Panduit FPONE1 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Panduit FPONE1 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2020 FS160
Page 1 of 2
Fiber PON Enclosure
Part Number(s): FPONE1
SPECIFICATIONS:
Material: PC +ABS, water resistant, dust-proof, IP55
Dimension (HxWxD): 233 x 200 x 63 mm
Color: Light Gray
Adapter Type: SC
Number of Adapters: Max 12
Number of Splitters: Max 1 (N x 2, N x 4, and N x 8,)
Wall Mount
Bottom
Front
Back
Product Structure and Cable Entry
Drop Cable
OSP Cable
Adapter Storage
Fiber
Management
Lid
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2020 FS160
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp www.panduit.com
Page 2 of 2
Attachment of Outside
Plant Cable
Drop Cable
Drop Cable
Grounding Terminal
Enclosure Installation and drop cable attachment
1. FInd the mounting screws included in the product packaging.
2. Drill (4) holes in the wall based on the drill template and place an expansion bolt in each hole, align the enclosure to holes
and use the bolt to fasten the enclosure to the wall.
3. Route the drop cables through the attachment hardware on the bottom right hand side of the base. Then route the drop
cables around the base of the enclosure so that they enter onto the front of the flip tray.
4. Attach the connectorized end into the adapters so that they enter onto the front of the flip tray.
Pigtail Installation
Pigtails with connectors one end should have the connectorized end attached to the adapter located in the adapter storage.
The pigtail fiber ends will need to be routed from the front of the flip tray to the rear of the flip tray and prepared for splicing.
Splitter Installation
5. Splitters are available connectorized or with bare fibers. If the splitter is connectorized, then attach the connectors to the
adapter located in the adapter storage. from the breakout side first, one at a time.
6. Then attach the splitter to the rear of the flip tray.
The Outside Plant Cable Installation
7. The outside plant cable is routed into the bottom left hand corner of the base and attached inside the bracket at the base
of the enclosure.
8. The cable is to be prepped with 38 inches of exposed unit tube that is routed in the base of the enclosure and routed to
the rear of the flip tray.
9. The unit tube that will be spliced is to be prepped by stripping to expose 18 inches of the fiber that will be spliced to the
pigtail.
10. Once the fusion splice is completed cover with the splice sleeve. It should be installed on the rear of the flip tray in the
splice storage, and then the fiber slack is routed counter clockwise and the unit tube is routed clockwise on the rear of the
flip tray.


Product specificaties

Merk: Panduit
Categorie: Niet gecategoriseerd
Model: FPONE1

Heb je hulp nodig?

Als je hulp nodig hebt met Panduit FPONE1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Panduit

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd