106UK User manual
MBM-1
Battery Powered Mirror Ball
Motor
Item ref: 153.106 UK
User Manual
Introduction
Thank you for choosing the QTX MBM-1 battery powered mirror ball motor.
This item will provide a convenient solution for small to medium tasks where no mains power is available.
Please read the below instructions to ensure proper implementation and avoid damage through misuse.
www.avsl.com 153.106UK User manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
General safety
The MBM-1 is intended for indoor use only. Keep away from damp or humid environments.
Keep the motor and housing dust free and do not allow particles to enter the mechanism.
Clean the MBM-1 periodically with a dry, lint free cloth. Do not use solvents on the casing.
Keep away from heat sources or direct sunlight.
Installation
The MBM-1 mirror ball motor is powered by a single 1.5V cell (D type) which should be installed before
installation. Open the battery compartment and connect the D cell, ensuring the correct polarity as
indicated.Positioning of the mirror ball motor is very important. Safety is the most important factor. Please
note the following to avoid failure and possible injury…
• The motor and mirror ball should be out of reach to avoid tampering
• The mirror ball should not weight more than 2kg
• The chain holding the mirror ball should be adequate for the load
• The fixing into the ceiling must be strong enough to hold both mirror ball and motor
Operation
To start the motor rotation, slide the side-mounted switch to the on position. The spindle will rotate and
so the mirror ball will rotate also. The MBM-1 is hinged to allow some sideways movement if the load is
not perfectly symmetrical. Remember to switch off when not needed to preserve the battery. If not being
used for long periods, remove the battery and store in a dry place.
Battery
1.5V (1 x D) not supplied
Max. weight load
2kg
Rotation per minute
6rpm
Dimensions
180 x 50mmØ
Weight
130g
This product is classed as Electrical or Electronic equipment and should not be disposed with other household or
commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2021 AVSL Group Ltd, Unit 2 Bridgewater Park, AVSL (Europe) Ltd, Unit 3D North Point House,
Taylor Road, Trafford Park, Manchester. M41 7JQ. North Point Bus. Park, New Mallow Road, Cork, Ireland.


Product specificaties

Merk: QTX
Categorie: Verlichting
Model: MBM-1

Heb je hulp nodig?

Als je hulp nodig hebt met QTX MBM-1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Verlichting QTX

QTX

QTX Wash & Beam Handleiding

4 September 2023
QTX

QTX TetraCube Handleiding

4 September 2023
QTX

QTX BATPAR-18W Handleiding

4 September 2023
QTX

QTX TinyMover Handleiding

4 September 2023
QTX

QTX Recharge DJ Handleiding

4 September 2023
QTX

QTX Multi-Bar Handleiding

4 September 2023
QTX

QTX SpectraWash Handleiding

4 September 2023
QTX

QTX DP4 Handleiding

20 Juni 2023
QTX

QTX MBM-1 Handleiding

18 Juni 2023

Handleiding Verlichting

Nieuwste handleidingen voor Verlichting