MXL DRK Handleiding

MXL Niet gecategoriseerd DRK

Lees hieronder de 📖 handleiding in het Nederlandse voor MXL DRK (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 280 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

Marshall Electronics, Inc. Professional Audio Division, El Segundo, CA

www.MXLmics.com www.mogamicable.com sales@MXLmics.com• •

Care

Dust and moisture will degrade the performance of a microphone over time so always store

the unit in its case. It is strongly advised to use a mesh pop-ﬁlter to avoid moisture from

damaging the capsule.

NEVER clean the microphone with any household cleaner or any liquid cleaner.

Warranty

Marshall microphones are guaranteed against defects in material and workmanship for one year from date of

purchase. Should you encounter any problem with this unit, promptly contact the company you purchased

it from for assistance. The original dated sales receipt will be necessary for any warranty claim. Do not send

any unit directly to us without prior authorization from our service department! Warranty coverage is limited

to repair or replacement (at our option) of the microphone, and does not cover incidental damages due to

use of this unit, nor damage caused by accidental misuse of this product.

DRK Users Manual

1. On the microphone clip, you’ll ﬁnd an adjustment for angling the position

of the microphone. Adjust the clip so that the “cup” of the microphone

clip is facing upward.

2. Holding the microphone securely in one hand, place the microphone into

the “cup” portion of the microphone clip and then tighten the knurled ring

back onto the base of the microphone. Your microphone is now sup

ported by the microphone stand.

Attaching the XLR Cable

Your XLR cable has diﬀerent connectors on each end. One end has three small

prongs (male), while the other has three small holes (female).

1. Begin by attaching the female end of the XLR cable to the base of the

microphone by aligning the notches (one notch each for the microphone

and the cable). The cable will ﬁt snugly into place. To remove the cable,

press and hold the release switch on the cable’s connector.

2. If you are connecting your microphone into the XLR connector of a

microphone preampliﬁer or the input channel of a mixer, the other

end of the XLR cable will patch directly into the external device and you

will be ready to begin.

Using Your Microphone with a Computer

Most computers use what is known as a 3.5mm mini jack for audio input and

output. To connect your microphone to a computer, you’ll need to use the

supplied XLR - 3.5mm Mini-Plug adapter cable.

With your XLR cable already attached to the microphone, connect the male

end of the XLR cable to the female (XLR) end of the adapter cable. The other

end of the cable will have a 3.5mm connector. You are now ready to connect

to the computer’s audio input.

Many self-contained personal recording systems use ¼-inch inputs. Others have

both ¼-inch and XLR inputs. If the external device has XLR connectors, you can

patch the microphone directly into the external unit by using the supplied XLR

cable. If the external device uses ¼-inch inputs, you’ll need to use the supplied

XLR to Mini-Plug Adapter Cable with the 3.5mm to ¼-inch Adapter.

1. Connect your microphone and XLR cable to the XLR to Mini-Plug

Adapter Cable as previously described.

2. Plug the 3.5mm mini jack into the supplied 3.5mm to ¼-inch adapter.

You are now ready to use your microphone with ¼-inch input-equipped

Unpack Your Microphone

Begin by removing the contents of your

MXL Recording Kit.

You should have the following components:

• Self-Powered Microphone

• Desktop Stand

• Microphone Clip (this holds the microphone)

• XLR cable (this is the cable with 3-prong connections on each end)

• XLR to Mini-Plug Adapter Cable (this cable enables you to patch into your computer)

• 3.5mm Mini-Plug to ¼-inch adapter

• 9-Volt battery

Preparing the Microphone Stand and Clip

1. Open the desktop microphone stand so the tripod is fully open and

standing upright.

2. Take the microphone clip and screw it onto the microphone stand’s

threaded mount.

Setting Up Your Microphone

1. Holding the microphone securely in one hand, unscrew and remove the

knurled ring at the base of the microphone.

2. Now unscrew and remove the sloped ring around the base of the

microphone’s body. The microphone’s tubular body will now be loose.

3. Prior to removing the microphone’s main body housing, take a few mo

ments to visually orient yourself to the position of the battery switch rela

tive to the On/Oﬀ\ markings on the microphone’s body. Now carefully

remove the main body housing.

4. On the opposite side of the microphone from the On/Oﬀ switch, you’ll see

the housing that holds the 9-volt battery. The battery can only be inserted

one way - so don’t worry!

5. Place the battery (terminals ﬁrst) into the battery housing and slide it

down and into position. The battery will “snap” into place when fully

inserted. If the battery doesn’t seem to ﬁt, ﬂip it over and re-insert it into

the housing.

6. Carefully replace the microphone’s main body housing - aligning the

On/Oﬀ markings with the microphone’s battery switch.

7. Next, re-install the sloped ring onto the base of the microphone. The

microphone’s body parts will now be secure and the On/Oﬀ switch

should move freely between the two positions.

Congratulations on your purchase of your MXL Recording Kit.

MXL microphones are the result of world-class engineering and man-

facturing capabilities. They are designed to provide you with outstand-

ing peformance and exceptional value. To help you get started, please

take a few moments to review the following instructions for setting up

your new microphone.

Conﬁguring Your New MXL Microphone Placing the Microphone on the Desktop Stand

Using Your Microphone with ¼ -inch Input - Equipped Devices

Using Your Self-Powered Microphone with Phantom Power

Your self-powered MXL microphone can be used with phantom power without fear of damag-

ing either the microphone or the phantom power source. If the microphone senses phantom

power, it will automatically bypass the internal battery and operate using phantom power.

Please turn the microphone to the oﬀ position when not in use and remove the battery

when storing or not using the microphone for long periods of time.

devices.

Product specificaties

Merk:	MXL
Categorie:	Niet gecategoriseerd
Model:	DRK

Heb je hulp nodig?

Als je hulp nodig hebt met MXL DRK stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd MXL

MXL uCHAT AC-406 Handleiding

16 November 2023

MXL FR-500WT Handleiding

16 November 2023

MXL Revelation Mini Handleiding

16 November 2023

MXL 2006 Handleiding

15 November 2023

MXL RF-100 Handleiding

15 November 2023

MXL 2003A Handleiding

12 Augustus 2023

MXL DRK Handleiding

12 Augustus 2023

MXL V67i Handleiding

12 Augustus 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Electrolux STA9 Handleiding

23 November 2024

Electrolux UMP3 Handleiding

23 November 2024

Electrolux ZS70GL Handleiding

23 November 2024

Bosch HEZ8TK36UC Handleiding

23 November 2024

Bosch HEZ8ZZ36UC Handleiding

23 November 2024

Bosch HDZIT301 Handleiding

23 November 2024

Bosch HEZBS301 Handleiding

23 November 2024

LG LX-330 Handleiding

23 November 2024

Stamos S-PLASMA 60U Handleiding

23 November 2024

Bosch KSZ2AVU00 Handleiding

22 November 2024