Hunter 99121 Handleiding

Hunter Controller 99121

Lees hieronder de 📖 handleiding in het Nederlandse voor Hunter 99121 (2 pagina's) in de categorie Controller. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

www.HunterFan.com 1.888.830.1326

Model 99121

Universal 3 Speed

Ceiling Fan Remote

Installation

OR OR OR

Remove the canopy. If uncertain

how to remove it, reference the fan’s

owner’s manual. With wiring exposed,

it may be helpful to note existing wire

connections or take a digital photo for

reference. Remove the wire connectors

that connect the wires from the outlet

box to the fan, leaving the grounding

wires connected.

Before installing the

Universal Remote Control

Receiver, use the pull chains

to set the fan speed to HIGH

and the light to ON. Be

sure power is OFF before

proceeding with installation.

Choose the hanging system that most closely resembles the one used by your fan and install the receiver as shown and wire as directed.

Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8” remaining. Re-strip the fan lead wires 1/2”. Place remaining excess

wire into the ceiling electrical box. The bracket and fan must remain properly grounded.

You may have installation issues if the fan is installed on an angled ceiling. For assistance, call 1-888-830-1326.

Ceiling

Plate

Receive

Canopy

Receiver

Canopy

Ceiling

Bracket

Receiver Fan Body

Cable Tie

For low prole fans, the receiver should

be secured to the ceiling bracket with a

cable tie.

Receiver

Canopy

M0059-01 • 01/14/14 • © Hunter Fan Company

Turn Power

OFF

If you are installing multiple remote-controlled fans

on the same circuit breaker,

you may need to perform a few extra steps to prevent

interference or faulty operation of your remote controls.

Go to www.HunterFan.com/FAQs and click “How do I properly

install multiple remote-controlled fans?” for more information.

Wiring

CONNECT WIRES FROM RECEIVER TO FAN - Using the orange wire connectors, connect the blue wire from the

receiver to the blue wire (or possibly black with white stripe wire) from the fan. Connect the yellow wire from the

receiver to the black wire from the fan.

If you’re uncertain about wire colors or connections, please contact a qualied electrician.

CONNECT WIRES FROM RECEIVER AND FAN TO WIRES FROM OUTLET BOX - Using the orange wire connectors,

connect the black wire (ungrounded) from the ceiling to the black wire from the receiver. Connect the white wire

(grounded) from the ceiling to both the white wire from the receiver and the white wire from the fan.

AFTER ALL WIRES ARE CONNECTED and secured with wire connectors, re-install the canopy.

Turn the splices upward and push them carefully back through the hanger bracket

into the outlet box. Spread the wires apart, with the grounded wires on one side of

the outlet box and the ungrounded wires on the other side of the outlet box.

To avoid possible electrical shock, before installing or servicing your fan, disconnect

the power by turning off the circuit breakers to the outlet box and associated wall

switch location. If you cannot lock the circuit breakers in the off position, securely

fasten a prominent warning device, such as a tag, to the service panel.

black

blue

yellow

blue

black

white white (grounded)

black (ungrounded)

white

www.HunterFan.com 1.888.830.1326

The Fan Off button only turns the fan

off. To turn the fan on, press one of the

fan speed buttons.

High

Medium

Low

Pairing

Within 3 minutes of restoring power

to the fan, press both the Fan Off

button and the High button for at least

4 seconds. Your fan will turn on low to

indicate successful syncing. If it does

not, turn off power to your fan, wait

1 minute then try again. If using the

transmitter with multiple fans, repeat

this process for each fan.

Note: The remote must be paired

before the fan will operate.

Fan Off High

Quickly press and release either Light

button to turn the lights off and on.

Press and hold either light button for

more than 1 second to activate the

dimming cycle. Release the light button

when the desired light level is reached.

Dim

Operation Maintenance

To install the transmitter cradle,

remove the two screws holding your

switch cover plate. Do not remove the

cover plate. Orient the cradle by lining

up the two mounting holes with those

on the cover plate. Insert and tighten

the screws. Do not over tighten.

Installing or changing the battery

To access the battery compartment

remove the small Phillips head screw

that secures the battery door to the

transmitter assembly. Replace with a

CR2032 battery when necessary. The

battery should be installed with the

positive (+) side up.

