Mooer CT-01 Handleiding

Mooer Niet gecategoriseerd CT-01

Lees hieronder de 📖 handleiding in het Nederlandse voor Mooer CT-01 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 237 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

放置场所

为防止变形、变色，及其他严重损坏，请避免以下情况：

•阳光直射 •靠近热源

•磁场 •高温潮湿

•多尘或不洁的地方 •湿度较大

•强烈震动或摇晃

电器干扰

在使用本机时，收音机和电视机可能会造成干扰。使用本机时要远离收音机

和电视机。

清洁

请使用干燥柔软的布清洁本机。如有必要，可用稍微湿润的布拭擦。

切勿使用粗糙的清洁粉、酒精、涂料稀释剂、蜡、溶剂、清洁剂及化学试剂

等浸渍抹布。

操作

请勿暴力使用开关及控制元件。

请勿让纸屑、金属制品及其他物体落入机内。

注意不要摔落，不要使其受到冲击及过度压力。

电池供电

请使用一颗标准的3V钮扣锂 (CR2032) 。电池进⾏供电

性能概述

精准、灵敏、快捷的夹式调音表，适合吉他和贝斯使用

高亮度的显示屏方便在黑暗的舞台环境使用

内置重力感应装置，180°自动切换方向

支持调谐435Hz - 445Hz

具备省电模式以及自动关机模式

精致摩登的外观与坚固耐用的结构完美融合

操作说明

面板说明

1. 半音显示：

音名半音显示

2. 音高准确显示：

显示音名音高准确时，

音名上下指示灯同时亮起

3. 开机按键：

短按打开或关闭调音表长按进入调谐

模式无操作后秒自动退出3

4. 音高偏移显示：

音名左边显示音高偏低，

右边显示偏高

5. 显示屏幕：

重力感应可上下倒转显示无操作后

秒进入省电待机模式分钟后自动关机。10 2

6. 音名显示：

十二平均律显示

7. 电池舱：

可安装钮扣电池3V

8. 固定夹：

稳固耐用的金属夹具

MAD E IN CHIN A

Bat tery : CR 2032 3V

CT CT -

--01

0101

技术参数

电池供电: 3V钮扣锂（CR2032）

尺寸: 57 mm L X27mm W X8mm H （）（）（）

重量: 25g

附件: 使用手册

*免责声明：参数更新恕不另行通知。

CT-01

夹式调音表

1. 180把调音表固定到乐器上，显示屏可度打开方便看清调音情况。

2. LED按下电源模式按钮屏幕亮起，调音表进入开启状态。

3. 0’ 440Hz开启状态下长按电源按钮可进入调谐模式，当屏幕显示为‘ 时表示当前为；

 ，；按下按键循环切换- 至+5 5 表示至435Hz 445Hz 无操作秒后自动退出调谐模式。3

4. Clip Tuner 10 2将会在无操作秒后进入省电模式，分钟后会自动关机节省电池电量消耗。

5. 用户可自行在调弦模式下按下按键进行关机操作。

1. Semitone Display:

Indicates if the note is a flat or sharp.

MAD E IN CHIN A

Bat tery : CR 2032 3V

CT CT-

--0

001

CT-01

Precautions

Power Supply

Please be sure to only use a 3V lithium button cell (Cr2032).

Cleaning

Clean with a soft, dry cloth. If necessary, slightly moisten the cloth.

Do not use abrasive cleansers, cleaning alcohol, paint thinners, wax, solvents,

cl eaning fluids, or chemical-impregnated wiping cloths.

Interference with other electrical devices

Radios and televisi ons placed nearby may experience reception interference.

Operate this unit at a suitable distance from radios and televisions.

Do not leave this product attached to your instrument when not in use as it could

damage the finish on some instruments, especially if while exposed to bright light

or hea t.

Location

Avoid le aving the CT01 Tuner in the following locations:

Direct sunlight

Magnetic fields

Excessively dusty or dirty areas

To avoid deformation, discoloration, or other serious damage, do not expose this

unit to the following conditions:

Heat sources

Extreme temperature or humidity

High humidity or moisture

PLEASE READ CAREFULLY BEFORE PROCEEDING

Features

Suitable for guitar and bass guitar

Fast, accurate tuning from 435 to 445Hz

180° rotatable hinge

Power saving mode and automatic shutdown

Bright, colorful display

•Attach the tuner to the headstock or body of your instrument. The clamp can be

rotated up to 180° to find your preferred viewing angle.

• Power on the tuner by pressing the power button.

• Press and hold the power button in the ON state to adjust the tuning

frequency. When the screen displays “0”, the tuner is set to 440HZ. You can

adjust the frequency from “-5” to “+5” or 435Hz to 445Hz, by pressing the power

button again. This mode will automatically exit after three seconds.

• Ad just the string to the target note as indicated on the pitch display. The note

is in tune when both indicator LEDs are simultaneously lit up.

• The tuner will enter power saving mode after 10 seconds. After 2 minutes,

CT01 will turn off automatically.

• The user can power it off manually by pressing the power switch.

2. Accurate Pitch Display:

Displays the current string’s

target note. Both the upper and

lower indicator LED light up

simultaneously when correct

pitch is achieved.

3. Power Switch:

Press switch to power on/off.

Press and hold to adjust the tuning

frequency. It will automatically exit

after 3 seconds.

4. Pitch Offset Display:

Indicates if the target note is sharp

(above) or flat (below).

5. Screen:

The CTO1 tuner is gravity sensitive and

the display will always adjust to face the

proper direction, allowing you to mount

it as you wish.

6. Pitch Display:

Indicates the target note.

7. Battery Compartment:

Use 3V lithium cell battery only.

8. Retaining Clamp:

Stable and durable metal fixture with

180° rotatable hinge.

Layout

Instructions

Power requirements: 3V lithium cell (Cr2032)

Dimensions: 57 mm L X27mm W X8mm H（）（）（）

Weight: 25g

Accessories: Owner’s Manual

*Notes Any specification’s update will not be amended in this manual.：

Specification

Clip-on Tuner

Product specificaties

Merk:	Mooer
Categorie:	Niet gecategoriseerd
Model:	CT-01

Heb je hulp nodig?

Als je hulp nodig hebt met Mooer CT-01 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Mooer

Mooer GE250 Handleiding

30 November 2024

Mooer PRIME S1 Handleiding

6 April 2024

Mooer MICRO DI Handleiding

9 Juli 2023

Mooer Echolizer Handleiding

9 Juli 2023

Mooer Noise Killer Handleiding

8 Juli 2023

Mooer Echoverb Handleiding

8 Juli 2023

Mooer Solo Handleiding

8 Juli 2023

Mooer 019 Handleiding

7 Juli 2023

Mooer Micro Aby MK2 Handleiding

7 Juli 2023

Mooer Triangle Buff Handleiding

7 Juli 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

D-Link DFE-680TX Handleiding

23 December 2024

D-Link DGE-550T Handleiding

23 December 2024

D-Link DGE-560SX Handleiding

23 December 2024

D-Link DGE-510T Handleiding

23 December 2024

Mercusys MS116GS Handleiding

23 December 2024

Yato YT-83060 Handleiding

23 December 2024

Hazet 176 N-7 Handleiding

23 December 2024

Savio RC-14 Handleiding

23 December 2024

Adder Link Portal R110 Handleiding

23 December 2024

Proctor Silex 34116 Handleiding

23 December 2024