Kenwood KVT-514 Handleiding

Kenwood DVD speler KVT-514

Lees hieronder de 📖 handleiding in het Nederlandse voor Kenwood KVT-514 (33 pagina's) in de categorie DVD speler. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/33
© B54-4697-00/00 (KW/RW)
KVT-514
KVT-534DVD
MONITOR WITH DVD RECEIVER
INSTALLATION MANUAL
MONITEUR AVEC RÉCEPTEUR DVD
MANUEL D'INSTALLATION
MONITOR CON RECEPTOR DVD
MANUAL DE INSTALACIÓN
2 | KVT-514/KVT-534DVD
Accessories
1
..........1
2
..........1
3
..........2
4
..........1
5
..........4
6
..........4
English | 3
Installation Procedure
1. To prevent a short circuit, remove the key from the
ignition and disconnect the - battery.
2. Make the proper input and output wire
connections for each unit.
3. Connect the speaker wires of the wiring harness.
4. Connect the wiring harness wires in the following
order: ground, battery, ignition.
5. Connect the wiring harness connector to the unit.
6. Install the unit in your car.
7. Reconnect the - battery.
8. Press the reset button.
2WARNING
• If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
2CAUTION
• Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and shortly
after the use of the unit. Metal part such as the heat sink
and enclosure become hot.
¤
• Mounting and wiring this product requires skills and
experience. For safety’s sake, leave the mounting and wiring
work to professionals.
• Make sure to ground the unit to a negative 12V DC power
supply.
• Do not install the unit in a spot exposed to direct sunlight
or excessive heat or humidity. Also avoid places with too
much dust or the possibility of water splashing.
• Do not use your own screws. Use only the screws provided.
If you use the wrong screws, you could damage the unit.
• If the power is not turned ON (“PROTECT” is displayed),
the speaker wire may have a short-circuit or touched the
chassis of the vehicle and the protection function may
have been activated. Therefore, the speaker wire should be
checked.
• If your car’s ignition does not have an ACC position, connect
the ignition wires to a power source that can be turned on
and off with the ignition key. If you connect the ignition
wire to a power source with a constant voltage supply, as
with battery wires, the battery may die.
• If the console has a lid, make sure to install the unit so that
the faceplate will not hit the lid when closing and opening.
• If the fuse blows, first make sure the wires aren’t touching
to cause a short circuit, then replace the old fuse with one
with the same rating.
• Insulate unconnected wires with vinyl tape or other similar
material. To prevent a short circuit, do not remove the caps
on the ends of the unconnected wires or the terminals.
• Connect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or fail to
work if you share the wires or ground them to any metal -
part in the car.
• When only two speakers are being connected to the
system, connect the connectors either to both the front
output terminals or to both the rear output terminals (do
not mix front and rear). For example, if you connect the +
connector of the left speaker to a front output terminal, do
not connect the connector to a rear output terminal.-
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Mount the unit so that the mounting angle is 30° or less.
• This unit has the cooling fan (page 5) to decrease the
internal temperature. Do not mount the unit in a place
where the cooling fan of the unit are blocked. Blocking
these openings will inhibit the cooling of the internal
temperature and result in malfunction.

Product specificaties

Merk: Kenwood
Categorie: DVD speler
Model: KVT-514

Heb je hulp nodig?

Als je hulp nodig hebt met Kenwood KVT-514 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding DVD speler Kenwood

Kenwood

Kenwood DVF-3400-S Handleiding

24 Mei 2023
Kenwood

Kenwood DDX26BT Handleiding

10 Mei 2023
Kenwood

Kenwood Excelon DDX9906XR Handleiding

5 Mei 2023
Kenwood

Kenwood DDX418 Handleiding

1 Mei 2023
Kenwood

Kenwood KVT-514 Handleiding

25 April 2023
Kenwood

Kenwood DVF-3400-B Handleiding

23 April 2023
Kenwood

Kenwood DDX276BT Handleiding

14 April 2023
Kenwood

Kenwood DDX5707S Handleiding

3 April 2023
Kenwood

Kenwood eXcelon DNX9960 Handleiding

13 Maart 2023
Kenwood

Kenwood DVF-5500-B Handleiding

6 Februari 2023

Handleiding DVD speler

Nieuwste handleidingen voor DVD speler

Nextbase

Nextbase Piqo Handleiding

7 December 2024
Philips

Philips MCD113 Handleiding

6 December 2024
Philips

Philips PET723/12 Handleiding

3 December 2024
Philips

Philips PET731/12 Handleiding

3 December 2024
LG

LG DVD4950 Handleiding

25 November 2024
Philips

Philips MCD755 Handleiding

24 November 2024
Philips

Philips DVP3006 Handleiding

24 November 2024
Philips

Philips DVP3003 Handleiding

24 November 2024
Philips

Philips MCD710B Handleiding

24 November 2024
Philips

Philips PET719 Handleiding

23 November 2024