Martin MAC 350 Entour Handleiding

Martin Niet gecategoriseerd MAC 350 Entour

Lees hieronder de 📖 handleiding in het Nederlandse voor Martin MAC 350 Entour (48 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 158 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/48
MAC 350 Entour
user manual
TM
Dimensions
All dimensions are in millimeters
©2010-2012 Martin Professional A/S. Information subject to change without notice. Martin Professional A/S and all affiliated compa-
nies disclaim liability for any injury, damage, direct or indirect loss, consequential or economic loss or any other loss occasioned by
the use of, inability to use or reliance on the information contained in this manual. The Martin logo, the Martin name and all other
trademarks in this document pertaining to services or products by Martin Professional A/S or its affiliates and subsidiaries are trade-
marks owned or licensed by Martin Professional A/S or its affiliates or subsidiaries. The use of certain patents in Martin™ MAC 350
Entour™ products is licensed by Color Kinetics, Inc. (see details printed on product).
P/N 35000242, Rev. H
Safety Information
The following symbols are used to identify important safety information on the product and in this manual:
.WARNING! Risk Group 3 LED product according to EN 62471. Do not look into the beam at a
distance of less than 8.7 meters (28 ft. 7 ins.) from the front surface of the product. Do not view the
light output with optical instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire and burn hazards, electric shock and falls.
Read this manual before installing, powering or servicing the fixture, follow the safety precautions listed
below and observe all warnings in this manual and printed on the fixture. If you have questions about how to
operate the fixture safely, please contact your Martin supplier or call the Martin 24-hour service hotline on
+45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
Disconnect the fixture from AC power before removing or installing any cover or part – including fuses –
and when not in use.
The fixture has double-pole/neutral fusing. If it is not completely disconnected from AC power, parts of the
fixture may remain live even if one of the two mains fuses has blown.
Always ground (earth) the fixture electrically.
Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
Connect the fixture to AC power using a listed, 3-conductor, minimum 1.5 mm2 or 16 AWG cable that is
rated minimum 10 amp, hard usage. Suitable cable jacket types include SJT, ST, STW, SEO, SEOW and
STO.
Before using the fixture, check that all power distribution equipment and cables are in perfect condition
and rated for the current requirements of all connected devices.
Isolate the fixture from power immediately if any power connector, power cable, seal, cover or other
component is damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power
until repairs have been completed.
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product.
WARNING!
Safety hazard.
Risk of severe
injury or death.
WARNING!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
WARNING!
Fire hazard.
WARNING!
Burn hazard. Hot
surface. Do not
touch.
WARNING!
LED Light
emission. Risk of
eye injury.
WARNING!
Refer to user
manual.


Product specificaties

Merk: Martin
Categorie: Niet gecategoriseerd
Model: MAC 350 Entour

Heb je hulp nodig?

Als je hulp nodig hebt met Martin MAC 350 Entour stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Martin

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd