Martin Exterior 400 Image Projector Handleiding

Martin Niet gecategoriseerd Exterior 400 Image Projector

Lees hieronder de 📖 handleiding in het Nederlandse voor Martin Exterior 400 Image Projector (44 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/44
user manual
Exterior 400
Image Projector™
Dimensions
All dimensions are in millimeters
234
365
320
335
421
307
290
380
425
421
Narrow-angle models (long barrel)
©2011-2012 Martin Professional A/S. Information subject to change without notice. Martin Professional A/S and all affiliated
companies disclaim liability for any injury, damage, direct or indirect loss, consequential or economic loss or any other loss
occasioned by the use of, inability to use or reliance on the information contained in this manual. The Martin logo, the Martin name
and all other trademarks in this document pertaining to services or products by Martin Professional A/S or its affiliates and
subsidiaries are trademarks owned or licensed by Martin Professional A/S or its affiliates or subsidiaries. The use of certain patents
in Martin Exterior 400 Image Projector Color Kinetics, Inc. (see details printed on product).products is licensed by
P/N 35000256, Rev. E
Safety Information
The following symbols are used to identify important safety information on the product and in this manual:
WARNING! Risk Group 2 LED product according to EN 62471. Do not look into the beam at a
distance of less than 8.3 m (27.3 ft.) from the front surface of the product. Do not view the light
output with optical instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire hazards, electric shock and falls.
Read this manual before installing, powering or servicing the fixture, follow the safety precautions listed
below and observe all warnings in this manual and printed on the fixture. Install and operate the fixture only
as described in this manual and in accordance with local laws and regulations. Refer any operation not
described in this manual to an authorized Martin Service partner.
Terminal block not included.
Installation may require advice from a qualified person.
If you have any questions about how to install or operate the fixture safely, please contact your Martin
supplier or call the Martin 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Shut down power to the entire installation at the main power distribution board and ensure that it cannot
be reapplied, deliberately or accidentally, before carrying out any installation or maintenance work.
• Disconnect the fixture from AC power before removing or installing any cover or part and when not in use.
• Connect the fixture electrically to ground (earth).
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• Connect the fixture to AC power using the supplied power cable only. The power and data cables supplied
with the fixture may only be replaced by Martin Professional or its authorized agents. If either of the
supplied cables is in any way unsuitable, contact Martin Professional for assistance.
• Before using the fixture, check that all power distribution equipment and cables are in perfect condition,
are rated for the current requirements of all connected devices, are protected to IP67 or higher and are of
suitable type for the location (including water, pollution, temperature and UV resistance).
• Isolate the fixture from power immediately if any cable, seal, cover or other component is damaged,
cracked, deformed or shows signs of overheating. Contact Martin Professional for assistance and do not
reapply power until repairs have been completed.
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product.
WARNING!
Safety hazard.
Risk of severe
injury or death.
WARNING!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
WARNING!
LED light
emission. Risk
Group 2 LED
product
according to EN
62471.
WARNING!
Fire hazard.
WARNING!
Refer to user
manual.

Product specificaties

Merk: Martin
Categorie: Niet gecategoriseerd
Model: Exterior 400 Image Projector

Heb je hulp nodig?

Als je hulp nodig hebt met Martin Exterior 400 Image Projector stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Martin

Martin

Martin Exterior Dot-1 Pro Handleiding

25 September 2024
Martin

Martin Exterior Dot-9 Pro Handleiding

24 September 2024
Martin

Martin DCE PSU 240 IP Handleiding

23 September 2024
Martin

Martin P3 PowerPort 500 IP Rental Handleiding

23 September 2024
Martin

Martin DCE Data Splitter/Booster IP Handleiding

23 September 2024
Martin

Martin P3 PowerPort 2000 Handleiding

23 September 2024
Martin

Martin P3 PowerPort 500 IP Install Handleiding

23 September 2024
Martin

Martin Acrobat Handleiding

21 Juni 2024
Martin

Martin CI6 Ð 100V Handleiding

21 Juni 2024
Martin

Martin Exterior 400 Image Projector Handleiding

10 Juni 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Protector

Protector AS-5030.3 V2 Handleiding

21 December 2024
Sabrent

Sabrent AU-MMCW Handleiding

21 December 2024
Sabrent

Sabrent AU-2X35 Handleiding

21 December 2024
Sabrent

Sabrent CB-RS232 Handleiding

21 December 2024
Owon

Owon 500W Handleiding

21 December 2024
Owon

Owon 300W Handleiding

21 December 2024
Sabrent

Sabrent SB-RKTQ4-1TB Handleiding

21 December 2024
Sabrent

Sabrent SB-RKTQ-1TB Handleiding

21 December 2024
Sabrent

Sabrent SB-ROCKET-1TB Handleiding

21 December 2024
Sabrent

Sabrent SB-HTSS Handleiding

21 December 2024