Hori Fighting Stick α Handleiding

Hori Controller Fighting Stick α

Lees hieronder de 📖 handleiding in het Nederlandse voor Hori Fighting Stick α (7 pagina's) in de categorie Controller. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/7

Controller

Instruction Manual

Thank you for purchasing this product.

Before using this product please read the instructions carefully.

After reading the instruction manual, please keep it for reference.

Caution

Caution Parents/Guardians:

Please read the following information carefully.

● This product contains small parts. Keep away from children under 3 years old.

● Keep this product away from small children or infants. Seek medical attention immediately if any

small parts are swallowed.

● Long cord. Strangulation hazard.

● Keep the product away from dusty or humid areas.

● Do not use this product if it has been damaged or modified.

● Do not get this product wet. This may cause an electric shock or malfunction.

● Do not place this product near heat sources or leave under direct sunlight for an extended period.

Overheating may cause malfunction.

● Do not touch the metal parts of the USB plug.

● Do not apply strong impact or weight on the product.

● Do not pull roughly or bend the cable of the product.

● Do not disassemble, modify or attempt to repair this product.

● If product needs cleaning, use only a soft dry cloth. Do not use any chemical agents like benzene

or thinner.

● Do not use this product for anything other than its intended purpose. We are not responsible for

any accidents or damages in the event of use other than the intended purpose.

Included

Xbox Series X|S / Xbox One / Windows 10

【】Subpanel

Mode Toggle Switch

Key Lock Switch

Mic LED

Share Button

Xbox®

Guide button

View Button

RSB Button

LSB Button

Status LED

Profile LED

Audio Control Button

Profile Button

Mic On/Off Button

Joystick (D-Pad)

RB Button

LB Button

RT Button

LT Button

Y Button

X Button

B Button

A Button

Menu Button

USB Connector Controller Cable

Quick Release

Platform

* Functions as PC controller through XInput.

This product does not support DirectInput.

USB Port, Internet ConnectionSystem requirements

Important

Before using this product with the Xbox Series X|S / Xbox One system,please read the included

instructions carefully.

Please check that your Xbox Series X|S / Xbox One is updated to the latest system firmware.

This product is designed for the Xbox Series X|S, but it can also be used with the

Xbox One and Windows 10 by following the instructions in this manual.

Layout

【】Front View

Headphone/Mic Jack

Open the chassis while sliding the sliding lock button.

Open the top case to a vertical position and place the product on a sturdy surface.

Please note that damage (such as damaged buttons and quick disconnect blade

connectors and covers, broken cables, etc.) caused by user modifications other than

replacing buttons or panel art are not covered by warranty.

● Please de-static yourself before touching inside of the product.

● Do not connect the USB plug into the Xbox Series X/ Xbox Series S/ Xbox One console or

Windows 10 USB port.

● Do not remove buttons or connectors during gameplay.

● Do not directly touch the metal inside the product with your bare hands.

● Be careful to not get your hands, fingers, hair, or cables caught when opening or closing the chassis.

Open the chassis for maintenance or replace the design sheet to customize your

Fighting Stick α.

How to Open the Chassis

●When installing a button, push the button in until

the stopper clicks into place.

* After installing, make sure that there is no gap between

the button and housing cover.

●When installing a button, insert the blade connectors

as far as it will go.

Refer to the cable wiring diagram below when wiring

each button.

2) As shown in the figure, push the two stoppers little

by little to remove them from the housing cover.

* Parts may be damaged if too much force is used.

* Be careful to not cut your hands on the edges of the buttons

holes on the housing cover.

1) Remove the quick disconnect blade connectors

connected to each button.

* When disconnecting the blade connectors, do not pull it out

by holding only the wiring cable.

How to Remove a Button

①

②

●When performing maintenance, please refer to the “How to Remove a Button”

section and the “Cable Wiring Diagram” as shown below.

Maintenance and Design Customization

Remove

Housing

Cover

Stopper

While

pressing

While

pressing

Blade connector

Product specificaties

Merk:	Hori
Categorie:	Controller
Model:	Fighting Stick α
Kleur van het product:	Black,White
Gewicht:	- g
Connectiviteitstechnologie:	Bedraad
Ondersteunt Windows:	Windows 10
Soort apparaat:	Fightstick
Analoge duim-sticks:	Ja
Gaming platforms ondersteund:	Xbox One,Xbox Series S,Xbox Series X
Programmeerbare knoppen:	Ja
Gaming controle functie toetsen:	Delenknop