Midea D80-15FA3 Handleiding

Midea Ketel & boiler D80-15FA3

Lees hieronder de 📖 handleiding in het Nederlandse voor Midea D80-15FA3 (28 pagina's) in de categorie Ketel & boiler. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/28
Storage Electric Water Heater
The diagram above is just for reference. Please take the
appearance of the actual product as the standard.
Instruction Manual
Model: D30-15FA3
D50-15FA3
D80-15FA3
D100-15FA3
Thank you very much for purchasing our water heater.
Before installing and operating your water heater, please
read this manual carefully and keep it for future reference.
1
The installation and maintenance has to be carried out by qualified professials or
Midea authorized technicians.
The manufacturer shall not be held responsible for any damage or malfunction caused by
wrong installation or failing to comply with following instructions included in this pamphlet.
For more detailed installation and maintenance guidelines, please refer to below chapters.
TABLE OF CONTENTS
TITLE PAGE
1.CAUTIONS....................................................................................................................... (2)
2.PRODUCT INTRODUCTION ...........................................................................................(3)
3.UNIT INSTALLATION .......................................................................................................(5)
4.METHODS OF USING .....................................................................................................(7)
5.MAINTENANCE ...............................................................................................................(7)
6.TROUBLESHOOTING .....................................................................................................(8)
7.PRODUCE INFORMATION WITH EU REGULATION .....................................................(9)
General Remark
2
The supply socket must be earthed reliably. The rated current of the socket shall not be lower
than 10A. The socket and plug shall be kept dry to prevent electrical leakage. Inspect
frequently whether the plugs contact well with the socket. Inspect method is as follows: insert
the power supply plug into socket, after using for half an hour, shut down the unit and pull the
plug out, and inspect the plug whether it scalds hand. If it scalds (over 50 ), please change
another well-contacted socket to avoid the plug being damaged, fire or other personnel
accidents result from bad-contacting.
The installation height of the supply socket shall not be lower than 1.8m.
The wall in which the electrical water heater is installed shall be able to bear the load more than
two times of the heater filled fully with water without distortion and cracks. Otherwise, other
strengthening measures shall be adopted.
The pressure relief valve attached with the heater must be installed at the cold water inlet of
this heater(see Fig.1), and make sure it is not exposed in the foggy. The water may be
outflowed from pressure relief valve, so the outflow pipe must open wide in the air; The
pressure relief valve need to be checked and cleaned regularly, so as to make sure it will not
be blocked.
Before installing this water heater,check and confirm that the earthing on the supply socket is
reliably grounded. Otherwise, the electrical water heater can not be installed and used. Do not
use extension boards. Incorrect installation and use of this electrical water heater may result in
serious injuries and loss of property.
Special Cautions
1. CAUTIONS
(Fig.1)
When using the heater for the first time(or the first use after maintenance), the heater can not
be switched on until it has been filled fully with water. When filling the water, at least one of the
outlet valves at the outlet of the heater must be opened to exhaust the air. This valve can be
closed after the heater has been filled fully with water.
The water heater is not intended for use by persons(including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instructions concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the heater.
Hot water Cold water
Pressure
relief valve
Thread screw
Drain handle
Pressure release hole


Product specificaties

Merk: Midea
Categorie: Ketel & boiler
Model: D80-15FA3
Kleur van het product: Wit
Gewicht: 25500 g
Breedte: 450 mm
Diepte: 450 mm
Hoogte: 809 mm
Energie-efficiëntieklasse: C
Soort: Tank (wateropslag)
Capaciteit watertank: 80 l
Ondersteuning voor plaatsing: Verticaal
Thermometer: Ja
Maximaal vermogen: 1500 W
Maximum werkdruk: 7.5 bar
Water tank materiaal: Geëmailleerd staal
AC-ingangsspanning: 220 - 240 V
AC-ingangsfrequentie: 50 Hz
Verwamingslocatie: Binnen
Zonneenergie batterijen ondersteuning: Nee
Brandstof: Electrisch
Boiler systeem: Solo-boilersysteem
Warmwatercapaciteit: - l/min
Materiaal verwarmingselement: Roestvrijstaal

Heb je hulp nodig?

Als je hulp nodig hebt met Midea D80-15FA3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Ketel & boiler Midea

Handleiding Ketel & boiler

Nieuwste handleidingen voor Ketel & boiler