InFocus SP-LAMP-083 Handleiding
InFocus
Projector accessoire
SP-LAMP-083
Lees hieronder de 📖 handleiding in het Nederlandse voor InFocus SP-LAMP-083 (1 pagina's) in de categorie Projector accessoire. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/1
Lamp Module Replacement Instructions:
Lamp Module Replacement Instructions:
Lamp Module Replacement Instructions:
Lamp Module Replacement Instructions:Lamp Module Replacement Instructions:
SP-LAMP-083
SP-LAMP-083
SP-LAMP-083
SP-LAMP-083 SP-LAMP-083
1. Turn off the projector and unplug the power cord.
2. Wait 60 minutes to allow the projector and lamp to cool
thoroughly.
3. Remove the lamp door, located on top of the projector, by
removing the screw on the left side of the lamp door,
sliding the door to the left and lifting the lamp door off.
4. Loosen the captive screws that attach the lamp housing to
the projector.
NOTE: If the projector is installed on a ceiling mount, be
careful not to drop the lamp module once the captive
screws are loosened.
5. Carefully lift the lamp straight up, off of the alignment pins;
being careful not to pinch the lamp connector. Dispose of
the lamp in an environmentally proper manner.
6. Install the new lamp module, aligning the pins properly. Be
careful not to pinch the lamp connector.
7. Tighten the screws. (NOTE: If the pins have not been
aligned properly, the screws will not tighten securely.)
8. Replace the lamp door by reversing Step 3 and locking it
back into place.
9. Replace the lamp door screw and tighten securely.
10. Plug in the power cord and press the Power button to turn
the projector back on.
11. To reset the lamp hour timer, navigate to the Advanced
Menu > Status/Service menu and select Reset Lamp
Hours.
NOTES:
Always use the InFocus lamp module designed for your projector model. Using the wrong lamp module may cause premature lamp failure and possible
damage to the projector.
SP-LAMP-083 – Used in IN122ST, IN124ST, IN126ST
You can order new lamps from www.infocus.com (in select areas), your retailer or your dealer. Only genuine InFocus lamps are tested for use in this
projector. Use of non InFocus lamps may cause electrical shock and fire, and may void the projector warranty. InFocus is not liable for the performance,
safety or certification of any other lamps.
WARNINGS:
The projector uses a high-pressure mercury glass lamp. The lamp may fail prematurely, or it may rupture with a popping sound if jolted, scratched, or
handled while hot. The risk of lamp failure or rupture also increases as the lamp age increases; please replace the lamp when you see the “Replace
Lamp” message.
To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.
Unplug the power cord before replacing the lamp.
Do not drop the lamp module. The glass may shatter and cause injury.
Do not touch the glass surface of the lamp module. Fingerprints can obscure projection sharpness and may cause the glass to shatter.
Be extremely careful when removing the lamp module. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp
module is designed to contain most of these fragments, but use caution when removing it.
Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement.
When replacing the lamp while the projector is ceiling-mounted, wear protective eyewear to prevent eye injury.
Hg-Lamp contains mercury. Manage with accordance with local disposal laws. See www.lamprecycle.org
Image
Setup
Status/Service
Basic Menu
Source Info...
Projector Info...
Reset Lamp Hours...
Factory Reset...
Service Code...
( ) Advanced Menu
MDL: IN112
FW: 0.13
Product specificaties
Merk: | InFocus |
Categorie: | Projector accessoire |
Model: | SP-LAMP-083 |
Gewicht verpakking: | 340 g |
Vermogen lamp: | 230 W |
Afmetingen verpakking (BxDxH): | 150 x 150 x 120 mm |
Merkcompatibiliteit: | Infocus |
Levensduur lamp: | 3500 uur |
Compatibiliteit: | IN122ST, IN124ST, IN126ST |
Serviceleeftijd van de lamp (economische mode): | 5000 uur |
Heb je hulp nodig?
Als je hulp nodig hebt met InFocus SP-LAMP-083 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Projector accessoire InFocus
16 Maart 2023
11 Februari 2023
20 Oktober 2022
Handleiding Projector accessoire
- Projector accessoire Sony
- Projector accessoire Casio
- Projector accessoire Panasonic
- Projector accessoire Auna
- Projector accessoire Barco
- Projector accessoire BenQ
- Projector accessoire Hitachi
- Projector accessoire Manhattan
- Projector accessoire Nec
- Projector accessoire Nedis
- Projector accessoire Newstar
- Projector accessoire Peerless
- Projector accessoire Sanyo
- Projector accessoire Speaka
- Projector accessoire Viewsonic
- Projector accessoire Vogels
- Projector accessoire XGIMI
- Projector accessoire Omnitronic
- Projector accessoire Optoma
- Projector accessoire Sanus
- Projector accessoire Vision
- Projector accessoire Chief
- Projector accessoire Gabor
- Projector accessoire SMK-Link
- Projector accessoire Lindy
- Projector accessoire Da-Lite
- Projector accessoire AV:link
- Projector accessoire Peerless-AV
- Projector accessoire Projecta
- Projector accessoire Chipolino
- Projector accessoire Konig & Meyer
- Projector accessoire Roadinger
- Projector accessoire Tempest
- Projector accessoire Premier Mounts
- Projector accessoire Gravity
- Projector accessoire Elite Screens
- Projector accessoire Kingpin Screens
- Projector accessoire Kanto
- Projector accessoire V7
- Projector accessoire Christie
- Projector accessoire Unicol
- Projector accessoire My Wall
- Projector accessoire Smart Media
- Projector accessoire NeoMounts
Nieuwste handleidingen voor Projector accessoire
18 December 2024
17 December 2024
17 December 2024
26 November 2024
26 November 2024
26 November 2024
26 November 2024
26 November 2024
26 November 2024
26 November 2024