Indesit PWDE 7124 W Handleiding

Indesit Wasmachine PWDE 7124 W

Lees hieronder de đź“– handleiding in het Nederlandse voor Indesit PWDE 7124 W (60 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/60
GB
1
English,1
GB
WASHER-DRYER
! This symbol reminds you to read this instruction manual.
Contents
Installation, 2-3
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Description of the washer-dryer, 4-5
Control panel
Display
How to run a wash cycle or a drying cycle, 6
Wash cycles and options, 7
Table of programmes and wash cycles
Wash options
Detergents and laundry, 8
Detergent dispenser drawer
Preparing the laundry
Special wash cycles
Precautions and advice, 9
General safety
Disposal
Care and maintenance, 10
Cutting off the water and electricity supplies
Cleaning the washer-dryer
Cleaning the detergent dispenser drawer
Caring for the door and drum of your appliance
Cleaning the pump
Checking the water inlet hose
Troubleshooting, 11
Service, 12
PWDE 7124 W
Instructions for use
Français,13
F
Español,25
ES
PortuguĂŞs,37
PT
Italiano,49
IT
2
GB
! This instruction manual should be kept in a safe place for
future reference. If the washer-dryer is sold, transferred or
moved, make sure that the instruction manual remains with
the machine so that the new owner is able to familiarise
himself/herself with its operation and features.
! Read these instructions carefully: they contain vital
information relating to the safe installation and operation of
the appliance.
Unpacking and levelling
Unpacking
1. Remove the washer-dryer from its packaging.
2. Make sure that the washer-dryer has not been damaged
during the transportation process. If it has been damaged,
contact the retailer and do not proceed any further with the
installation process.
3. Remove the 4 protective
screws (used during
transportation) and the
rubber washer with the
corresponding spacer,
located on the rear part of
the appliance ( ).see figure
4. Close off the holes using the plastic plugs provided.
5. Keep all the parts in a safe place: you will need them
again if the washer-dryer needs to be moved to another
location.
! Packaging materials should not be used as toys for
children.
Levelling
1. Install the washer-dryer on a flat sturdy floor, without
resting it up against walls, furniture cabinets or anything
else.
2. If the floor is not perfectly
level, compensate for any
unevenness by tightening
or loosening the adjustable
front feet ( ); see figure
the angle of inclination,
measured in relation to the
worktop, must not exceed
2°.
Levelling the machine correctly will provide it with stability,
help to avoid vibrations and excessive noise and prevent it
from shifting while it is operating. If it is placed on carpet or
a rug, adjust the feet in such a way as to allow a sufficient
ventilation space underneath the washer-dryer.
Connecting the electricity and water
supplies
Connecting the water inlet hose
1. Connect the inlet hose
by screwing it to a cold
water tap using a 3/4 gas
threaded connection (see
figure).
Before performing the
connection, allow the
water to run freely until it is
perfectly clear.
2. Connect the inlet hose
to the washer-dryer by
screwing it onto the
corresponding water inlet
of the appliance, which is
situated on the top right-
hand side of the rear part of
the appliance . (see figure)
3. Make sure that the hose is not folded over or bent.
! The water pressure at the tap must fall within the range
of values indicated in the Technical data table (see next
page).
! If the inlet hose is not long enough, contact a specialised
shop or an authorised technician.
! Never use second-hand hoses.
! Use the ones supplied with the machine.
Installation
GB
3
Connecting the drain hose
Connect the drain hose,
without bending it, to a
drain duct or a wall drain
situated between 65 and
100 cm from the floor;
alternatively, placed it over
the edge of a basin, sink
or tub, fastening the duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.
! We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150
cm in length.
Electrical connections
Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable
laws;
• the socket is able to withstand the maximum power
load of the appliance as indicated in the Technical data
table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table ( );see opposite
• the socket is compatible with the plug of the washer-
dryer. If this is not the case, replace the socket or the plug.
! The washer-dryer must not be installed outdoors, even
in covered areas. It is extremely dangerous to leave the
appliance exposed to rain, storms and other weather
conditions.
! When the washer-dryer has been installed, the electricity
socket must remain within easy reach.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced by
authorised technicians.
Warning! The company shall not be held responsible in the
event that these standards are not observed.
The first wash cycle
Once the appliance has been installed, and before you use
it for the first time, run a wash cycle with detergent and no
laundry, using wash cycle number 2.
65 - 100 cm
Technical data
Model PWDE 7124 W
Dimensions
width 59.5 cm
height 85 cm
depth 55 cm
Capacity from 1 to 7 kg for wash programme
from 1 to 5 kg for the drying programme
Electrical
connections
please refer to the technical data plate
fixed to the machine
Water connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 52 litres
Spin speed up to 1200 rotations per minute
Energy rated
programmes
according to
regulation
EN 50229
wash: programme 2; temperature 60°C;
using a load of 7 kg.
drying: first drying cycle performed with
a 2 kg load, by selecting the drying level
“A1” (IRON);
second drying cycle performed with a
5 kg load, by selecting the maximum
drying level “A4” (EXTRA).
This appliance conforms to the following
EC Directives:
- 2004/108/EC (Electromagnetic Compa-
tibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC


Product specificaties

Merk: Indesit
Categorie: Wasmachine
Model: PWDE 7124 W
Apparaatplaatsing: Vrijstaand
Soort bediening: Buttons, Rotary
Kleur van het product: Wit
Deurscharnieren: Links
Ingebouwd display: Ja
Gewicht: 66000 g
Breedte: 595 mm
Diepte: 551 mm
Hoogte: 850 mm
Type lader: Voorbelading
Trommelinhoud: 52 l
Uitgestelde start timer: Ja
Startvertraging: 24 uur
Aantal droogprogramma's: 3
Breedte verpakking: 650 mm
Diepte verpakking: 590 mm
Hoogte verpakking: 890 mm
Energie-efficiëntieklasse (oud): B
Energieverbruik wassen: - kWu
Wasklasse: A
Aanpasbare centrifugesnelheid: Ja
Maximale centrifugesnelheid: 1200 RPM
Droogcapciteit: 5 kg
Jaarlijks engergieverbruik wassen & drogen: 1134 kWu
Energiegebruik bij wassen & drogen: 1.33 kWu
Waterverbruik wassen & drogen: 92 l
Restvochtpercentage: 54 procent
Aantal wasprogramma's: 16
Spoelen Plus functie: Ja
Duur wascyclus: 153 min
Nominale capaciteit (wassen): 7 kg
Type beeldscherm: LED
Wasprogramma's: Hand/wool, Jeans/denim, Delicate/silk

Heb je hulp nodig?

Als je hulp nodig hebt met Indesit PWDE 7124 W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasmachine Indesit

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine