Hayward SwimClear C200S Handleiding

Hayward Niet gecategoriseerd SwimClear C200S

Lees hieronder de 📖 handleiding in het Nederlandse voor Hayward SwimClear C200S (8 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 85 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

ISCS100 Rev B

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 1

SwimClear™ CARTRIDGE FILTER

Owner’s Manual

Models C100S, C150S and C200S

IMPORTANT SAFETY INSTRUCTIONS

SAVE THIS INSTRUCTION MANUAL

Basic safety precautions s

ways

e fo

owe

ure to fo

ow instructions can cause severe injury

and/or death.

This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for

one of the following signal words and be alert to the potential for personal injury.

WARNING

warns about hazards that can

cause serious personal injury, death or major property

damage and if ignored presents a potential hazard.

CAUTION

warns about hazards that will

or can

cause minor or moderate personal injury and/or

property damage and if ignored present a potential hazard. It can also make consumers aware of actions

that are unpredictable and unsafe.

The NOTICE

label indicates special instructions that are important but not related to hazards.

Hayward Pool Products

620 Division Street, Elizabeth, NJ 07207

Phone: (908) 351.5400

www.hayward.com

Contents

Product Specific Warnings………2

Introduction……….…………..…..…4

Installation……….……………..…….4

General Warnings………….……….5

Replacement Parts………..……….6

Warranty & Registration …………8

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 2

WARNING – Read, understand and follow all instructions

in this owner’s manual and on the

equipment. Failure to follow instructions can cause severe injury and/or death.

WARNING – Suction Entrapment Hazard.

Suction in suction outlets and/or suction outlet covers which are, damaged, broken, cracked, missing, or unsecured can cause

severe injury and/or death due to the following entrapment hazards:

Hair Entrapment

- Hair can become entangled in suction outlet cover.

Limb Entrapment

- A limb inserted into an opening of a suction outlet sump or suction outlet cover that is damaged, broken,

cracked, missing, or not securely attached can result in a mechanical bind or swelling of the limb.

Body Suction Entrapment

- A negative pressure applied to a large portion of the body or limbs can result in an entrapment.

Evisceration/ Disembowelment

- A negative pressure applied directly to the intestines through an unprotected suction outlet

sump or suction outlet cover which is, damaged, broken, cracked, missing, or unsecured can result in evisceration/

disembowelment.

Mechanical Entrapment

- There is potential for jewelry, swimsuits, hair decorations, fingers, toes or knuckles to be caught in an

opening of a suction outlet cover resulting in mechanical entrapment.

WARNING

- To Reduce the risk of Entrapment Hazards:

 When outlets are small enough to be blocked by a person, a minimum of two functioning suction outlets per pump must be

installed. Suction outlets in the same plane (i.e. floor or wall), must be installed a minimum of three feet (3’) [1 meter]

apart, as measured from near point to near point.

 Dual suction fittings shall be placed in such locations and distances to avoid “dual blockage” by a user.

 Dual suction fittings shall not be located on seating areas or on the backrest for such seating areas.

 The maximum system flow rate shall not exceed the flow rating as listed on the suction outlet cover.

 Never use Pool or Spa if any suction outlet component is da , or not securely attached. maged, broken, cracked, missing

 Replace damaged, broken, cracked, missing, or not securely attached suction outlet components immediately.

 In addition, two or more suction outlets per pump installed in accordance with latest ASME, APSP Standards and CPSC

guidelines, follow all National, State, and Local codes applicable.

 Installation of a vacuum release or vent system, which relieves entrapping suction, is recommended.

WARNING

– Failure to remove pressure test plugs and/or plugs used in winterization of the pool/spa from

the suction outlets can result in an increased potential for suction entrapment as described above.

WARNING

– Failure to keep suction outlet components clear of debris, such as leaves, dirt, hair, paper

and other material can result in an increase potential for suction entrapment as described above.

WARNING

– Suction outlet components have a finite life: the cover/grate should be inspected frequently

and replaced at least every seven years or if found to be damaged, broken, cracked, missing, or not securely

attached.

