Kicker CX300.4 Handleiding

Kicker Autoradio CX300.4

Lees hieronder de šŸ“– handleiding in het Nederlandse voor Kicker CX300.4 (32 pagina's) in de categorie Autoradio. Deze handleiding was nuttig voor 37 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/32
Ownerā€™s Manual |
Manual del Propietario |
Benutzerhandbuch |
Manuel dā€™utilisation |
CX Amplifiers
2012 CX 4 Channel Amps Rev F indd 1
2
CX.4-SERIES AMPLIFIERS
OWNERā€™S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER ampliļ¬ er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4ā€ (10cm) of open
ventilation for the ampliļ¬ er. If possible, mount the ampliļ¬ er in the climate-controlled passenger compartment. Drill
four holes using a 7/64ā€ (3mm) bit and use the supplied #8 screws to mount the ampliļ¬ er.
The KICKER CX Ampliļ¬ ers are capable of space-saving vertical mounting. Use a 2.5mm hex key (Allen wrench)
to loosen the endpanel, remove the existing brackets, then insert and tighten the double-slotted brackets to the
ampliļ¬ er as illustrated on the next page.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Serial Number:
Model: CX300.4
RMS Power
@ 14.4V, 4 stereo, 1% THD+Nļ— ļ‚£
@ 14.4V, 2 stereo, 1% THD+Nļ— ļ‚£
@ 14.4V, 4 bridged, 1% THD+Nļ— ļ‚£
40W x 4
75W x 4
150W x 2
Length | in. [mm] 12-7/16 [320]
Height | in. [mm] 2-3/8 [60]
Width | in. [mm] 7-3/16 [180]
Frequency Response Ā± 1dB 10Hzā€“20KHz
Signal-to-noise Ratio >95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mVā€“5V
High Level: 250mVā€“10V
Electronic Crossover Selectable: HI, LO or OFF; Variable 50ā€“200Hz @ 12dB/Octave
Bass Boost Variable 0ā€“12dB @ 40Hz
Pro Tip: To get the best performance from your new KICKER Ampliļ¬ er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
MODEL: CX300.4
2012 CX 4 Channel Amps Rev F indd 2
3
Wiring: Disconnect the vehicleā€™s battery to avoid an electrical short. Then, connect the ground wire to the
ampliļ¬ er. Make the ground wire short, 24ā€ (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicleā€™s chassis. Adding an additional ground wire of this same gauge (or larger) between the
batteryā€™s negative post and the vehicle chassis is recommended.
The CX ampliļ¬ er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereoā€™s source unit. A high-level signal can be run from the source unitā€™s speaker outputs to the
stereo RCA input on the end panel of the ampliļ¬ er using the KICKER ZISL as shown (make sure you set the CX
ampliļ¬ erā€™s input level switch to ā€œHIā€). Alternatively, the signal can be delivered to the ampliļ¬ er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the ampliļ¬ er to ā€œLOā€. Keep the
audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring,
cross it at a 90 degree angle.
source unit
high-level speaker
outputs
to ampliļ¬ er
shield
+
ā€“
core conductor KICKER ZISL
source unit high-level
speaker outputs
OR to ampliļ¬ er
double-slotted
bracket
hex screws
ampliļ¬ er side panel
VERTICAL MOUNTING
Install a fuse within 18ā€ (45cm) of the battery and in-line with the power cable connected to your ampliļ¬ er. If you
ever need to remove the ampliļ¬ er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the ampliļ¬ er--just the opposite as when you installed it.
+
+
ā€“
ā€“
2012 CX 4 Channel Amps Rev F indd 3


Product specificaties

Merk: Kicker
Categorie: Autoradio
Model: CX300.4

Heb je hulp nodig?

Als je hulp nodig hebt met Kicker CX300.4 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Autoradio Kicker

Handleiding Autoradio

Nieuwste handleidingen voor Autoradio