Konig DL-QUAKE250 Handleiding

Konig Effect machine DL-QUAKE250

Lees hieronder de 📖 handleiding in het Nederlandse voor Konig DL-QUAKE250 (77 pagina's) in de categorie Effect machine. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/77

DL-QUAKE250

MANUAL (p. 2)

Light xture Quake 250W

MODE D’EMPLOI (p. 14)

Jeu de lumières Quake 250 W

MANUALE (p. 26)

Luminaria Quake 250W

BRUKSANVISNING (s. 51)

Belysningsarmatur Quake 250W

MANUAL DE UTILIZARE (p. 63)

Corp de iluminat Quake 250W

HASZNÁLATI ÚTMUTATÓ (o. 39.)

250 W-os Quake vetítő

KÄYTTÖOHJE (s. 45)

Quake 250W valolaite

GEBRUIKSAANWIJZING (p. 20)

Verlichtingsarmatuur Quake 250W

ANLEITUNG (s. 7)

Lichteffekt Quake 250W

MANUAL DE USO (p. 33)

Dispositivo luminoso Quake 250W

NÁVOD K POUŽITÍ (s. 57)

Světelná konstrukce Quake 250W

ΕΓΧΕΙΡΙΔΙΟ XPHΣHΣ (σελ. 70)

Συσκευή Φωτισμού Quake 250W

DL-QUAKE250_A5.indd 1 2009.9.1 9:33:30 AM

ENGLISH

INTRODUCTION:

This advanced DMX controllable multi-color light effect has 12 different rotating gobo patterns and a

special feature called gobo shaking. The 250W halogen lamp ensures a room lling effect. This light

effect is ideal for permanent installation or mobile use

IMPORTANT INFORMATION BEFORE USE:

The QUAKE250 is not for household use. It is not a toy: it presents risks of serious injury due to

electric shock, high heat, and intense light. For safe operation, read this manual before using the

xture and observe all warnings and precautions printed here and on the xture. If you have questions

about how to operate the xture safely, please contact your König distributor or dealer.

Precautions:

• For protection against dangerous electric shock, the xture must be grounded (earthed). The AC

mains supply shall be tted with a fuse or circuit breaker and ground-fault protection.

• The xture operating voltage is printed on the rating label. Verify that the operating voltage closely

matches the AC supply voltage before connecting the xture. Do not connect the xture if the

voltage on the label differs from the AC mains voltage by more than ve percent.

• Verify that all used power cables are undamaged and rated for the current requirements of all

connected devices before use.

• There are no user serviceable parts inside except the lamp. Refer all service to a qualied

technician.

• Replace the lamp if it becomes defective or worn out. Allow the xture to cool for 15 minutes before

installing a new lamp and make sure the xture is disconnected from the AC mains supply.

• Keep all combustible materials (for example fabric, wood, paper) at least 50cm (20 inches) away

from the xture. Keep ammable materials well away from the xture.

• Provide a minimum clearance of 10cm (4 inches) around the fan and air vents.

• When suspending the xture above ground level, verify that the structure can hold at least 10 times

the weight of all installed devices and secure the xture with an approved safety cable. Block

access below the work area whenever installing or removing the xture.

• When carrying the xture, lock the mounting bracket securely and do not touch the lens or mirrors.

• Do not expose the xture to rain or moisture.

• Do not illuminate surfaces within 1 meter (39 inches) of the xture.

• Do not operate the xture if the ambient temperature exceeds 40°C (104°F).

• Never place lters or other objects over the lens or mirrors.

Important! Electric dimmers may damage the electronic components.

Although the QUAKE250 cannot be dimmed, it may be switched on and off remotely using switch

packs or the full-on and full-off levels on dimmer packs.

INSTALLATION:

The best way to hang the QUAKE250 is to use a rigging clamp. Bolt the clamp securely to the

mounting bracket. Verify that the structure can hold at least 10 times the weight of all installed devices

and secure the xture with an approved safety cable. Change to the desired angle by adjusting the

mounting bracket and tighten both swivel locks.

Install the xture at least 50cm (20 inches) away from combustible materials. Keep ammable

materials well away from the xture. Make sure the xture does not illuminate surfaces within 1 meter

(39 inches).

To ensure maximum lamp life, provide a minimum clearance of 10cm (4 inches) around the fan and air

vents. Make sure the ambient temperature will not exceed 40°C (104°F) and do not place the xture

on or nearby a loudspeaker.

DL-QUAKE250_A5.indd 2 2009.9.1 9:33:30 AM

OPERATION:

Read “IMPORTANT INFORMATION BEFORE USE” rst and verify all precautions are fullled before

operating.

Make sure the correct lamp is installed, read “SERVICE” how to (re)place the lamp.

Although the QUAKE250 cannot be dimmed, it may be switched on and off remotely using switch

packs or the full-on and full-off levels on dimmer packs. Disconnect the xture from AC power when

not in use.

The QUAKE250 has an advanced control panel. To set the desired function please read the following

instructions carefully.

Power

DMX

Up Down

Enter

Sound

Control panel

DMX address setting:

1. Press Menu button to access address code setting menu

Axxxx

2. Press UP or DOWN button to set the

DMX address code.

3. Press ENTER button to save the update

DMX address code.

Address code setting range

A001-A512

Test program:

Press Menu button to access the test program, select the menu

TEST and press

ENTER button to

save the setting, the LCD display ashes.

Press Menu button to exit this scene.

Mode setting:

Press Menu button to acces the menu Mode and press ENTER button to save the setting.

Press UP or DOWN button to select the mode of

Auto or Sond or dMH.

Press ENTER button to save the setting.

Press Menu button to upgrade the menu.

Auto Automatic mode

Sond Sound activity mode (w/o sound triggering will be black out)

dMH DMX mode

Sound Activity Sensitivity Setting:

Press Menu button to access the menu

SEnS

Press UP or DOWN to select the sound sensitivity (range: 0-99)

Press ENTER to save the setting.

Note: If the unit is in Master/Slave or Sound mode without any (music) triggering for 60 seconds, then

the unit will switch to black out mode.

DL-QUAKE250_A5.indd 3 2009.9.1 9:33:30 AM

Product specificaties

Merk:	Konig
Categorie:	Effect machine
Model:	DL-QUAKE250
Kleur van het product:	Zwart
Gewicht:	4300 g
Vermogen lamp:	250 W
Ingangsspanning:	230 V
Fitting/voet-type:	GX5.3
Frequentie:	50 - 60 Hz
Afmetingen (B x D x H):	365 x 365 x 195 mm