Peak PKC0J6 Handleiding

Peak Acculader PKC0J6

Lees hieronder de 📖 handleiding in het Nederlandse voor Peak PKC0J6 (7 pagina's) in de categorie Acculader. Deze handleiding was nuttig voor 31 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/7

600 Peak Amp

Jump-Starter

Model No.: PKC0J6

Owner’s Manual

and Warranty Information

Read these instructions completely before using this product.

Retain this Owner’s Manual for future reference.

 Do not expose battery to ﬁ re or intense heat since it can explode.

 Before recycling or disposing of a battery, protect exposed terminals with heavy-duty electrical tape

to prevent shorting (shorting can result in personal injury or ﬁ re).

 Always wear protective eyewear when using this product. Contact with battery acid can cause

blindness and/or severe chemical burns.

 Follow these ﬁ rst aid procedures in case of accidental contact with battery acid.

FIRST AID

SKIN: Wash skin thoroughly if battery acid comes in contact with skin. Seek medical attention

immediately.

EYES: Flush eyes with cool water for at least ten minutes. Seek medical attention immediately.

CONTACT POISON CONTROL CENTER IMMEDIATELY IF INGESTED.

 Never touch battery clamps together or to a common piece of metal. Sparking, explosion or

damage to the unit can result. Always store the battery clamps on the appropriate case clamp posts

on the back of the unit after use.

 Place this unit as far away from the battery being charged as the charging cables will permit.

 When using the Jump-Starter close to the vehicle’s battery and engine, place the unit on a ﬂ at,

stable surface, and keep all clamps, cords, clothing and body parts away from moving parts of the

vehicle.

 Follow these instructions and those published by the battery manufacturer and manufacturer of

any equipment you intend to use near the battery. Pay attention to all hazard precautions on these

products and on the engine before charging.

 This system is designed to be used only on vehicles with a 12-volt DC battery system. Do not

connect to a 6-volt or 24-volt battery system.

 Remove all jewelry or metal objects that could cause short circuits or react with battery acid. A lead-

acid battery produces a short-circuit current high enough to weld a ring or other similar objects to

metal, causing a severe burn.

 When w orking on electrical equipment, always ensure someone is nearby to help you in an

emergency.

 Keep a supply of baking soda on hand when working on batteries. Baking soda neutralizes lead-

acid battery electrolyte.

All messages that follow have NOTICE level hazards. Failure to comply could

result in property damage.

 Vehicles that have on-board computerized systems may be damaged if vehicle battery is jump-

started. Before jump-starting, read the vehicle’s owner’s manual to con ﬁ rm that external-starting

assistance is suitable.

 Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start after

the recommended number of attempts, discontinue these jump-start procedures and look for other

problems that may need to be corrected.

 This Jump-Star ter is not designed to be used as a replacement for a vehicle’s battery. Do not

attempt to operate a vehicle that does not have a battery installed.

 After connecting the batter y charging clamps to the discharged battery and before turning on the

jump-starter ON/OFF switch, check the power/polarity indicator light on the front of the unit. If the

light is GREEN, the clamp connections are correct. If the light is RED and an alarm sounds, the

clamp connections are incorrect and need to be reversed.

 This Jump-Starter is delivered in a partially charged state. Fully charge unit with the supplied

110/120-volt AC charger to the recommended maximum and initial charge time of 24 hours.

Thereafter, an AC typical charge time is 8 to 12 hours when using the AC charger.

 Although this unit contains a sealed batter y, it is recommended that unit be kept upright during

storage, use and recharging. To avoid possible damage that may shorten the unit’s working life,

protect it from direct sunlight, direct heat and/or moisture.

 Never allow battery acid to come in contact with this unit.

 All ON/OFF switches should be in the OFF position when charging the Jump-Starter or when not in

use. Make sure all switches are in the OFF position before connecting to a power source or load.

 Do not use any accessory that is not recommended or provided by the manufacturer.

INTRODUCTION

This Jump-Starter has been carefully engineered and manufactured to give you dependable operation.

Please read this manual thoroughly before operating your new Jump-Starter, as it contains the

information you need to become familiar with its features and obtain the performance that will bring you

continued enjoyment for many years. Please keep this manual on ﬁ le for future reference.

FEATURES

 Built-in 600 peak amps batter y jump-starter with quick storing cables and clamps

 Built-in 12-volt DC power socket for powering DC appliances

 Built-in USB power outlet

 Batter y indicator display (indicates % of charge)

 Reverse polarity connection LED indicator with sound alarm

 Includes sealed, maintenance-fr ee, heavy-duty, lead-acid battery

 Requires no maintenance (other than recharging) for optimal operation

 110/120-volt AC charging plug

 Safe to use, transport and store

 Molded high-impact case is tough and durable

 Low Charge Alert (LCA)™

234

Legend

1. Jump-Starter/USB Port ON/OFF

Switch

2. Jump-Starter/USB Port ON LED

3. Battery Indicator Display

4. Display Button

5. 12-volt DC Power Socket

6. USB Port

7. Low Charge Alert (LCA) Port

8. Reverse Polarity Indicator LED

9. Low Charge Alert (LCA) Storage

Port

10. 110/120-volt AC Charging Plug

11. Red Positive (+) Jumper Cable

12. Black Negative (-) Jumper Cable

Low Charge Alert and LCA are trademarks of Old World Industries, LLC. Used with permission. All rights

reserved.

Product specificaties

Merk:	Peak
Categorie:	Acculader
Model:	PKC0J6

Heb je hulp nodig?

Als je hulp nodig hebt met Peak PKC0J6 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Acculader Peak

Peak PKC0J6 Handleiding

7 Juni 2023

Peak PKC0AZ Handleiding

12 Mei 2023

Handleiding Acculader

Nieuwste handleidingen voor Acculader

Growatt THOR 20DS-P Handleiding

15 December 2024

Silverline 634004 Handleiding

5 December 2024

Einhell BT-PS 800 Handleiding

4 December 2024

Einhell BT-PS 1000/1 Handleiding

4 December 2024

Einhell BT-PS 700 Handleiding

4 December 2024

Einhell BT-PS 1000 Handleiding

4 December 2024

HyperX ChargePlay Quad Handleiding

30 November 2024

Xtorm XW402 Handleiding

30 November 2024

SKROSS MUV USB (AC) Handleiding

26 November 2024

SKROSS PRO Light - World Handleiding

26 November 2024