Minn Kota MK 230PC Handleiding

Minn Kota Acculader MK 230PC

Lees hieronder de 📖 handleiding in het Nederlandse voor Minn Kota MK 230PC (13 pagina's) in de categorie Acculader. Deze handleiding was nuttig voor 58 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/13

OWNER’S MANUAL FOR

MINN KOTA ONBOARD

BATTERY CHARGERS

Models: MK115PC, MK230PC,

MK345PC, MK460PC

Service Information:

Please call our service department at

1.800.227.6433 if you have any problems

with your battery charger. A technical support

representative will be happy to assist you.

Compliant with FCC

PART 15, Class A

Designed and Constructed to

Marine UL1236 Standard.

1) IMPORTANT SAFETY INSTRUCTIONS

a) SAVE THESE INSTRUCTIONS! This manual contains important safety and operating instructions applicable to the safe and efficient use

of your Minn Kota battery charger.

b) The Minn Kota battery charger is a powerful electrical device. If incorrectly installed, configured or operated, the battery charger can damage

batteries and / or electrical equipment. Please thoroughly read the instructions and safety information contained in this manual before operat-

ing the battery charger.

c) Use of an attachment not recommended or sold by Johnson Outdoors Inc. may result in risk of fire, electric shock, or injury to persons or prop-

erty.

d) The charger is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not

play with the charger.

e) To reduce risk of damage to electric plug or cord, pull by the plug rather than the cord when disconnecting the battery charger.

f) An extension cord should not be used unless absolutely necessary. Use of the improper extension cord could result in a risk of fire or electric

shock. If extension cord must be used, make sure:

i) That pins of plug of the extension cord are the same number, size and shape of those of the plug on the battery charger;

ii) That extension cord is properly wired and in good electrical condition; and

iii) That wire in extension cord is proper size as follows:

g) Do not operate the battery charger with a damaged cord or plug.

h) Do not operate the battery charger if it has received a sharp blow, been dropped or otherwise damaged in any way.

i) Do not disassemble the charger. Incorrect reassembly may result in a risk of electric shock or fire.

j) To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning. Disconnecting the leads will not

reduce this risk.

k) To reduce risk of shock or spark, never touch the ring terminals together while the charger is plugged into an outlet or extension cord.

l) External connections to the battery charger shall comply with the United States Coast Guard electrical regulations (33CFR183, Sub Part 1).

2) PERSONAL PRECAUTIONS

a) Consider having someone close enough nearby to come to your aid when you work near a lead acid battery.

b) Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.

WARNING: RISK OF EXPLOSIVE GASES

WORKING IN THE VICINITY OF A LEAD ACID BATTERY IS DANGEROUS. BATTERIES CONTAIN SULFURIC ACID AND PRODUCE

EXPLOSIVE GASES. A BATTERY EXPLOSION COULD RESULT IN LOSS OF EYESIGHT OR SERIOUS BURNS. FOR THIS REASON, IT

IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS EACH TIME YOU USE THE CHARGER.

TO REDUCE THE RISK OF BATTERY EXPLOSION, FOLLOW THESE INSTRUCTIONS AND THOSE PUBLISHED BY THE BATTERY

MANUFACTURER FOR ANY EQUIPMENT YOU INTEND TO USE IN THE VICINITY OF THE BATTERY. REVIEW CAUTIONARY

MARKINGS ON THESE PRODUCTS AND ON ENGINE, MOTOR OR OTHER EQUIPMENT REQUIRING BATTERY USAGE.

Minimum recommended AWG wire size for various length extension cords used with the Minn Kota battery charger:

MK115PC Length of Cord in feet 25 50 100 MK230PC Length of Cord in feet 25 50 100

AWG Size 18 18 16 AWG Size 16 16 12

MK345PC Length of Cord in feet 25 50 100 MK460PC Length of Cord in feet 25 50 100

AWG Size 16 12 10 AWG Size 14 12 10

WARNING – DO NOT ATTEMPT TO REPAIR OR SERVICE THE CHARGER YOURSELF. OPENING THE CHARGER MAY EXPOSE YOU

TO HIGH VOLTAGES, THE RISK OF ELECTRIC SHOCK, AND OTHER HAZARDS.

c) Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery.

d) If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately flush eye with running cold

water for at least 10 minutes and get medical attention immediately.

e) Never smoke or allow a spark or flame in vicinity of battery, engine, motor or other flammable or explosive equipment.

f) Be extra cautious to reduce risk of dropping a metal tool onto the battery or across the battery terminals. It might spark or short circuit the bat-

tery or other electrical component that may cause an explosion.

g) Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a lead acid battery. A lead acid battery

can produce a short circuit current high enough to weld such items, causing severe burns.

h) Use the Minn Kota battery charger for charging and maintaining FLOODED LEAD-ACID, MAINTENANCE FREE, GEL CELL, AND AGM /

STARVED ELECTROLYTE batteries only. It is not intended to supply power to low voltage electrical systems other than for charging and

maintaining batteries. Do not use the charger for charging dry-cell batteries that are commonly used with home appliances. These batteries

may burst and cause injury to persons and damage to property.

i) NEVER charge a frozen battery.

3) PREPARING TO CHARGE

a) If necessary to remove battery from boat or vehicle to charge or maintain, always remove grounded terminal from battery first (if applicable).

Make sure all accessories in the boat or vehicle are off, so as not to cause an arc.

b) Be sure area around battery is well ventilated while battery is being charged or maintained.

c) Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.

d) Add distilled water in each cell until battery acid reaches level specified by battery manufacturer. Do not overfill. For a battery without remov-

able cell caps, such as valve regulated lead acid batteries, carefully follow manufacturer’s recharging instructions.

e) Study all battery manufacturers’ specific precautions while charging and for recommended rates of charge.

4) CHARGER LOCATION AND MOUNTING

a) Locate charger as far away from battery as the dc cables permit.

b) Never place charger above battery being charged; gases from battery will corrode and damage charger.

c) Never allow battery acid to drip on charger when reading electrolyte specific gravity or filling battery.

d) Do not operate charger in a closed-in area or restrict ventilation in any way.

e) Do not set a battery on top of charger.

f) Do not mount the charger below the waterline of the boat or directly adjacent to fuel tanks.

g) Each DC output cord is six feet long. Make sure that all DC output cords can reach the batteries and that the AC power cord can reach a

power source. When using an extension cord, make the AC connection to the charger outside of the battery compartment as far away as

practical to reduce the risk of a spark igniting gasses in the compartment.

h) Each output cord is equipped with a temperature sensor. By monitoring external temperature, the battery charger adjusts the charging profile

of the battery to assure full charge without overcharging or undercharging the battery. Attempting to shorten the output wires could damage

the temperature sensor and affect the charger output.

i) If the DC battery leads are not long enough, they may be lengthened by splicing and soldering 12 AWG (minimum) wire. Each splice should

be covered with dual wall adhesive lined heat shrink tubing to protect the joint from corroding. The splice should be made between the

fork in the output cable and the fuse holder. The fuse holder should always remain within 7” of the battery terminals. The maximum exten-

sion length is 15 feet. You may contact the Minn Kota Service Department with any questions. Do not splice the AC power cord, as this

voids the three year Limited Warranty.

Product specificaties

Merk:	Minn Kota
Categorie:	Acculader
Model:	MK 230PC
Kleur van het product:	Zwart
Ingebouwd display:	Nee
Gewicht:	4000 g
Breedte:	254 mm
Diepte:	241 mm
Hoogte:	95 mm
Oplaadspanning:	12/24 V
Output current:	7 A
AC-ingangsspanning:	110 - 120 V
AC-ingangsfrequentie:	60 Hz