Polk DB1212 Handleiding

Polk Subwoofer DB1212

Lees hieronder de 📖 handleiding in het Nederlandse voor Polk DB1212 (15 pagina's) in de categorie Subwoofer. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/15
2d b : I n c r e d i b l e S o u n d , A f f o r d a b l e P r i c e
ENGLISH
AMPLIFIER HOOKUP
NOTE: USE WITH 2 OHM COMPATIBLE AMPLIFIERS.
NOT ALL AMPLIFIERS ARE STABLE INTO A 2 OHM LOAD
(ESPECIALLY IN BRIDGED MODE). PLEASE CONSULT
YOUR AMPLIFIER’S OWNER’S MANUAL.
GETTING STARTED
Please inspect your loudspeaker(s) carefully. Notify your
Polk Audio dealer if you notice any damage or missing items.
Keep the carton and packing material; this will do the best
job of protecting your speaker(s) if they must be transported.
SAFE LIMITS OF OPERATION
Polk Audio specifies the recommended amplification range
for each of its passive (non-amplified) loudspeakers. Typically
that specification will be expressed as a range of power such
as 20-200 W (per channel). It is important to understand
what those numbers mean when choosing a receiver or
amplifier for your Polk loudspeakers. The lower number
indicates the lowest continuous rated power that will yield
acceptable performance in a typical listening environment.
The higher number indicates the highest per channel power
that should be used with your Polk speakers. That number
should not be confused with a “Power Handling” specification
and it does not imply that the speaker will safely handle
that full amount of power on a long-term basis. We specify
a wide range of power ratings because not all electronics
manufacturers use the same method for rating power.
In fact, high quality lower-rated amplifiers sound better and
play louder than low quality units with a higher power rating.
Automobile horsepower is a good analogy. Your car probably
has far more horsepower than it needs for your daily commute
and is likely capable of going well over 120mph (190km/hr).
Having that extra power is good for on-ramp acceleration
and danger avoidance (like getting away from brain-eating
zombies) but that doesn’t mean that it is advisable to operate
your car on North American highways at full power and
maximum speed for an extended period of time. Just ask
your local state trooper if you are in doubt. Similarly, we
recommend using amplifiers and receivers with rated power
above the Power Handling limits of our speakers because
having extra power available for short term peaks is conducive
to better sound quality, maximum dynamic range and effortless
high volume output. But we strongly urge you not to use the
full power of your amplifier or receiver for daily listening.
Loudspeakers can be damaged when an amplifier, regardless
of its wattage, is made to play at higher listening levels than its
power can clearly produce. Operation at this level can result in
very high levels of audible distortion originating in the
amplifier, which can add a harsh, gritty sound to your listening
material. If you hear distortion—turn the volume down
or risk damaging your speakers. You can damage just
about any speaker, regardless of power rating, if you drive an
amplifier to or beyond the point of distortion.
TECHNICAL ASSISTANCE OR SERVICE
If, after following the hookup directions, you experience
difficulty, please double check all wire connections. Should
you isolate the problem to the speaker, contact the authorized
Polk Audio dealer where you made your purchase, or contact
Polk Audio Customer Service. Polk Audio’s Customer Service
Department is available from 9am–6pm, EST, Monday through
Friday, at 800-377-7655 (US & Canada only, outside the US call
410-358-3600) or via email at polkcs@polkaudio.com. Please
do not hesitate to contact us if you have questions about your
speaker system.
More detailed information—including audio how-to articles,
FAQs, and online manuals—is available on our award
winning website at www.polkaudio.com/car/faqad and
www.polkaudio.com/car/library/manuals.
3
M o r e I n f o @ w w w . p o l k a u d i o . c o m / c a r
SPECIFICATIONS
db1212
Type subwoofer enclosure/slot ported
Frequency Response 26 Hz - 200 Hz
Driver Complement 1 - 12" subwoofer
Nominal Impedance 2 Ohms
Power Handling (RMS) 360 Watts
Recommended Amplification Range 50 - 500 Watts
Power Handling (Peak) 720 Watts
Efficiency 97 dB
Dimensions Bottom Depth - 18 11/16" (47.47 cm)
Top Depth - 15 11/16" (39.85 cm)
Height - 14 3/4" (37.47 cm)
Width - 17 1/4" (43.82 cm)
db1222
Type subwoofer enclosure/slot ported
Frequency Response 27 Hz - 200 Hz
Driver Complement 2 - 12" subwoofers
Nominal Impedance 2 Ohms
Power Handling (RMS) 720 Watts
Recommended Amplification Range 50 - 1000 Watts
Power Handling (Peak) 1440 Watts
Efficiency 103 dB
Dimensions Bottom Depth - 18 1/2" (46.99 cm)
Top Depth - 15 1/2" (39.37 cm)
Height - 14 3/4" (37.47 cm)
Width - 32 1/2" (82.55 cm)
WARNING: LISTEN CAREFULLY
Polk Audio loudspeakers and subwoofers are capable of playing at extremely high volume levels,
which could cause serious or permanent hearing damage. Polk Audio, Inc. accepts no liability
for hearing loss, bodily injury or property damage resulting from the misuse of its products.
Keep these guidelines in mind and always use your own good judgment when controlling volume:
• You should limit prolonged exposure to volumes that exceed 85 decibels(dB).
• High volume in an automobile can hinder your ability to safely operate a vehicle.
• You are responsible for knowing the local laws governing acceptable mobile volume levels.
For more about safe volume levels, go to: www.polkaudio.com/education/article/SPL/
Or refer to the Occupational Health and Safety Administration (OSHA) guidelines at:
www.osha.gov/dts/osta/otm/noise/standards_more.html
Product Disposal—Certain international, national and/or local laws and/or
regulations may apply regarding the disposal of this product. For further detailed
information, please contact the retailer where you purchased this product or the
Polk Audio Importer/Distributor in your country. A listing of Polk Audio Importer/
Distributors can be found on the Polk Audio website www.polkaudio.com or by
contacting Polk Audio at 5601 Metro Drive, Baltimore, Maryland 21215, USA—
Phone: +1 410 358-3600.

Product specificaties

Merk: Polk
Categorie: Subwoofer
Model: DB1212

Heb je hulp nodig?

Als je hulp nodig hebt met Polk DB1212 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Subwoofer Polk

Polk

Polk Signature Elite ES8 Handleiding

12 November 2024
Polk

Polk Signature Elite ES12 Handleiding

12 November 2024
Polk

Polk PSW125 Handleiding

29 Mei 2023
Polk

Polk DB1040DVC Handleiding

12 Mei 2023
Polk

Polk DB1240DVC Handleiding

11 Mei 2023
Polk

Polk MM 1242 DVC Handleiding

8 Mei 2023
Polk

Polk Monitor XT12 Handleiding

6 Mei 2023
Polk

Polk Monitor XT10 Handleiding

3 Mei 2023
Polk

Polk PSW505 Handleiding

1 Mei 2023
Polk

Polk AM3386A Handleiding

26 April 2023

Handleiding Subwoofer

Nieuwste handleidingen voor Subwoofer

Deaf Bonce

Deaf Bonce Apocalypse ASA-4000.1 Handleiding

20 November 2024
Deaf Bonce

Deaf Bonce Apocalypse Atom 2000 PRO Handleiding

20 November 2024
JBL

JBL PSW-D115 Handleiding

20 November 2024
JBL

JBL PSW-D110 Handleiding

20 November 2024
JBL

JBL PSW-D112 Handleiding

20 November 2024
JBL

JBL Power P1224 Handleiding

20 November 2024
JBL

JBL Power P1220D II Handleiding

20 November 2024
JBL

JBL Power P1242 Handleiding

20 November 2024
JBL

JBL Power P1220 II Handleiding

20 November 2024
JBL

JBL Power P1020 II Handleiding

20 November 2024