Onkyo SKR-L500 Handleiding

Onkyo Speaker SKR-L500

Lees hieronder de 📖 handleiding in het Nederlandse voor Onkyo SKR-L500 (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 49 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/4
E
n
Speaker System
SKR-L500
Instruction Manual
Thank you for purchasing an Onkyo speaker system.
Please read this manual thoroughly before using your
new speakers. Following the instructions in this
manual will enable you to obtain optimum
performance and listening enjoyment from your
speaker system.
Please retain this manual for future reference.
Contents
Getting Started
Package Contents ........................... 2
Placement ........................................ 2
Installing & Using
Using Cork Spacers with the
Speaker......................................... 2
Wall Mounting.................................. 2
Connecting the Speakers............... 3
Using Speaker Mounts/Brackets ... 3
Appendix
Operating Precautions ................... 3
Speaker care.................................... 4
Specifications.................................. 4
SKR-L500.fm Page 1 Tuesday, October 4, 2005 2:15 PM
2
• SKR-L500: Surround back speaker
• Speaker cable, 9 m (brown)
• Cork spacers, 4 pcs.
SKR-L500: Surround back speaker
This speaker enhances the realism of surround sound
and improve sound localization behind the listener.
Position it behind the listener about 2–3 feet (60–
100 cm) above ear level.
• The speaker cabinet is sensitive to extreme tempera-
tures and humidity, do not put it in locations subject
to direct sunlight or in humid places, such as near an
air conditioner, humidifier, bathroom, or kitchen.
• Do not put water or other liquids close to the speaker.
If liquid is spilled over the speaker, the drive units
may be damaged.
• As explained in this manual, mount the speaker on a
wall, or on the optional stands/brackets, otherwise, it
may fall, causing personal injury or damage to the
speaker.
We recommend using the supplied cork spacers to
achieve the best possible sound from your speaker. The
cork spacers prevent the speaker from moving, provid-
ing a more stable setup.
The speaker can easily be wall mounted by using the
keyhole slots. To prevent the speaker from vibrating
against the wall, attach four of the supplied cork spacers
to the rear of the speaker.
■
Mounting vertically
To mount the speaker vertically, use the two keyhole
slots shown to hang the speaker on two screws that are
securely screwed into the wall.
■
Mounting horizontally
To mount the speaker horizontally, use the two keyhole
slots shown to hang the speaker on two screws that are
securely screwed into the wall.
The plaque of each speaker rotates so that you can posi-
tion the speaker upside down.
Caution:
A mounting screw’s ability to support a speaker
depends on how well it’s anchored to the wall. If you
have hollow walls, screw each mounting screw into a
stud. If there are no studs, or the walls are solid, use
suitable wall anchors.
Use screws with a head diameter of 9.5 mm or less and a
shank diameter of 4 mm or less. With hollow walls, use
a cable/pipe detector to check for any power cables or
water pipes before making any holes.
Leave a gap of 5 mm
between the wall and the
base of the screw head, as
shown.
(We recommend that you
consult a home installation
professional.)
Package Contents
Placement
Using Cork Spacers with the Speaker
SKR-L500
SKR-L500
Cork spacers
Bottom of the
SKR-L500
Wall Mounting
Cork spacer
Keyhole slot for
wall mounting
Keyhole slot for wall
mounting
Cork spacers
Wall
5 mm
SKR-L500.fm Page 2 Tuesday, October 4, 2005 2:15 PM
3
Read the following before connecting your speakers:
• Turn off your amp before making any connections.
• The nominal impedance of these speakers is 6
Ω
. Use
only an amp that supports this impedance.
• Pay close attention to speaker wiring polarity. Con-
nect positive (+) terminals to only positive (+) termi-
nals, and negative (–) terminals to only negative (–)
terminals. If the speakers are wired incorrectly, the
sound will be out of phase and will sound unnatural.
• Be careful not to short the
positive and negative wires.
Doing so may damage your
amp.
■
Connecting the Speaker Cables
Threaded inserts for 5 mm machine screws are provided
on the rear and buttom of the speaker for wall-mounting
with commercially available speaker mounts and brack-
ets. Refer to the manual supplied with your mounts or
brackets for installation details.
Note:
The portion of the screw that goes into the speaker’s
threaded insert should be between 5 mm and 9 mm
long.
The speaker can handle the specified input power when
used for normal music reproduction. If any of the fol-
lowing signals are fed to them, even if the input power
is within the specified rating, excessive current may
flow in the speaker coils, causing burning or wire break-
age:
1.
Interstation noise from an untuned FM radio.
2.
Sound from fast-forwarding a cassette tape.
3.
High-pitched sounds generated by an oscillator, elec-
tronic musical instrument, and so on.
4.
Amplifier oscillation.
5.
Special test tones from audio test CDs and so on.
6.
Thumps and clicks caused by connecting or discon-
necting audio cables (Always turn off your amplifier
before connecting or disconnecting cables.)
7.
Microphone feedback.
• The speaker contain strong magnets, so do not put
magnetic or iron objects such as screwdrivers close to
them. If you do, the object may be attached to the
magnets, causing personal injury or damage to the
diaphragm.
Connecting the Speakers
1
Strip the insulation from the
ends of the speaker cables,
and twist the bare wires tightly.
2
Use the cables to connect speaker’s input
terminals to the corresponding speaker
output terminals on your amp.
To make a connection, while
pressing the terminal lever,
insert the wire into the hole, and
then release the lever.
Make sure that the terminals are
gripping the bare wires, not the insulation.
FRONT
SPEAKERS
CENTER
SPEAKER
SURROUND
SPEAKERS
R
L
SURROUND BACK SPEAKERS
SKF-L500
Front right
speaker
SKF-L500
Front left
speaker
SKC-L500C
Center speaker
SKR-L500
Surround back
speaker (right)
SKR-L500
Surround back
speaker (left)
Brown
Brown
SKM-L500S
Surround right
speaker
SKM-L500S
Surround left
speaker
Using Speaker Mounts/Brackets
Operating Precautions
5 mm
5–9 mm
Mount or bracket
SKR-L500.fm Page 3 Tuesday, October 4, 2005 2:15 PM

