Honeywell T822K1018/U Handleiding

Honeywell Thermostaat T822K1018/U

Lees hieronder de 📖 handleiding in het Nederlandse voor Honeywell T822K1018/U (16 pagina's) in de categorie Thermostaat. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
Owners Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
Español: Página 11
T834 Series
Thermostat
69-1944EFS-01
M37978
Check package contents:
Thermostat
Wall anchors & screws (2 each)
Before you begin, make sure you have:
No. 2 Phillips & small pocket screw-
drivers
Hammer
Level (optional)
Pencil
Drill and bit (3/16” for drywall, 7/32” for
plaster)
Pre-installation checklist
This manual covers the following models:
Horizontal Mount: Vertical Mount: T8034N T834N/T834L
Must be installed by a trained, experienced technician
Read these instructions carefully. Failure to follow these instructions
can damage the product or cause a hazardous condition.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
T834 Series
69-1944EFS—01 2
System Types
Gas, oil, or electric heat with air
conditioning
Warm air, hot water, high-efficiency
furnaces, heat pumps, steam, gravity
Heat only
Heat only with fan
Cool only
System Settings
Heat, Off, Cool (T834N)
Off, Cool (T834L)
Fan Settings
Auto, On
Product application
This thermostat provides control of 24 Vac single-stage heating and cooling systems.
Electrical Ratings
Terminal Voltage (50/60Hz) Running Current
W Heating 2030 Vac 0.021.2 A
Y Cooling 2030 Vac 0.021.2 A
G Fan 2030 Vac 0.020.6 A
O Cooling Changeover 2030 Vac 0.020.5 A
B Heating Changeover 2030 Vac 0.020.5 A
Specifications
Temperature Range
50° to 90°F (10° to 32°C)
Operating Ambient Temperature
to 120°F (18° to 49°C)
Operating Relative Humidity
5% to 90% (non-condensing)
Dimensions (vertical model)
2.88W x 4.75H x 1.5D (inches)
73W x 121H x 38D (mm)
Dimensions (horizontal model)
4.75W x 2.88H x 1.5D (inches)
121W x 73H x 38D (mm)
English: Français : Español: Page 1 • Page 6 • Página 11
3 69-1944EFS—01
MCR37992
UP
VERT.
UP
HORIZ.
R
Rc
G
W
E
F
Y
0
UPHORIZ.
1. Pull wires through wire hole.
Position base on wall, level
and mark hole positions.
2. Drill holes (3/16” holes for
drywall, 7/32” holes for plas-
ter), then tap in supplied wall
anchors.
3. Pull wires through base, posi-
tion over anchors, and insert
screws. Check level if desired,
then tighten screws.
Base installation
1. Loosen screw terminals, insert bare wires
beneath screws, then re-tighten screws.
2. Push any excess wire back into the wall opening.
3. Plug the wall opening with nonflammable
insulation to prevent drafts from affecting
thermostat operation.
Terminal Designations
R Heating power. Connect to secondary
side of heating system transformer.
Rc Cooling power. Connect to secondary
side of cooling system transformer.**
G Fan relay.
W Heat relay.**
B Heat pump changeover valve energized in
heating.
O Heat pump changeover valve energized in
cooling.
Y Compressor contactor.
**Not present in the T834L model.
Wiring
NOTES
R & Rc Terminals
In single-transformer system, leave
metal jumper in place between R
& Rc. Remove metal jumper if two-
transformer system.
Heat pump systems
If wiring to a heat pump, use a small
piece of wire (not supplied) to connect
terminals .W and Y
Wire Specifications
Use 18-gauge thermostat wire. Shielded
wire is not required.


Product specificaties

Merk: Honeywell
Categorie: Thermostaat
Model: T822K1018/U

Heb je hulp nodig?

Als je hulp nodig hebt met Honeywell T822K1018/U stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Thermostaat Honeywell

Handleiding Thermostaat

Nieuwste handleidingen voor Thermostaat