Pyle PMX802M Handleiding

Pyle Staafmixer PMX802M

Lees hieronder de 📖 handleiding in het Nederlandse voor Pyle PMX802M (9 pagina's) in de categorie Staafmixer. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/9

Mul-Channel Mixers

PyleUSA.com

Warnings

 Please be sure to read, keep and refer to instrucons listed in this manual.

 Do not use this device near water or expose to moisture.

 Clean only with a dry cloth.

 Do not block any venlaon openings and allow adequate space for air ow during operaon.

 Do not install near any heat sources or other devices that produce heat.

 Do not defeat the safety purpose of the polarized or grounding-type plug.

 Protect the power cord from any kind of damage or corrosion.

 Unplug the mixer when not in use or when unused for long periods of me.

 Refer all service to qualied service personnel. Servicing is required when the mixer has been damaged or performs in an unusually.

 Use only speaker cables when connecng speakers to amplier outputs. Using other types of cables is a re hazard.

 Exposure to extremely high noise levels may cause in permanent hearing loss. Individuals vary considerably to noise induced hearing loss but

take precauon when listening at high levels.

 If the power cord is damaged (i.e., cut or a bare wire is exposed), ask your dealer for a replacement. Using the unit with a damaged power cord

is a re and electrical shock hazard.

 Should this unit be dropped or the cabinet be damaged, turn the power switch o, remove the power plug from the AC outlet, and contact your

dealer. If you connue using the unit without heeding this instrucon, re or electrical shock may result.

C A U T I O N

If the unit is damaged or non-operaonal, please nofy your dealer and the shipping company immediately. Claims for

damage or replacement may not be granted if not reported properly or in a mely manner.

 Connect this unit’s power cord only to an AC outlet of the type stated in this Manual or as marked on the unit. Failure to do so may result in

re and/or electrical shock.

 Do not place heavy objects on top of the power cord. A damaged power cord is also a re and electrical shock hazard.

 Use only the included power cord for this unit, using other types may again result in re and electrical shock.

 Do not set all equalizer controls and faders to maximum levels. Doing so may cause oscillaon depending on the condion of the connected

unit and speakers, and may also damage the speakers.

 The performance of components on this mixer such switches, rotary controls, faders, and connectors, deteriorates over me. The rate as

depends on the operang environment and is somemes unavoidable. Consult your dealer about replacing defecve components.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT ATTEMPT TO OPEN OR ACCESS THE INSIDE OF

THE UNIT. REFER ALL SERVICING TO A QUALIFIED PYLE

SERVICE PERSONNEL.

This lightning ash symbol is intended to alert the user to the presence of uninsulated and “dangerous

voltage” within the mixer's enclosure that may be of sucient power to constute a risk of electric shock.

This exclamaon point symbol is intended to alert the user to the presence of important operang

and maintaining instrucons, that one should pay aenon to and keep for future reference.

Mul-Channel Mixers

PyleUSA.com

Installaon

Install the mixer on an even surface to allow for sucient airow and venlaon during use. The device is equipped with

electronically controlled cooling fans to protect against thermal overload and internal circuitry from damage due to

extreme heat. Please avoid covering any sides of the unit or placing objects or other audio devices too close to your mixer.

Prior to connecng and powering on the unit, make sure that the device matches the voltage and frequency of your

power supply. Power o the mixer when not in use.

Cables and Connecons

RCA

1/4'' TRS and Mono

XLR 3-Pin

RCA connector jacks have been most

commonly used in home audio systems

and conguraons for years. Also known

as RCA 'phono', 'plugs' or 'audio

connectors' , these jacks are always

unbalanced, and generally carry a line-

level signal at 10 dB, nominal signa–l

levels. The RCA connector jacks are most

likely used when connecng an audio

device like a media player or other home

audio type source to your mixer. These

connector jacks are also used when

connecng to the output of your devices.

1/4'' mono and stereo connector jacks are

labeled for use as unbalanced mono,

unbalanced stereo, balanced mono, or as

an insert patch point. A 1/4'' TRS (Tip,

Ring, Sleeve), 3-conductor connecon, or

'Stereo' cable allows a single connecon

signal to carry 2-channels of audio; also

can be used for mono balanced signals.

While, a 1/4'' TS (Tip, Sleeve), 2-conductor,

or 'Mono' cable are most popularly known

for their use in guitar or line-level

instrument connecon; they can also be

used for mono unbalanced signals.

XLR connector jacks, almost always carries

a balanced signal. Depending on your

device, these connector jacks may also be

capable of handling unbalanced signals.

Microphones generally have this type of

connector, as well as most other

professional audio equipment and devices.

Typical 3-Pin XLR sockets are xed with the

right-most pin being the 'ground', the le-

most pin being 'hot' and the boom pin

as the 'neutral'.

Technical Specicaons

Mono Inputs

Microphone Inputs (XENYX Mic Preamp)

XLR, electronically balanced, discrete input circuit

Mic E.I.N. (20Hz - 20kHz)

@ 0 Ohm Source Resistance

@50 Ohm Source Resistance

@150 Ohm Source Resistance

-134dB / 135.7dB A-Weighted

-131dB / 133.3dB A-Weighted

-129dB / 130.7dB A-Weighted

Frequency Response

<10Hz - 150kHz (-1dB)

<10Hz - 200kHz (-3dB)

Gain Range

+10dB to +60dB

Maximum Input Level

+12dB @ +10dB Gain

Impedance

Approximately 2.6k Ohm, Balanced

Signal- -Noise to

110dB / 112dB A-Weighted

Distoron (THD +N)

0.005% / 0.004%, A-Weighted

Line Input

1/4'' TRS Connectors, Electronically Balanced

Channel Equalizaon

(Frequency Hz)

Control Range High: @ 10k +/-15dB

Control Range Low: k +/-15dB @60

Master 5-Band Graphic EQ

Frequency: Hz (60, 250, 1K, 4K, 12K)

Control Ranges: +/-12dB

Product specificaties

Merk:	Pyle
Categorie:	Staafmixer
Model:	PMX802M

Heb je hulp nodig?

Als je hulp nodig hebt met Pyle PMX802M stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Staafmixer Pyle

Pyle PMAX4 Handleiding

9 Juli 2023

Pyle PMAX6 Handleiding

7 Juli 2023

Pyle PMAX8 Handleiding

1 Juli 2023

Pyle PMIDIPD20 Handleiding

17 Mei 2023

Pyle PMIDIPD30 Handleiding

21 April 2023

Pyle PKSCRD308 Handleiding

20 April 2023

Pyle PDJLT88 Handleiding

23 Maart 2023

Pyle PMX6BU Handleiding

21 Maart 2023

Pyle PMX802M Handleiding

12 Maart 2023

Pyle UPYD1964B Handleiding

5 Maart 2023

Handleiding Staafmixer

Nieuwste handleidingen voor Staafmixer

Bosch MultiTalent 3 MCM3301BGB Handleiding

22 November 2024

Bosch ErgoMixx MSM6611DGB Handleiding

22 November 2024

Bosch ErgoMixx MSM66135GB Handleiding

22 November 2024

Electroline ELNEXTSTANDMIX389G Handleiding

18 November 2024

Princess 221229 Handleiding

16 November 2024

Zelmer ZHB4640 Handleiding

14 November 2024

Sunbeam Zumbo SM9600 Handleiding

13 November 2024

Morphy Richards MRHBS8BK Handleiding

13 November 2024

KitchenAid KHMB732 Handleiding

11 November 2024

KitchenAid KHM7210 Handleiding

11 November 2024