CAUTION

– Components such as the filtration system, pumps and heater must be positioned so as to

prevent their being used as means of access to the pool by young children. To reduce risk of injury, do not permit

children to use or climb on this product. Closely supervise chil such as the filtration system, dren at all times. Components

pumps, and heaters must be positioned to prevent children from using them as a means of access to the pool.

WARNING

– Hazardous Pressure.

Pool and spa water circulation systems operate under hazardous pressure during

start up, normal operation, and after pump shut off. Stand clea e to r of circulation system equipment during pump start up. Failur

follow safety and operation instructions could result in violent separation of the pump housing and cover, and/or filter housing

and lock ring due to pressure in the system, which could cause property damage, severe personal injury, or death. Before

servicing pool and spa water circulation system, all system and pump controls must be in off position and filter manual air rel

ief

valve must be in open position. Before starting system pump, all system valves must be set in a position to allow system water

return back to the pool. Do not change filter control valve position while system pump is running. Before starting system pump,

fully open filter manual air relief valve. Do not close filter manual air relief valv

e until a steady stream of water (not air or air and

water) is discharged.

WARNING

– Separation Hazard. Failure to follow safety and operation instructions could result in violent

separation of pump and/or filter components. Strainer cover must be properly secured to pump housing with strainer cover lock

ring. Before servicing pool and spa circulation system, filters manual air relief valve must be in open position. Do not operate

pool and spa circulation system if a system componen

t is not assembled properly, damaged, or missing.

Never operate or test

the circulation system at more than 50 PSI. Do not purge the system with compressed air. Purging the system with

compressed air can cause components to explode, with risk of severe injury or death to anyone nearby. Use only a low pressure

(below 5 PSI), high volume blower when air purging the pump, filter, or piping.

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 3

WARNING

– Risk of Electric Shock. All electrical wiring MUST be in conformance with applicable local codes,

regulations, and the National Electric Code (NEC). Hazardous voltage can shock, burn, and cause death or serious property

damage. To reduce the risk of electric shock, do NOT use an extension cord to connect unit to electric supply. Provide a properly

located electrical receptacle. Before working on any electrical equipment, turn off power supply to the equipment. To reduce

the risk of electric shock replace damaged wiring immediately. Locate conduit to prevent abuse from lawn mowers, hedge

trimmers and other equipment. Do NOT ground to a gas supply line.

WARNING

–

Risk of Electric Shock.

Failure to ground all electrical equipment can cause serious or fatal electrical

shock hazard. Electrically ground all electrical equipment before connecting to electrical power supply.

WARNING

– Risk of Electric Shock. Failure to bond all electrical equipment to pool structure will increase risk for

electrocution and could result in injury or death. To reduce the risk of electric shock, see installation instructions and consult a

professional electrician on how to bond al censed electrician fol electrical equipment. Also, contact a li r information on local

electrical codes for bonding requirements.

Notes to electrician: Use a solid copper conductor, size 8 or larger. Run a continuous wire from external bonding lug to

reinforcing rod or mesh. Connect a No. 8 AWG (8.4 mm

) [No. 6 AWG (13.3 mm

) for Canada] solid copper bonding wire to the

pressure wire connector provided on the electrical equipment and to all metal parts of swimming pool, spa, or hot tub, and metal

piping (except gas piping), and conduit within 5 ft. (1.5 m) of inside walls of sw

imming pool, spa, or hot tub.

IMPORTANT - Reference NEC codes for all wiring standards including, but not limited to, grounding, bonding and other general

wiring procedures.

WARNING

– Risk of Electric Shock. The electrical equipment must be connected only to a supply circuit that is

protected by a ground-fault circuit-interrupter (GFCI). Such a GFCI should be provided by the installer and should be tested o

n a

routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push reset button. Power should be

restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the electrical equipment

without the test button being pushed, a ground current is flowing, indicating the possibility of an electrical shock. Do not use this

electrical equipment. Disconnect the electrical equipment and have the problem corre

cted by a qualified service representative

before using.

