Kicker ZX350.4 Handleiding

Kicker Autoradio ZX350.4

Lees hieronder de šŸ“– handleiding in het Nederlandse voor Kicker ZX350.4 (28 pagina's) in de categorie Autoradio. Deze handleiding was nuttig voor 16 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/28
ZX AMPLIFIER
ZX350.4
ZX650.4
English Version
VersiĆ³n EspaƱol
Amplificador del la Serie ZX.4
Deutsche Version
StereoverstƤrker der ZX.4-Serie
Version Francaise
Amplificateur de sƩrie ZX.4
LIVINā€™ LOUD
2011 ZX 350.4 650.4 RevC.indd 1
2011 ZX 350.4 650.4 RevC.indd 1
2011 ZX 350.4 650.4 RevC.indd 1
2011 ZX 350.4 650.4 RevC.indd 12011 ZX 350.4 650.4 RevC.indd 1 11/5/2010 1:13:34 PM
11/5/2010 1:13:34 PM
11/5/2010 1:13:34 PM
11/5/2010 1:13:34 PM11/5/2010 1:13:34 PM
2ZX AMPLIFIERS
ZX.4-SERIES AMPLIFIERS Ownerā€™s Manual
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER ampliļ¬ er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4ā€ (10cm) of open
ventilation for the ampliļ¬ er. If possible, mount the ampliļ¬ er in the climate-controlled passenger compartment. Drill
four holes using a 7/64ā€ (3mm) bit and use the supplied #8 screws to mount the ampliļ¬ er.
Wiring: Disconnect the vehicleā€™s battery to avoid an electrical short. Then, connect the ground wire to the
ampliļ¬ er. Make the ground wire short, 24ā€ (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicleā€™s chassis. Adding an additional ground wire of this same gauge (or larger) between the
batteryā€™s negative post and the vehicle chassis is recommended.
The ZX ampliļ¬ er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereoā€™s source unit. A high-level signal can be run from the source unitā€™s speaker outputs to the
stereo RCA input on the end panel of the ampliļ¬ er using the KICKER ZISL as shown (make sure you set the ZX
ampliļ¬ erā€™s input level switch to ā€œHIā€). Alternatively, the signal can be delivered to the ampliļ¬ er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the ampliļ¬ er to ā€œLOā€. Keep the
audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring,
cross it at a 90 degree angle.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
Model: ZX350.4 ZX650.4
RMS Power, all channels driven
@ 14.4V, 4 stereo, 1% THD+NĪ©ļ‚£
@ 14.4V, 2 stereo, 1% THD+NĪ©ļ‚£
@ 14.4V, 4 mono, 1% THD+NĪ©ļ‚£
60W x 4
90W x 4
175W x 2
120W x 4
160W x 4
325W x 2
Length 13-1/2ā€ (342mm) 20ā€ (507mm)
Speciļ¬ cations common to all models:
Height 2-1/8ā€ (54mm)
Width 9-5/8ā€ (244mm)
Frequency Response Ā± 1dB 20Hzā€“20kHz
Signal-to-noise Ratio >95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mVā€“5V
High Level: 250mVā€“10V
Selectable Electronic Crossover Variable HI, LO, or OFF (bypass) | 50ā€“200Hz, 12dB/octave
Bass Boost Variable 0ā€“18dB @ 40Hz
Pro Tip: To get the best performance from your new KICKER Ampliļ¬ er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
MODEL: ZX350.4 / ZX650.4
2011 ZX 350.4 650.4 RevC.indd 2
2011 ZX 350.4 650.4 RevC.indd 2
2011 ZX 350.4 650.4 RevC.indd 2
2011 ZX 350.4 650.4 RevC.indd 22011 ZX 350.4 650.4 RevC.indd 2 11/5/2010 1:13:53 PM
11/5/2010 1:13:53 PM
11/5/2010 1:13:53 PM
11/5/2010 1:13:53 PM11/5/2010 1:13:53 PM
3
Model External Fuse Power/Ground Wire KICKER Wiring Kit
ZX350.4 1 x 60 Ampere 8 Gauge PK8, CK8, ZCK8
ZX650.4 1 x 100 Ampere 4 Gauge PK4, CK4, ZCK4
source unit
high-level speaker
outputs
to ampliļ¬ er
shield
+
ā€“
core conductor
GND REM +12V
12V
battery
external fuse
protection LED
remote turn-on
(see page 5)
bare-metal
chassis ground
ļ‚£18ā€
(45cm)
ļ‚£24ā€
(60cm)
AMP1
AMP1
L+ L- R+ R-
AMP2
L+ L- R+ R-
L+ BRIDGE WIRING R-
AMP2
L LR R
L+ L- R+ R- L+ L- R+ R-
signal in
FOUR CHANNEL OPERATION
minimum impedance of 2 ohms per channel
Install a fuse within 18ā€ (45cm) of the battery and in-line with the power cable connected to your ampliļ¬ er. If you
ever need to remove the ampliļ¬ er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the ampliļ¬ er--just the opposite as when you installed it.
KICKER ZISL
source unit high-level
speaker outputs
OR to ampliļ¬ er
2011 ZX 350.4 650.4 RevC.indd 3
2011 ZX 350.4 650.4 RevC.indd 3
2011 ZX 350.4 650.4 RevC.indd 3
2011 ZX 350.4 650.4 RevC.indd 32011 ZX 350.4 650.4 RevC.indd 3 11/5/2010 1:13:54 PM
11/5/2010 1:13:54 PM
11/5/2010 1:13:54 PM
11/5/2010 1:13:54 PM11/5/2010 1:13:54 PM


Product specificaties

Merk: Kicker
Categorie: Autoradio
Model: ZX350.4

Heb je hulp nodig?

Als je hulp nodig hebt met Kicker ZX350.4 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Autoradio Kicker

Handleiding Autoradio

Nieuwste handleidingen voor Autoradio