Onkyo D-N7BX Handleiding

Onkyo Speaker D-N7BX

Lees hieronder de šŸ“– handleiding in het Nederlandse voor Onkyo D-N7BX (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
En
Speaker System
D-N10BX
D-N9BX
D-N7BX
Instruction Manual
Thank you for purchasing an Onkyo Speaker
System.
Please read this manual thoroughly before using
it. Following the instructions in this manual will
enable you to obtain optimum performance and
listening enjoyment from your new Speaker Sys-
tem.
Please retain this manual for future reference.
Before Using Your New Speakers
ā€¢ The speaker cabinets are made out of
wood and are therefore sensitive to
extreme temperatures and humidity.
Do not use them in locations subject to
direct sunlight or in humid places,
such as near an air conditioner, humid-
iļ¬er, bathroom, or kitchen.
ā€¢ Place the speakers on sturdy, ļ¬‚at sur-
faces. Putting them on uneven or
unstable surfaces where they may fall
and cause damage will affect the
sound quality.
ā€¢ Do not keep water or other liquids
close to the speakers. If a liquid is
spilled over them, the woofer and
tweeter inside may be damaged.
ā€¢ Do not handle the speakers with wet or
damp hands.
D-N10BX,N9BX,N7BX_En.fm Page 1 Thursday, May 25, 2006 5:42 PM
2
In catalogs and on packaging, the letter at the end of the
product name indicates the color. Speciļ¬cations and
operation are the same regardless of the color.
The speakers can handle the speciļ¬ed input power when
used for normal music reproduction. If theyā€™re fed any
of the following signals, even if the input power is
within the speciļ¬ed rating, excessive current may ļ¬‚ow
in the speaker coils, causing burning or wire breakage:
1. Interstation noise from an untuned FM radio.
2. Audio from a cassette thatā€™s being fast-forwarded.
3. High-pitched sounds generated by an oscillator, elec-
tronic musical instrument, and so on.
4. Ampliļ¬er oscillation.
5. Special test tones from audio test CDs and so on.
6. Thumps and clicks caused by connecting or discon-
necting audio cables (always turn off your ampliļ¬er
before connecting or disconnecting cables).
7. Microphone feedback.
The speakers contain powerful magnets. Do not put
metal items, such as screwdrivers, close to the speakers,
as they may be attracted toward the magnet, causing
injury, or damage to the tweeter diaphragm.
ā€¢ D-N10BX/D-N9BX
ā€¢ D-N7BX
The two speakers are identical, so it doesnā€™t matter
which one you use on the left or right.
TVs and computer monitors are magnetically sensitive
devices and as such are likely to suffer from discolora-
tion or picture distortion when conventional speakers
are placed nearby. To prevent this, the speakers feature
internal magnetic shielding. In some situations, how-
ever, discoloration may still be an issue. In this case,
turn off your TV or monitor, wait 15 to 30 minutes, and
then turn it back on again. This normally activates the
degaussing function, which neutralizes the magnetic
ļ¬eld, thereby removing any discoloration effects. If dis-
coloration problems persist, try moving the speakers
away from your TV or monitor. Note that discoloration
can also be caused by a magnet or demagnetizing tool
thatā€™s too close to your TV or monitor.
Note:
If the speakers are placed close to a TV or monitor, due
to the electromagnetic waves radiated by the TV or
monitor, you may hear noise from the speakers even
after your ampliļ¬er has been turned off. To prevent this,
position the speakers away from your TV or monitor.
You can use the speakers either with or without their
grilles, which can be removed as follows.
1. Use both hands to gently pull the bottom of the grille
away from the speaker.
2. Use both hands to gently pull the top of the grille
away from the speaker.
3. To replace the grille, align the four fasteners and gen-
tly push the grille toward the speaker.
* D-N10BX/D-N9BX shown here. Grille removal is
the same for the D-N7BX.
You can improve the sound quality by attaching the
included cork spacers to raise the speakers off the surface
and reduce the contact area. The cork spacers also make
the speakers stable and prevent them from slipping.
* D-N10BX shown here.
Precautions
Getting to Know the Speakers
