Netis ST3116GS Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Netis ST3116GS (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
as an example of the product images below.
Power Adapter
ADSL/Router Switch
Computer
60W 120W
60W 120W
3
> Check if the Power Adapter/Power Cord is well connected. Try to unplug and
plug back in the Power Adapter/Power Cord to the switch or try another power
outlet.
2. The LINK/ACT LED is not on.
> Make sure the network configuration of connecting device is correct, and
network card and drivers are installed correctly.
> Check the cable connections.
> Make sure the cable distance between the switch and other IEEE802.3
compatible network device does not exceed 100 meters.
3. Performance is bad.
> Check the status of Ethernet switching. If Ethernet switching is set to full-duplex
on one device but a partner is set to half-duplex, then performance will be poor.
> Make sure the cable between the switch and other IEEE802.3 compatible
network device is Category 5 UTP or better.
4. Some devices can't talk to other devices on the network.
> Check status of the LINK/ACT LEDs to make sure devices are linked.
> Make sure that the devices' network configurations are correct.
> Reset the switch if needed.
1.The Power(PWR) LED is not on.
Warning:
[A shielded-ty pe power c o rd is required i n ord er to meet FCC emission limits and also to
prevent interference to the nearby radio and television reception. It is essential that only the
supplied power cord be used.]
[Use only s hielded cables to connect I/O devices to this equipment.]
You are cautioned that changes or modifications not ex pr es sl y a pp ro ve d b y t h e par ty
re sp on si bl e f or compliance could void your authority to operate the equipment.
[ ]:depend on EUT condition.
This devic e complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this devic e may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Appendix A: FCC Statement
FCC St ate ment
(For ST-3105, ST-3108, ST3105S, ST3108S, ST3105G, ST3105GS ST3108GS),
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
(For ST3108G, ST3116, ST3124, ST3116P, ST3124P, ST3116G, ST3124G, PE6108,
PE6108H, PE6108GH, PE6108G)
This Equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is lik ely to cause harmful interference,
in which case the user will be required to correct the interference at his/her own expense.
Appendix B: Industry of Canada Statement
PK UM 0 59 10
(For ST3105S, ST3108S, ST3105G)
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
(For ST3108G)
This Class [A] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [A] est conforme à la norme NMB-003 du
Canada.
Technical Support:
USA/ Canada:
Toll Free: +1 866 71 network (+1 866 716 3896)
E-mail: usa_support@netis-systems.com
Other Regions:
E-mail: support@netis-systems.com
NETI S SYSTEMS C O., LTD.
www.netis-systems. com
MADE IN CHI NA
ST3105GS, ST3108GS
4


Product specificaties

Merk: Netis
Categorie: Niet gecategoriseerd
Model: ST3116GS

Heb je hulp nodig?

Als je hulp nodig hebt met Netis ST3116GS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Netis

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd