JVC GVSP2 Handleiding
JVC
Fotoprinter
GVSP2
Lees hieronder de đź“– handleiding in het Nederlandse voor JVC GVSP2 (36 pagina's) in de categorie Fotoprinter. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/36
GV-SP2
DIGITAL SYSTEM PRINTER
LYT0546-001A
INSTRUCTIONS
ENGLISH
EN
Dear Customer,
Thank you for purchasing this Digital System Printer. Before use, please read the
safety information and precautions contained in the following pages to ensure safe
use of this product.
i
Using This Instruction Manual
•All major sections and subsections are
listed in the Table Of Contents
(Z pg. 4).
•Notes appear after most subsections. Be
sure to read these as well.
•Basic and advanced features/operation
are separated for easier reference.
It is recommended that you . . .
... refer to “Controls, Indicators and
Connectors” (Z pg. 5) and familiarize
yourself with button locations, etc.
before use.
... read thoroughly the Safety Precautions
and Safety Instructions that follow.
They contain extremely important
information regarding the safe use of
your new Digital System Printer.
Power Save Mode
1. To put the printer in power save
mode, hold down the STANDBY/ON
button for several seconds while
the printer’s power is off.
2. During power save mode, printer’s
power will automatically be turned off
if the printer is not used for a while.
3. To print again after the printer’s power
has been automatically turned off,
press the power button once and the
power will come back on.
4. To put the printer in power save mode
back again, repeat step 1.
You are recommended to carefully
read the cautions on page 3 before
use.
When the equipment is installed in a
cabinet or on a shelf, make sure that it
has sufficient space on all sides to allow
for ventilation (10 cm or more on both
sides, on top and at the rear).
Do not block the ventilation holes.
(If the ventilation holes are blocked by a
newspaper, or cloth etc. the heat may not
be able to get out.)
No naked flame sources, such as lighted
candles, should be placed on the
apparatus.
When discarding batteries, environmental
problems must be considered and the
local rules or laws governing the disposal
of these batteries must be followed
strictly.
The apparatus shall not be exposed to
dripping or splashing.
Do not use this equipment in a bathroom
or places with water.
Also do not place any containers filled
with water or liquids (such as cosmetics
or medicines, flower vases, potted plants,
cups etc.) on top of this unit.
(If water or liquid is allowed to enter this
equipment, fire or electric shock may be
caused.)
EN 1
SAFETY
PRECAUTIONS
WARNING:
TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE
THIS UNIT TO RAIN OR
MOISTURE.
CAUTION
nWhen you are not using the unit for a long
period of time, it is recommended that you
disconnect the power cord from the mains
outlet.
nDangerous voltage inside. Refer internal
servicing to qualified service personnel. To
prevent electric shock or fire hazard, remove
the power cord from the mains outlet prior to
connecting or disconnecting any signal lead
or aerial.
The STANDBY/ON button does not
completely shut off mains power to the unit, but
switches operating current on and off. " "
shows electrical power standby and " " shows
ON.
The mains outlet shall be installed near the unit
and shall be easily accessble.
NOTE:
The rating plate (serial number plate) and safety
caution are on the bottom and/or the back of the main
unit.
IMPORTANT (for U. K. owners)
Connection to the mains supply in the United
Kingdom.
DO NOT cut off the mains plug from this
equipment. If the plug fitted is not suitable for
the power points in your home or the cable is
too short to reach a power point, then obtain a
proper safety approved extension lead/adapter
or consult your dealer.
BE SURE to replace the fuse only with an
identical approved type, as originally fitted,
and to replace the fuse cover.
If nonetheless the mains plug is cut off remove
the fuse and dispose of the plug immediately,
to avoid a possible shock hazard by inadvert-
ent connection to the mains supply.
If this product is not supplied fitted with a
mains plug then follow the instructions given
below:
DO NOT make any connection to the Larger
Terminal coded E or Green.
The wires in the mains lead are coloured in
accordance with the following code:
If these colours do not correspond with the
terminal identifications of your plug, connect
as follows:
Blue wire to terminal coded N (Neutral) or
coloured Black.
Brown wire to terminal coded L (Live) or
coloured Red.
If in doubt — consult a competent electrician.
Brown to L (Live) or
Red
Blue to N (Neutral) or
Black
Product specificaties
| Merk: | JVC |
| Categorie: | Fotoprinter |
| Model: | GVSP2 |
Heb je hulp nodig?
Als je hulp nodig hebt met JVC GVSP2 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Fotoprinter JVC
16 Augustus 2022
26 November 2021
Handleiding Fotoprinter
- Fotoprinter HP
- Fotoprinter Sony
- Fotoprinter Panasonic
- Fotoprinter Epson
- Fotoprinter Canon
- Fotoprinter Olympus
- Fotoprinter Agfa
- Fotoprinter Kodak
Nieuwste handleidingen voor Fotoprinter
21 November 2022
24 Mei 2022
12 Maart 2022
11 April 2022
3 Maart 2022
17 Augustus 2022
11 Maart 2022
15 Augustus 2022
20 Mei 2022
16 Augustus 2022