Metra LC-GMRC-LAN-09 Handleiding

Metra Niet gecategoriseerd LC-GMRC-LAN-09

Lees hieronder de 📖 handleiding in het Nederlandse voor Metra LC-GMRC-LAN-09 (8 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/8
LC-GMRC-LAN-09
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 5/30/19 INSTLC-GMRC-LAN-09
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
INTERFACE COMPONENTS
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip ties
TABLE OF CONTENTS
Connections ............................................................2
Installation .............................................................3
Programming .........................................................3
APPLICATIONS
Chevrolet
Colorado 2015-2018(1)
Equinox 2018(1)
Malibu 2016-2018(2)
Silverado 2015-2018(3)
Silverado 1500 2014(3)
Suburban 2015-up
Tahoe 2015-up
GMC
Canyon 2015-2018(1)
Sierra 2015-2018(3)
Sierra 1500 2014(3)
Yukon / Yukon XL 2015-up
• LC-GMRC-LAN-09 interface • LC-GMRC-LAN-09 harness
• (1) • (2) With RPO code I05 or I06 With radio code IP1 With radio code IO3, IO5, or IO6• (3)
The RPO code is located in the Service Parts Identification sticker
INTERFACE FEATURES
GM Data Interface 2014-up
•
Provides accessory power (10-amp)
• Retains R.A.P. (retained
accessory power)
• Provides wires for multimedia
radios (park brake, reverse,
speed sense)
• Used in non-amplified models, or
when bypassing a factory amp
•
Designed for models without
OnStar
• Retains all warning chimes
• High level speaker input
• Retains balance and fade
• Provides illumination output
• Micro-B USB updatable
Visit AxxessInterfaces.com for more detailed information about the product and up-to-date
vehicle specific applications
2
CONNECTIONS
From the LC-GMRC-LAN-09 harness to the aftermarket radio:
• Connect the wire to the ground wire.Black
• Connect the Yellow wire to the battery wire.
• Connect the wire to the accessory wire.Red
• If retaining the factory AUX-IN jack, connect the & RCA jacks to the AUX input.Red White
• If the aftermarket radio has an illumination wire, connect the wire to it.Orange
• Connect the wire to the left front positive speaker output.White
• Connect the wire to the left front negative speaker output.White/Black
• Connect the wire to the right front positive speaker output.Gray
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the wire to the left rear positive speaker output.Green
• Connect the wire to the left rear negative speaker output.Green/Black
• Connect the wire to the right rear positive speaker output.Purple
• Connect the wire to the right rear negative speaker output.Purple/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the wire to the VSS/speed sense wire.Blue/Pink
• Connect the wire to the reverse wire.Green/Purple
• Connect the wire to the parking brake wire.Light Green
3
REV. 5/30/2019 INSTLC-GMRC-LAN-09
INSTALLATION
PROGRAMMING
With the key in the off position:
1. Locate the factory radio harness in the vehicle and complete all necessary connections to the
aftermarket radio.
2. Connect the LC-GMRC-LAN-09 harness LC-GMRC-LAN-09 interface into the , and then to the
factory radio harness in the vehicle.
Note: For the Equinox and Malibu, use part number AX-GMLAN09EXT (sold separately) to extend
the wiring harness to the right of the glovebox where the radio brain is located at.
Attention: If the interface loses power for any reason, the following steps will need to be
performed again.
1.
Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on
.
If the radio does not come on within 60 seconds, turn the key to the off position, Note:
disconnect the interface, check all connections, reconnect the interface, and then try again.
2.
Cycle the key off. If the driver’s door is closed, open and close the door. Cycle the key back on.
3. Test all functions of the installation for proper operation, before reassembling the dash.

Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: LC-GMRC-LAN-09

Heb je hulp nodig?

Als je hulp nodig hebt met Metra LC-GMRC-LAN-09 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Metra

Metra

Metra 95-7022HG Handleiding

12 November 2024
Metra

Metra 95-7642 Handleiding

12 November 2024
Metra

Metra 71-017C Handleiding

26 September 2024
Metra

Metra AXSP-HK Handleiding

26 September 2024
Metra

Metra 109-TO7 Handleiding

24 September 2024
Metra

Metra 95-8273B Handleiding

6 September 2024
Metra

Metra 95-7822 Handleiding

6 September 2024
Metra

Metra 82-8703 Handleiding

6 September 2024
Metra

Metra 88-00-9004 Handleiding

6 September 2024
Metra

Metra 82-9101 Handleiding

6 September 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Taga Harmony

Taga Harmony TOS-600 v.2 Handleiding

26 November 2024
Trace Elliot

Trace Elliot Pro 2x12 Cabinet Handleiding

26 November 2024
Kramer

Kramer K-Bar Camera Bracket Handleiding

26 November 2024
Kramer

Kramer RK-19 Handleiding

26 November 2024
Kramer

Kramer OSP-MM1 Handleiding

26 November 2024
Kramer

Kramer ASPEN-1616UX Handleiding

26 November 2024
Korg

Korg Pitchstrap Handleiding

26 November 2024
NeoMounts

NeoMounts WL70-450BL11 Handleiding

26 November 2024
Kramer

Kramer CLS-AOCH/60 Handleiding

26 November 2024
Klauke

Klauke EKM 6022ISM Handleiding

26 November 2024