Metra JP-JTKT Handleiding

Metra Dashcam JP-JTKT

Lees hieronder de 📖 handleiding in het Nederlandse voor Metra JP-JTKT (8 pagina's) in de categorie Dashcam. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
©COPYRIGHT 2021 METRA ELECTRONICS CORPORATION
Metraonline.comMetra Electronics Corp. ®REV. 06/18/2021 INSTJP-JTKT
Attention! When testing the aftermarket
equipment, ensure that all factory equip-
ment is connected before cycling the key to
ignition.
JP-JTKT
INSTALLATION INSTRUCTIONS
Camera Removal ................................................ 2-4
Assembly 5 ................................................................
Wiring 6 .....................................................................
Specifications 7 .........................................................
TABLE OF CONTENTS
TOOLS REQUIRED
• 5/32 Allen bit
• Torx T6H bit
• Zip-ties
Jeep Gladiator JT 2020-UP*
Replacement Camera Kit
*Visit Metraonline.com for more detailed informatuon about the product and up-to-date vehicle specific
applications.
A) Camera B) Bracket - 1 and 2 C) Harness
A B C
Product Features
• Designed to replace the LVDS camera on Jeep Gladiator
• Direct OE replacement
• ABS brackets
• Resolution: 550 TV lines
• Viewing Angle: 160 degrees
• Improved power circuit
386-257-1187
|
Metraonline.com
2
1. Remove the eight 5/32 bit screws from
the tailgate panel. (Figure A)
2. Remove the panel and safely set aside.
3. Remove the two 5/32 bit screws from the
smaller blue panel. (Figure B)
4. Remove the panel and safely set aside.
NOTE: Some trucks that do not have a bed
cover may look different. Make sure to safely
remove all screws and panels and set aside
before lifting up the tailgate.
Figure A Figure B
CAMERA REMOVAL
REV. 06/18/2021 INSTJP-JTKT 3
1. Unplug the pink camera cable and set
aside. For this install the pink cable will
not be used so iBEAM suggests ziptieing
the cable back so there is no rattle in the
tailgate.
2. Remove the retention clip around the
camera. Slide in the direction of the
arrow and set aside, this will be need-
ed this later when installing the new
camera.
3. There is a clip below the area highlighted
in Figure B. Press that clip in and slide
the camera out towards the front side of
the tailgate.
Figure A Figure B
CAMERA REMOVAL (CONT.)


Product specificaties

Merk: Metra
Categorie: Dashcam
Model: JP-JTKT

Heb je hulp nodig?

Als je hulp nodig hebt met Metra JP-JTKT stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Dashcam Metra

Handleiding Dashcam

Nieuwste handleidingen voor Dashcam