Tweeter
Grille
attachment pin Grille
Woofer Cabinet
Tweeter
Grille
attachment pin Grille
Woofer Cabinet
Using Close to a TV or Computer
Removing the Speaker Grilles
Using the Included Cork Spacers
ReplaceRemove
D-N10BX/D-N9BX D-N7BX
Cork spacer
Bottom
D-N10BX,N9BX,N7BX_En.fm Page 2 Thursday, May 25, 2006 5:42 PM
3
ā€¢ Before connecting the speakers, disconnect your
ampliļ¬erā€™s power cord from the wall outlet and set its
volume control to minimum.
ā€¢ The speakerā€™s rated impedance is 4
ā„¦
. Make sure you con-
nect an ampliļ¬er that is compatible with a 4
ā„¦
impedance.
ā€¢ Use the supplied speaker cables to connect the speak-
ers to your ampliļ¬er as shown.
The type of speaker terminals used on the receiver and
their position depends on the model. Refer to the
receiverā€™s instruction manual for details on connecting
speakers to the receiver.
Before Turning on Your Receiver:
ā€¢ Make sure the speakerā€™s positive (+) terminals are
connected to the ampliļ¬erā€™s positive (+) terminals,
and the speakerā€™s negative (ā€“) terminals are con-
nected to the ampliļ¬erā€™s negative (ā€“) terminals. If you
get the polarity reversed, the sound will be unnatural,
with a limited bass range and poor stereo image.
ā€¢ Make sure that the positive (+) and negative (ā€“) wires
are not touching each other. If they are, a short circuit
may occur, damaging your ampliļ¬er.
The sound quality of the speakers is directly affected by
the size and shape of the room theyā€™re used in and its
furnishings. When considering where to place your
speakers, read the following:
ā€¢ Where possible, mount the speakers on speaker
stands, concrete blocks, bricks, or a sturdy bookshelf.
Putting them directly on the ļ¬‚oor will emphasize bass
sounds, creating a boomy sound.
ā€¢ If a speaker is placed on an uneven surface where it
can wobble or vibrate, bass performance will be
adversely affected. You can eliminate speaker wobble
by putting a shim made out of cork or metal, such as a
coin, underneath the speaker or stand, as shown.
ā€¢ If you mount the speakers on a ļ¬‚at surface, such as a
bookshelf, you can improve the sound quality by
inserting cork spacers or coins in between the speaker
and the shelf. Raising them off the surface like this
will reduce the contact area and improve the sound.
ā€¢ If you like lots of bass, mount the speakers on low
speaker stands and place them in front of a solid wall.
ā€¢ Walls and furnishings affect sound quality. To achieve
a good stereo sound, put the left and right speakers in
similar locations at the same distance away from your
listening position and at the same height. If you put
them in totally different locations, for example, one
on the ļ¬‚oor and the other on a bookshelf, the stereo
imaging will be adversely affected.
ā€¢ To determine the best positions for your speakers,
imagine an equilateral triangle and put the left and
right speakers at the ends of the base. The ideal listen-
ing position is at or slightly behind the triangleā€™s
apex. Angle the speakers toward your listening posi-
tion.
ā€¢ Glass doors and smooth walls behind the listening
position can reļ¬‚ect the sound from the speakers and
can make sounds at certain frequencies louder. You
can prevent this by hanging sound-absorbing mate-
rial, such as thick curtain, on the door or wall.
D-N10BX
ā€¢ Please note that the speakersā€™ surface features a spe-
cial ļ¬nish. An object placed on the speakers for a
long period of time may leave a trace or mark. Adhe-
sive tape may also leave a mark.
Connecting the Speakers
Right speaker Left speaker
Speaker cable
Positive (+) side is
indicated by a
red line
D-N10BX
shown
1.Peel the
insulation off
the ends of
the speaker
cable and
twist the
core wires.
2.Loosen the
terminal screw
and insert the
speaker cable
into the hole
(until the core
wires are
inserted fully).
3.Fasten the
terminal
screw.
Speaker Placement
Shim
D-N10BX,N9BX,N7BX_En.fm Page 3 Thursday, May 25, 2006 5:42 PM


Product specificaties

Merk: Onkyo
Categorie: Speaker
Model: D-N7BX

Heb je hulp nodig?

Als je hulp nodig hebt met Onkyo D-N7BX stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Onkyo

Handleiding Speaker

Nieuwste handleidingen voor Speaker