Phillips

Head

Screw

Battery

Door

Low Medium

M0059-01 • 01/14/14 • © Hunter Fan Company

Turn Power

TroubleshootingSafe-Exit

This device complies with part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This device complies with RSS-210 of Industry Canada. Operation is

subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to

radio communications. However there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following

measures: Reorient or relocate the receiving antenna, Increase the

separation between the equipment and receiver, Connect the equipment

into an outlet on a circuit different from that to which the receiver is

connected. Consult the dealer or an experienced radio/TV technician for

help. Note: Any changes or modications to the transmitter or receiver

not expressly approved by Hunter Fan Company may void one’s authority

to operate this remote control.

Read and Save These Instructions

This product conforms to UL Standard 507.

WARNINGS

Fan will not start

• Make sure the power is on at the

circuit breaker and the wall switch.

• Make sure the battery is working.

• Make sure that the transmitter and

receiver are paired.

• Check wire connections inside of

the canopy.

Remote control of fan is erratic

• Make sure the battery is installed

correctly.

• Install a fresh battery.

Transmitter only works when held

at close range

• Change battery.

Lights do not dim

• Check to see if a CFL bulb is

installed. The control has a feature

that automatically detects CFL bulbs

and turns off dimming if a CFL bulb

is installed.

CFL bulbs icker

• Turn the light switch off and back

on. Within three minutes, hold down

the Fan Off button while pressing

the Dim Down button twice. If the

problem is not corrected, repeat the

process up to three times.

• Press the Fan Off button for at

least three seconds to initiate the

Safe-Exit Mode.

• The lights will ash for visual

conrmation.

• The lights will stay on 50%

brightness for 15 seconds and

then begin to dim. After a total

of 30 seconds, the lights will be

completely off.

Note: For CFL lighting, the lights

will stay on 100% brightness

for 30 seconds. After a total of

30 seconds, the lights will be

completely off.

The Safe-Exit Program gives

you about thirty seconds of

light when you turn the lights

off to exit the room before the

lights go out. To use Safe-Exit:

HUNTER FAN COMPANY CONTROL LIMITED WARRANTY

The Hunter Fan Company makes the following limited warranty to the original purchaser

of the Control (“Control”): Your Control is warranted to be free from defects in

material and workmanship for a period of one year from the date of sale. If the Control

malfunctions or fails within the warranty period due to a defect in material or workmanship

we will replace it free of charge. IF THE ORIGINAL PURCHASER CEASES TO OWN THE

CONTROL, THIS WARRANTY AND ANY IMPLIED WARRANTY, INCLUDING BUT NOT

LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR

A PARTICULAR PURPOSE, ARE VOIDED. THIS WARRANTY IS IN LIEU OF ALL OTHER

EXPRESS WARRANTIES. THE DURATION OF ANY IMPLIED WARRANTY, INCLUDING,

BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR

FITNESS FOR A PARTICULAR PURPOSE, IN RESPECT TO ANY CONTROL, IS

EXPRESSLY LIMITED TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH

ABOVE FOR SUCH CONTROL. This warranty excludes malfunctions or failures which

were caused by repairs by persons not authorized by us, mishandling, improper installation,

modications, or damage to the Control while in your possession, or unreasonable use.

This warranty does not apply to batteries or to deterioration or damage to the product

caused by the use of faulty batteries. To obtain a replacement, return your Control postage

prepaid along with proof of purchase to Hunter Fan Company Service Department at

7130 Goodlett Farms Pkwy., Memphis, TN 38016. IN NO EVENT SHALL HUNTER

FAN COMPANY BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES.

SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED

WARRANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR

CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY

NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND

YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

HighFan Off

Cradle

Dim

Down

If you have problems installing or operating your fan, do not return this

product to the dealer. Call our Consumer Affairs Hotline.

1-888-830-1326

Use the pull-chain switch on the

fan to set the fan speed to the HIGH

position before operation.

IMPORTANT

Product specificaties

Merk:	Hunter
Categorie:	Controller
Model:	99121
Kleur van het product:	Zilver
Ingebouwd display:	Nee
Aantal snelheden:	3
Plaatsing:	Muur
Ingebouwd licht:	Ja
MP3 afspelen:	Nee
Afstandsbediening inbegrepen:	Ja
Ventilator diameter:	- mm