Midland MicroMobile MXAT01VP Handleiding

Midland Radio MicroMobile MXAT01VP

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Midland MicroMobile MXAT01VP (1 pagina's) in de categorie Radio. Deze handleiding was nuttig voor 59 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
5900 Parretta Drive KANSAS CITY, M●O ● 64120
PHONE: (816) 241 8500 5713- ● FAX: (816) 241-
EMAIL: mail@midlandradio.com
WEBSITE: midlandusa.com
Midland Radio Corporation
midlandusa.com
10 16/ /2022
MXAT01 NMO Mount Assembly Diagram
1. The MXAT01 NMO mount is designed for mounting brackets or surfaces up to 1/2" thick.
2. The MXAT01 NMO mount is designed to be installed in a 1/2" hole, commonly used for 3/8” stud mount
CB antennas.
3. Part C should be adjusted so the center conductor on the Part D NMO interface extends 9/32” to 5/16”
beyond the mounting surface, or just above the top surface of Part A when installed.
4. Use the hex head on the Part D NMO interface to hold it in position while Part A is installed and tightened.
5. Part A is installed on top of the bracket or mounting surface with the wrench flats up and the O-ring
down. The rubber O-ring on the bottom of part A acts as a seal to prevent water entering the mounting
s - urface hole. Maximum torque: 32 lb ft.
6. The hex head can also be used to hold the NMO interface in position while tightening the PL259
connector, Part F, by hand.
7. The center conductor of Part D should end up 1/32” to 1/16” proud of Part A to properly interface with
the MXAT01 antenna. Tighten the antenna by hand, to just snug.


Product specificaties

Merk: Midland
Categorie: Radio
Model: MicroMobile MXAT01VP

Heb je hulp nodig?

Als je hulp nodig hebt met Midland MicroMobile MXAT01VP stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Radio Midland

Handleiding Radio

Nieuwste handleidingen voor Radio