Privileg RSIC 3M19 Handleiding

Privileg Vaatwasser RSIC 3M19

Lees hieronder de 📖 handleiding in het Nederlandse voor Privileg RSIC 3M19 (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 58 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/8
EN
1
Before using the appliance carefully read Health and Safety guide.
APPLIANCE
PRODUCT DESCRIPTION
You can download the Safety Instructions and the Use and Care Guide, by visiting our website
docs.whirlpool.eu and following the Instructions on the back of this booklet.
1. Upper rack
2. Foldable  aps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
0000 000 00000
Service:
1
2
3
4
5
6
7
9
8
1011
12
1 2 3 4 5 6 7 8 9 10 11
1. On-O /Reset button with indicator light
2. Program selection button
3. Salt re ll indicator light
4. Rinse Aid re ll indicator light
5. Program number and delay time indicator
6. Tablet indicator light
7. Display
8. Half Load indicator light
9. Half Load button
10. Delay button
11. Start/Pause button with indicator light/ Tab
DAILY REFERENCE
GUIDE
CONTROL PANEL
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the reta-
ining elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
• It is important that the salt reservoir be never empty.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see Product Description) and should be  lled when the SALT REFILL
indicator light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the  rst time you do this:  ll the salt re-
servoir with water.
3. Position the funnel (see  gure) and  ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, we recommend carrying out the
procedure before the washing cycle is started.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for average (3) water hardness.
• Switch on the appliance by pressing the button.ON/OFF
• Switch o the appliance by pressing the button.ON/OFF
• Hold down button P for 5 seconds, until you hear a beep.
• Switch on the appliance by pressing the button.ON/OFF
• The current selection level number and the salt indicator light both  ash.
• Press button P to select the desired hardness level (see WATER
HARDNESS TABLE).
• Switch o the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been speci cally designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches o .
If the salt container is not  lled, the water softener and the
heating element may be damaged as a result.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4 Hard 17 - 34 31 - 60
5 Very hard 35 - 50 61 - 90
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser A should
be  lled when the RINSE AID REFILL indicator light in the control
panel is lit.
1. Open the dispenser B by pressing and pulling up the tab on the lid.
2. Pour in the rinse aid (max.110 ml), making sure it does not over ow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satis ed with the drying results, you can ad-
just the quantity of rinse aid used.
• Switch the dishwasher on using the ON/OFF button.
• Switch it o using the button.ON/OFF
• Press button P three times - a beep will be heard.
• Switch it on using the button.ON/OFF
• The current selection level number and rinse aid indicator light  ash.
• Press button P to select the level of rinse aid quantity to be supplied.
• Switch it o using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied.
The LOW RINSE AID indicator light will not be lit if you run out of rinse
aid.
A maximum of 4 levels can be set according to the dishwasher model.
The factory setting is speci c to the model, please follow instruction
above to check this for your machine.
• If you see bluish streaks on the dishes, set a low number (1-2).
• If there are drops of water or limescale marks on the dishes, set a
mid-range number (3-4).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device A.
Introduce the detergent into the dry dispenser B only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are B
indications to help the detergent
dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
A
B
A
B
EN
3
Program
Drying
phase
Available
options *)
Detergent
container Duration
of wash
program
(h:min)**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
Tub B
1Eco 50° 4:00 11.5 0.83
2Intensive 65° -2:30 15.0 1.50
3Normal 55° - 2:30 15.0 1.30
4Daily 50° - 1:20 11.5 1.10
5Delicate
45°
-1:40 11.5 1.00
6Rapid 30’ 50° - - 0:30 8.5 0.50
7Pre Wash -- - - 0:10 4.5 0.01
PROGRAMS TABLE
ECO program data is measured under laboratory conditions according to European Standard EN 50242.
Note for Test Laboratories: For information on comparative EN testing conditions, please send an email to the following address:
dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary
depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,
load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - O mode consumption: 0.5 W
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
1 ECO
Normally soiled crockery. Standard program, the most e cient in
terms of its combined energy and water consumption.
2 INTENSIVE
Program recommended for heavily soiled crockery, especially suitable
for pans and saucepans (not to be used for delicate items).
3 NORMAL
Mixed soil. For normally soiled dishes with dried food residues.
4 DAILY
Normally soiled crockery. Everyday cycle, that ensures optimal cleaning
and drying performance in shorter time.
5 DELICATE
Program for delicate items, which are more sensitive to high tempera-
tures, for example glasses and cups.
6 RAPID 30’
Program to be used for lightly-soiled dishes with no dried food
residues.
7 PRE WASH
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
Notes:
Please note that cycles like Rapid or Fast are most e ective for lightly soiled
dishes.
To reduce consumption even further, only run the dishwasher
when it is full.

Product specificaties

Merk: Privileg
Categorie: Vaatwasser
Model: RSIC 3M19

Heb je hulp nodig?

Als je hulp nodig hebt met Privileg RSIC 3M19 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Vaatwasser Privileg

Privileg

Privileg RSBC 3B19 X Handleiding

17 November 2024
Privileg

Privileg RUO 3C23 A 6.5 X Handleiding

26 Juni 2023
Privileg

Privileg RSIC 3M19 Handleiding

21 Juni 2023
Privileg

Privileg RUC 2C24 A X Handleiding

20 Juni 2023
Privileg

Privileg RSFO 3T224 Handleiding

20 Juni 2023
Privileg

Privileg RIO 3T131 A FE X Handleiding

19 Juni 2023
Privileg

Privileg RCIE 2B19 A Handleiding

19 Juni 2023
Privileg

Privileg RSBO 3T224 X Handleiding

18 Juni 2023
Privileg

Privileg PDSI 5081/1 A Handleiding

15 Juni 2023
Privileg

Privileg RFO 3T133 A F Handleiding

14 Juni 2023

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser

Sammic

Sammic SAM-3001 Handleiding

17 November 2024
Gaggenau

Gaggenau DA045060 Handleiding

16 November 2024
Gaggenau

Gaggenau DA045061 Handleiding

16 November 2024
Gorenje

Gorenje GV68260 Handleiding

16 November 2024
Kuppersbusch

Kuppersbusch IGV 449.3 Handleiding

16 November 2024
Kuppersbusch

Kuppersbusch IGV 645.0 Handleiding

16 November 2024
Whirlpool

Whirlpool WSUO 3O23 PF Handleiding

15 November 2024
Omega

Omega OFI604 Handleiding

15 November 2024
Asko

Asko DBI 644 MIB.S Handleiding

15 November 2024
Asko

Asko DFS233IB.S.TW/1 Handleiding

15 November 2024