Product specificaties

Merk: Onkyo
Categorie: Speaker
Model: SKR-L500

Heb je hulp nodig?

Als je hulp nodig hebt met Onkyo SKR-L500 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Speaker Onkyo

Onkyo

Onkyo HT-S3405 Handleiding

22 Juni 2023
Onkyo

Onkyo HTP-2S Handleiding

27 Mei 2023
Onkyo

Onkyo SKS-4700 Handleiding

23 Mei 2023
Onkyo

Onkyo SKS-3600 Handleiding

5 Mei 2023
Onkyo

Onkyo D-407F Handleiding

2 Mei 2023
Onkyo

Onkyo D-309H Handleiding

1 Mei 2023
Onkyo

Onkyo SKS-HT230 Handleiding

16 April 2023
Onkyo

Onkyo SKR-L500 Handleiding

11 April 2023
Onkyo

Onkyo SKS-101 Handleiding

10 April 2023
Onkyo

Onkyo Smart Speaker G3 VC-GX30 Handleiding

4 April 2023

Handleiding Speaker

Nieuwste handleidingen voor Speaker

Kramer

Kramer Tavor 8-Sub Handleiding

21 November 2024
Kramer

Kramer Galil 6-AW Handleiding

21 November 2024
Extron

Extron SM 28 Handleiding

21 November 2024
JBL

JBL RM10 Handleiding

20 November 2024
JBL

JBL Performance IS6 Handleiding

20 November 2024
JBL

JBL Power P-Kit Handleiding

20 November 2024
JBL

JBL Performance P941 Handleiding

20 November 2024
JBL

JBL Performance P52OWS Handleiding

20 November 2024
JBL

JBL Performance PC600 Handleiding

20 November 2024
JBL

JBL Performance IS6DT Handleiding

20 November 2024