Lowepro DryZone Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Lowepro DryZone (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
DRYZONE User’s Guide
C A R E
1. Rinse off pod [a] and outer pack [b] with fresh water after
each exposure to salt water and contaminants. Sponge off
dirt with mild soap and water. See photo 1
2. If the TIZIP is over-stressed during closure, the
zipper may separate. If this happens, move the
slider back, reduce the cross tension, then re-close.
The waterproofness of the TIZIP will be
compromised if the zipper is bent, damaged,
dirty or not fully closed.
If the DryZone is used to protect sensitive equipment, the
sealing function should be double-checked prior to usage. To ensure your DryZone
does not leak, follow these guidelines:
• The head of the zipper must be completely pulled to the end into its locked position.
• The zipper must be sufficiently lubricated before use. See lubrication instructions for
details.
• Do not distort the zipper.
• Keep the zipper clean.
• The DryZone is waterproof but NOT intended to be submerged for any period of time.
• Do not use the DryZone as a personal flotation device.
• Additional lubrication can be found at many outdoor and diving equipment stores.
• Contact Lowepro customer service at info@lowepro.com for additional information.
T I Z I P ®M A I N T E N A N C E
Regular maintenance with TIZIP lubricant is necessary for long-term performance.
Follow steps 1-9, as shown, to properly lubricate the TIZIP. To protect the pod
while lubricating the TIZIP, place a cloth between the TIZIP and the pod.
TIZIP
LUBRICATION
STEPS 1-9
b
a
Photo 1
Over >>
1. To properly fit the backpack, loosen all the straps and place
the backpack on your back. Fasten the waistbelt and tighten
so that it rests comfortably on your hips.
See photo 2
2. Tighten the shoulder straps so the bag hangs comfortably.
3. The height of the shoulder harness is adjustable for different
torso lengths. The shoulder harness is attached to an
adjustable “torso plate” that moves up and down behind
the DryFlo™ mesh back pad. (DryZone 200 only)
Loosen the load adjustment straps. See photo 3
To adjust to proper height, run your hand down the length
and width of the hook and loop panels to separate. Keep
one hand in place between the panels and move the “torso
plate” up or down.
The stitching on the torso plate should not be
higher than the top of the back pad. See photo 4
F I N E - T U N I N G T H E L O A D
1. Tighten the shoulder straps to transfer a portion of the
weight to your shoulders.
2. Tighten the load adjustment straps to bring the pack closer
to your shoulder and to stabilize the load. You can adjust
the weight distribution to your personal preference while
wearing the pack. See photo 3 above
3. Connect and tighten the sternum strap. You can change the
vertical position so that the strap fits comfortably across
your chest. The sternum strap reduces shoulder fatigue and
increases mobility by pulling the shoulder straps inward.
See photo 5
T H E H I D D E N T R I P O D H O L D E R
1. Pull the rip-cord on the bottom of the pack to extend the
tripod holder. See photo 6
2. Unclip the quick release buckles.
3. Insert two of the tripod’s legs into the tripod holder.
[a] See photo 7
4. Fasten the tripod to the front of the DryZone with the
quick-release buckles and tie-down bungee cords.
[b] See photo 7
5. Tighten the bungee cords by pulling the cord locks.
DRYZONE
a
b
Photo 4Photo 5Photo 6
Photo 7 Photo 3
DZUG-1102
A D J U S T I N G T H E B A C K P A C K
Photo 2


Product specificaties

Merk: Lowepro
Categorie: Niet gecategoriseerd
Model: DryZone

Heb je hulp nodig?

Als je hulp nodig hebt met Lowepro DryZone stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Lowepro

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd