Metra 99-7882B Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Metra 99-7882B (8 pagina's) in de categorie Carkit. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8
METRA. The World’s best kits.®metraonline.com © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
REV. 11/14/2017 INST99-7882B
CAUTION!
Metra recommends disconnecting the negative bat
-
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con
-
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
Installation instructions for part 99-7882B U.S. PATENT # D728,554
• ISO DIN radio provision with pocket
Note: This kit will not retain the i-MID display
• A) Radio trim panel • B) Radio brackets • C) Pocket • D) (3) metal panel clips • E) (3) plastic panel clips
• F) (4) #8 x 3/8” Phillips truss-head screws • G) (13) #8 x 3/8” Phillips pan-head screws
• H) (3) #4 x 3/8” Phillips truss-head screws • I) (2) #8 x 1/2” Phillips pan-head screws
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • Please visit metraonline.com for options
Antenna Adapter: • 40-HD11
• Panel removal tool • Phillips screwdriver • 8mm socket wrench
TOOLS REQUIRED
A B C D E
H
F
I
G
Dash Disassembly ..................................................2
Kit Preparation ........................................................3
Kit Assembly
– ISO DIN radio provision with pocket 3 ......................
Table of Contents
99-7882B
®
1.
Open the pocket door below the
radio, remove (2) Phillips screws
exposed, and then remove the
pocket. (Figure A)
2.
Remove (2) Phillips screws from the
bottom edge of the radio. (Figure B)
3. Remove (2) 8mm screws facing
up from inside the pocket cavity.
(Figure C)
4. Unsnap and remove the climate/
radio panel assembly. (Figure D)
5. Remove the components from the
climate/radio panel to be reused in
kit assembly. (Figure E)
a. Remove (4) screws from the
climate control panel.
b. Remove (2) screws from the
factory hazard button.
c. Remove (3) screws from the
factory vent.
d. Remove (3) screws from the
lower trim panel.
Continue to kit preparation
Dash Disassembly
(Figure E)
(Figure A)
(Figure B)
(Figure C)
(Figure D)
Step 5 a
Step 5 b
Step 5 c
Step 5 d
99-7882B
®
Kit Preparation Kit Assembly
(Figure A)
(Figure A)
(Figure B)
1.
Secure the factory components removed in dash disassembly to the . Except for the radio panel
(3) screws to secure the lower trim panel, either the factory screws or the (9) #8 x 3/8” Phillips
pan-head screws supplied with the kit may be used. For the lower trim panel use the (3)
#4 x 3/8” Phillips truss-head screws supplied with the kit to secure it to the panel. (Figure A)
2. Attach the (3) metal and (3) plastic panel clips to the . The factory metal radio panel
clips may be used in place of the metal clips, but not the plastic clips. (Figure A)
Continue to kit assembly
ISO DIN radio provision with pocket
1.
Secure the to the pocket radio brackets
with the (4) #8 x 3/8” Phillips pan-head
screws supplied with the kit. (Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3.
Slide the radio between the bracket/
pocket assembly
and secure it with the
screws supplied with the radio. (Figure B)
4. Secure the completed assembly to
the with the (4) #8 radio trim panel
X 3/8” Phillips truss-head screws
supplied with the kit. (Figure C)
5.
Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or AXXESS. Re-connect the
negative battery terminal and test the
radio for proper operation.
6.
Reassemble the dash in reverse order
of disassembly using the (2) #8 x 1/2”
Phillips pan-head screws supplied
with the kit for the lower radio mounts.
Metal clip locations
Plastic clip
location
Plastic clip
locations
Product specificaties
| Merk: | Metra |
| Categorie: | Carkit |
| Model: | 99-7882B |
Heb je hulp nodig?
Als je hulp nodig hebt met Metra 99-7882B stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Carkit Metra
17 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
23 Augustus 2024
23 Augustus 2024
23 Augustus 2024
23 Augustus 2024
Handleiding Carkit
- Carkit JVC
- Carkit Kenwood
- Carkit Motorola
- Carkit Medion
- Carkit Nokia
- Carkit Pioneer
- Carkit Siemens
- Carkit Alpine
- Carkit Belkin
- Carkit Blaupunkt
- Carkit Boss
- Carkit Brigmton
- Carkit Brodit
- Carkit Bury
- Carkit Dymond
- Carkit Einhell
- Carkit Envivo
- Carkit Gembird
- Carkit Hama
- Carkit HQ
- Carkit Iluv
- Carkit Kensington
- Carkit Kogan
- Carkit Lenco
- Carkit Livoo
- Carkit Manhattan
- Carkit Manta
- Carkit Mr Handsfree
- Carkit MT Logic
- Carkit Nedis
- Carkit Parrot
- Carkit Pyle
- Carkit Renegade
- Carkit Renkforce
- Carkit Silvercrest
- Carkit Sony Ericsson
- Carkit SuperTooth
- Carkit Technaxx
- Carkit Thule
- Carkit TomTom
- Carkit Trust
- Carkit Uniden
- Carkit Veho
- Carkit Jabra
- Carkit Jensen
- Carkit B-Speech
- Carkit BeeWi
- Carkit Caliber
- Carkit Exibel
- Carkit T'nB
- Carkit Hamron
- Carkit Clarion
- Carkit Cobra
- Carkit Arkon
- Carkit Scosche
- Carkit WAGAN
- Carkit Havis
- Carkit I-Tec
- Carkit BlueAnt
- Carkit SBS
- Carkit Cellular Line
- Carkit PAC
- Carkit KRAM
- Carkit NAV-TV
- Carkit Ergotron
- Carkit Konig & Meyer
- Carkit Alpin
- Carkit Novus
- Carkit Foliatec
- Carkit THB
- Carkit Perfect Choice
- Carkit SiriusXM
Nieuwste handleidingen voor Carkit
17 November 2024
15 November 2024
30 Juli 2024
30 Juli 2024
19 Juni 2024
27 Mei 2024
27 Mei 2024
27 Mei 2024
27 Mei 2024
27 Mei 2024