Jilong JL027296N Handleiding

Jilong luchtbed JL027296N

Lees hieronder de 📖 handleiding in het Nederlandse voor Jilong JL027296N (34 pagina's) in de categorie luchtbed. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/34

Important Safety Guideline

Please read, understand and follow all instructions prior to using.

To enhance the enjoyment of your Air Bed and protect the safety of the operator

using the product, ALWAYS STRICTLY OBSERVE the following important

safety points. The following important points should be read and understand before

using this product:

1. : To prevent possible electric shock, do not attempt to plug in power WARNING

cord with wet hands.

2. : To prevent possible electric shock, connect power cord into a WARNING

grounded receptacle protected by a ground-fault circuit interrupter (GFCI).

3. : To prevent possible electric shock, never use a damaged or frayed WARNING

power cord. If the supply cord is damaged, it must be replaced by the

manufactured or its service agent or a similarly qualiﬁed person in order to avoid

a hazard.

4. : Do not extension power cords with this product. WARNING

5. Only for indoor household use. Keep away from ﬁre. WARNING:

6. In order to reduce the risk of electric shock, do not expose to rain. WARNING:

And store indoors.

7. RISK OF COMBUSTION: Do not place the airbed against or near any open

ﬂames, heaters, furnaces or other hot objects.

8. IMPORTANT: Do not operate electric pump for more than 5 minutes at one

time (Generally, 5 minutes for each inflation or deﬂation is enough), take 20

minutes break between uses, as overheating may occur and pump will

automatically shut oﬀ. It will be ready to use after it has cooled down. This

automatic shut oﬀ is for your safety. Unplug electrical power cord when not in

use.

9. Do not obstruct the air passage opening or insert any objects into WARNING:

the opening at any time.

10. Do not stand, jump or use the airbed as a trampoline. Always WARNING:

supervise children near the airbed.

11. This product is not a raft or ﬂoatation device. Do not use near or WARNING:

on water.

12. Children must not be left unattended when using the airbed. Use WARNING:

only under adult competent supervision.

13. : The storage bag is not a toy. To avoid danger of suﬀocation, keep WARNING

the airbed storage bag or any other bags away from babies and children. Fold up

the bag and store away from children when not in use.

14. : Keep pets away from the airbed. Pets may tear or puncture the WARNING

airbed.

15. IMPORTANT: Make sure the area is ﬂat, smooth, even and free of sharp

IPN2-13-E

Instruction Manual

Built-in Electric Pump

220 240V ~ 50 Hz 13 –0W

objects that can puncture the airbed. Do not set up the airbed nearby stairs, doors,

drops, sharp edges or breakables.

16. IMPORTANT: To minimize any chance of rolling, tipping or swaying, avoid

sleeping on the edge of the airbed. Edges provide less support than the middle of

the airbed.

17. IMPORTANT: This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision or

instruction concerning use of the appliance by a person responsible for their

safety.

18. IMPORTANT: Children should be supervised to ensure that they do not play

with the appliance.

Inﬂation instructions

1. Open the cord cover of pump first and make sure the optional inﬂation air valve is

securely closed.

2. Plug the AC electrical line cord into an AC electrical outlet (ground fault circuit

interrupter outlet). Please check the correct voltage! See Fig. (1)

3. Turn the control dial clockwise until the inﬂation mark ( ). arrow points to

See Fig. (2)

220 240V –

11 0 –120V

Fig.(1)

××

√

√√

Fig.(2)

4. When the airbed is fully inﬂated to the desired ﬁrmness, turn the control dial

counter-clockwise until arrow points to the “OFF”. See Fig. (3)

5. Lie down on the airbed to test the ﬁrmness.

6. If the sleeping surface is too hard, adjust the firmness by continuously turning the

control dial counter-clockwise gradually until air start to exit through the air

passage. Then turn the control dial clockwise until arrow points to the “ ”OFF

when the desired ﬁrmness is achieved. If the airbed becomes too soft, please repeat

step 3 thru 5 as necessary.

7. Disconnect the AC line cord from the wall socket and place it inside the cord

compartment.

Deﬂation instructions

1. Open the cord cover of pump first and make sure the optional inﬂation air valve is

securely closed.

2. Plug the AC electrical line cord into an AC electrical outlet (ground fault circuit

interrupter outlet). Please check the correct voltage! See Fig. (1)

3. Turn the control dial counter-clockwise until arrow points to the deﬂation mark

( ). See below Fig. (4)

4. When all air is removed from the airbed, turn the control dial clockwise until

arrow points to the . See below Fig. (3) “ ”OFF

5. When the airbed is completely deﬂated, begin rolling the airbed from the foot of

the airbed towards the head of the airbed where the pump is located. To ensure the

airbed is fully deﬂated, repeat steps 3 thru 4.

Fig.(3)

Product specificaties

Merk:	Jilong
Categorie:	luchtbed
Model:	JL027296N
Kleur van het product:	Zwart
Breedte:	1360 mm
Hoogte:	220 mm
Gewicht verpakking:	4400 g
Breedte verpakking:	370 mm
Diepte verpakking:	270 mm
Hoogte verpakking:	125 mm
Soort:	Tweepersoonsmatras
Type verpakking:	Doos
Lengte:	2050 mm
Gebruikstijd:	2 min
Aanbevolen leeftijdscategorie:	Volwassenen
Producten per pallet:	104 stuk(s)
Verpakkingsvolume:	53000 cm³
Ingebouwde luchtpomp:	Ja
Intrastatcode:	39269092
Minimum bestelhoeveelheid:	3 stuk(s)
Aantal kamers:	1
Pomp voltage:	220 - 240 V
Inclusief reparatiemiddel:	Ja
Ingebouwd kussen:	Ja