CAUTION –

–

– –

HAYWARD

®®

pumps are intended for use with permanently-installed pools and may be used with hot tubs

and spas if so marked. Do not use with storable pools. A permanently-installed pool is constructed in or on the ground or in a

building such that it cannot be readily disassembled for storage. A storable pool is constructed so that it is capable of bein

readily disassembled for storage and reassembled to its original integrity.

WARNING

– Risk of Hyperthermia.

. . To avoid hyperthermia the following

“Safety Rules for Hot Tubs” are recommended

by the U.S. Consumer Product Safety Commission.

1. Spa or hot tub water temperatures should never exceed 104°F [40°C]. A temperature of 100°F [38°C] is considered

safe for a healthy adult. Special caution is suggested for young children. Prolonged immersion in hot water can

induce hyperthermia.

2. Drinking of alcoholic beverages before or during spa or hot tub use can cause drowsiness, which could lead to

unconsciousness and subsequently result in drowning.

3. Pregnant women beware! Soaking in water above 100°F [38°C] can cause fetal damage during the first three

months of pregnancy (resulting in the birth of a brain-damaged or deformed child). Pregnant women should adhere to

the 100°F [38°C] maximum rule.

4. Before entering the spa or hot tub, users should check the water temperature with an accurate thermometer; spa or

hot tub thermostats may err in regulating water temperatures by as much as 4°F (2.2°C).

5. Persons taking medications, which induce drowsiness, such as tranquilizers, antihistamines or anticoagulants,

should not use spas or hot tubs.

6. If the pool/spa is used for therapy, it should be done with the advice of a physician. Always stir pool/ spa water before

entering the pool/spa to mix in any hot surface layer of water that might exceed healthful temperature limits and cause

injury. Do not tamper with controls, because scalding can result if safety controls are not in proper working order.

7. Persons with a medical history of heart disease, circulatory problems, diabetes or blood pressure problems

should obtain a physician’s advice before using spas or hot tubs.

8. Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above normal body

temperature of 98.6°F [37°C]. The symptoms of Hyperthermia include: drowsiness, lethargy, dizziness, fainting,

and an increase in the internal temperature of the body.

The effects of Hyperthermia include:

1. Unawareness of impending danger.

2. Failure to p erceive heat.

3. Failure to recognize the need to leave the spa.

4. Physical inability to exit the spa.

5. Fetal damage in pregnant women.

6. Unconsciousness resulting in danger of drowning.

SAVE THESE INSTRUCTIONS

Product specificaties

Merk:	Hayward
Categorie:	Niet gecategoriseerd
Model:	SwimClear C200S

Heb je hulp nodig?

Als je hulp nodig hebt met Hayward SwimClear C200S stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Hayward

Hayward Easy Chem Handleiding

16 Mei 2024

Hayward SandMaster SM2306T Handleiding

30 Mei 2023

Hayward Pro-Grid C9002SEP Handleiding

29 Mei 2023

Hayward ProSeries HB Handleiding

16 Mei 2023

Hayward SharkVac XL Pilot Handleiding

14 Mei 2023

Hayward AquaRite 100 Handleiding

18 April 2023

Hayward PMD15 Handleiding

8 April 2023

Hayward SandMaster SM1906T Handleiding

7 April 2023

Hayward Control Station Handleiding

24 Maart 2023

Hayward SandMaster SM2506T Handleiding

22 Maart 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Einhell WB 50 Handleiding

30 December 2025

Hisense HAF1800D Handleiding

30 December 2025

Eufy Outdoor / Indoor Siren Handleiding

30 December 2025

Lenco TTA-180TN Handleiding

30 December 2025

Pioneer CA-HR-PSA-EVO.003 Handleiding

30 December 2025

TC Electronic PLETHORA X1 Handleiding

30 December 2025

Pioneer CA-HM-FOR.004 Handleiding

30 December 2025

Pioneer CA-HR-PSA-EVO.002 Handleiding

30 December 2025

Brennenstuhl Tower Power Handleiding

29 December 2024

Brennenstuhl Eco-Line Handleiding

29 December 2024