Kitronik 2163 Handleiding

Kitronik Niet gecategoriseerd 2163

Lees hieronder de 📖 handleiding in het Nederlandse voor Kitronik 2163 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 31 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

LEARN TO SOLDER CLASS PACK

DEVELOP YOUR SOLDERING SKILLS WITH THIS

ESSENTIAL INFORMATION

BUILD INSTRUCIONS

HOW THE KIT WORKS

Version 1.0

Learn to Solder

www.kitronik.co.uk/2163

Build Instructions

Before you start, take a look at the Printed Circuit Board (PCB). The components go in the side with the writing on

and the solder goes on the side with the tracks and silver pads.

Start with the resistor R1. The text on the PCB shows where R1 should go. It doesn’t matter which

way around the resistor goes into the board. Solder the resistor, remembering to trim the legs

afterward.

Repeat with R2, R3 and R4.

PCB

Ref

Value

Colour Bands

,R2, R3, R4

Brown,

black

, b

rown

Check there is a component in each place indicated on the PCB.

Check all the solder joints are good.

Place the PCB on a PP3 battery.

Check the LED lights up.

PLACE THE LED

INSPECT YOUR

WORK

TEST YOUR WORK

Solder the LED. Ensure that the positive leg is inserted into the correct hole.

The positive leg is the longer one. Use the PCB markings to help.

PLACE RESISTORS

Learn to Solder

www.kitronik.co.uk/2163

Checking Your Learn to Solder PCB

 Check the solder joints are all good.

 Is the LED correct way round?

How the Learn to Solder PCB Works

The circuit diagram for the Learn to Solder PCB is shown above. It is a very simple circuit. The 9V battery that powers

the circuit is connected via the PCB pads.

LEDs can be damaged if the current through them is not limited.

With a 9V battery, and forward voltage drop of 2.1V on the LED, a 400 Ω current limiting resistor will give a current

of 17.5mA. The LED specification is maximum current of 25mA, so the LED will light with good brightness.

The resistance has been split to give 8 solder joints to practice, rather than 2. The 4 100Ω resistors in series add up

to 400 Ω.

Product specificaties

Merk:	Kitronik
Categorie:	Niet gecategoriseerd
Model:	2163
Kleur van het product:	Groen
Breedte:	21 mm
Diepte:	31 mm
Hoogte:	1.5 mm
Land van herkomst:	Verenigd Koninkrijk
Ingangsspanning:	9 V
LED kleur:	Rood
Type product:	Breadboard Printed Circuit Board (PCB) kit
Weerstanden inbegrepen:	Ja
Breadboard:	Ja