Projecta HDBT252 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Projecta HDBT252 (8 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
P/No. HDBT252
Tray Fitting Instructions to suit Auxiliary battery for
Mazda BT50 B3000 Automatic/Ford Ranger PJ–PK Automatic
Years: Jan 2007 – Oct 2011
Models: WLT – 2.5 Litre Turbo Diesel & 3.0 Litre Diesel
HEAVY DUTY DUAL BATTERY TRAY
2
IMPORTANT SAFETY INFORMATION
Please read this instruction thoroughly before fitting the tray.
This product is recommend to be fitted by a workshop or qualified mechanical person.
WARNINGS
• Before installation, make sure that the vehicle is stationary and the wheels chocked.
• Be careful when laying wires, not to cause any electrical shorts or wire breakage.
• After installation ensure the bonnet can close without hitting the newly installed battery
and battery tray.
SPECIFICATIONS
Max Battery Size (mm) L265 x W174 x H220
Max Battery Weight 18Kg
Recommended batteries Exide LCS 24-86, Exide ORBITAL ORB34DC & Century NS70T
Approximate fitting time 1.5 hours
Special tools None required
Recommended Dual IDC25, DBC100, DBC150, VSR100 or VSR200
Battery System
Tray Location Engine Bay, Passenger Side near radiator support
KIT INCLUDES
Hardware
2 x M6 Bolt Countersunk
5 x M6 Nut
5 x M6 Bolts Hex
1 X M8 Bolt
5 x 150mm Cable tie
Special
Top Mount
Tray
J Bolts
Computer Mount
1. Make sure that the vehicle is stationary, the engine is switched off and cool.
Disconnect the negative battery terminals from the main battery.
2. Your Auxiliary tray will be located between the passenger side headlight and air
cleaner. Remove the rear M8 bolt with large flange located on inner guard where
you will locate tray, in between the headlight and air cleaner and retain.
3. Move wiring loom from the same position.
4. Remove Computer mounting bracket from inner guard.
5. Remove wiring and relay from bracket.
6. Remove computer from bracket by removing 2 x M6 nuts and removing hold
down bracket.
7. Bolt computer to new computer mount, using top clamp.
8. Bolt computer mount to side of tray using 2 x M6 bolts Countersunk and
M6 Whizlocks.
3
FITTING INSTRUCTIONS


Product specificaties

Merk: Projecta
Categorie: Niet gecategoriseerd
Model: HDBT252

Heb je hulp nodig?

Als je hulp nodig hebt met Projecta HDBT252 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Projecta

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd