Proaim P-G-PM Handleiding

Proaim Statief P-G-PM

Lees hieronder de 📖 handleiding in het Nederlandse voor Proaim P-G-PM (7 pagina's) in de categorie Statief. Deze handleiding was nuttig voor 4 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/7
Please inspect the contents of your shipped package to ensure you have received everything that is listed
below.
Power Sucon Mount Camera Gripper (P G )- -PM
A s s e m bl y M a n u a l
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any means,
electronic, mechanical, photo copying, recording, or otherwise, except as may be expressly permied by the applicable copyright -
statutes or in wring by the Publisher.
What s In The Box
2 x Sucon Cups
2 x Ropes
2 x Ropes Hooks
Camera Mounng
Plaorm
3 x Bowl Head
100mm Bowl
Adapter
3 x Sucon Cups with Cap
9 x Aluminum Rods
(Size: 30cm,15cm,7.5cm)
2 x Camera Mounng Bolts
(Size: 2 x 1/4” & 3/8”)
1 x L Type -
Allen Key (Size:4mm)
2
Camera Mount Gripper Setup
Remove the cap from the Sucon Cup, and
you will see thread located in the center, 1/4”
as shown in the image.
Remove the dust cover and posion the
sucon cup wherever required.
Screw in the Ball Tilt Head on sucon cups.
Adjustable Ball Tilt Heads allow for an
extensive range of lockable posions for
Aluminum Rods.
Pull and then remove the cap of the
aluminum rod (30cm).
Similarly, mount all the Ball Tilt heads onto
the sucon cups.
Press down the sucon cup and keep pushing
the pump to rmly x it on the surface.
Repeat this process for all the sucon cups.
Cauon: Recheck the Pump every 90 minutes.
If the red line is visible, Re pump the cup -
without losing the remaining vacuum ll the
Red Line disappears.
3 x Dierent Assembly Aluminum Rods
3
Screw the other end of the aluminum rod
(30cm) onto the Ball Tilt head, and then
ghten it.
First loosen the knob, then set the posion of
the Aluminum rods and nally secure them by
ghtening the knobs.
Screw the rods into the camera mounng
plaorm and ghten them.
Firstly, remove the dust cover and place your
sucon cup on the selected place and press
down to x the pump rmly on the surface.
Remove the cap of the aluminum rod (15cm),
then screw and ghten it properly onto the
Ball Tilt head. Repeat the same process for
aaching the other aluminum rods.
NOTE: Three rods are provided for each length
(30cm,15cm,7.5cm). These rods can be linked
together in any combinaon you need to create
the perfect setup.


Product specificaties

Merk: Proaim
Categorie: Statief
Model: P-G-PM

Heb je hulp nodig?

Als je hulp nodig hebt met Proaim P-G-PM stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Statief Proaim

Handleiding Statief

Nieuwste handleidingen voor Statief