Hatco IWB-4 Handleiding

Hatco Koelkast IWB-4

Lees hieronder de 📖 handleiding in het Nederlandse voor Hatco IWB-4 (9 pagina's) in de categorie Koelkast. Deze handleiding was nuttig voor 47 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
P/N 07.04.697.00 © 2016 Hatco Corporation
Built-In Ice Well
Cuves à Glace à Encastrer
IWB Series/Série
Installation and Operating Manual
Manuel d'installation et d'utilisation
Replacement Parts List
Liste des pièces de rechange
Register Online!
(see page 2)
S'inscrire en ligne!
(voir page 13)
hatcocorp.com
Do not operate this equipment unless you
have read and understood the contents of
this manual! Failure to follow the
instructions contained in this manual may
result in serious injury or death. This
manual contains important safety
information concerning the maintenance,
use, and operation of this product. If
you’re unable to understand the contents
of this manual, please bring it to the
attention of your supervisor. Keep this
manual in a safe location for future
reference.
English = p 2
No opere este equipo al menos que haya
leído y comprendido el contenido de este
manual! Cualquier falla en el seguimiento
de las instrucciones contenidas en este
manual puede resultar en un serio lesión
o muerte. Este manual contiene
importante información sobre seguridad
concerniente al mantenimiento, uso y
operación de este producto. Si usted no
puede entender el contenido de este
manual por favor pregunte a su
supervisor. Almacenar este manual en
una localización segura para la referencia
futura.
Ne pas utiliser cet équipement sans avoir
lu et compris le contenu de ce manuel !
Le non-respect des instructions
contenues dans ce manuel peut entraîner
de graves blessures ou la mort. Ce
manuel contient des informations
importantes concernant l'entretien,
l'utilisation et le fonctionnement de ce
produit. Si vous ne comprenez pas le
contenu de ce manuel, veuillez le signaler
à votre supérieur. Conservez ce manuel
dans un endroit r pour pouvoir vous y
référer plus tard.
Français = p 13
WARNING
ADVERTENCIA
AVERTISSEMENT
Form No. IWBM-0816 5
INSTALLATION
English
General
Built-In Ice Wells are shipped from the factory as components
that require installation and connection. Use the following
procedures to install each component and make the
appropriate connections.
This unit must be installed by qualified, trained installers.
Installation must conform to all local plumbing codes.
Check with local plumbing inspectors for proper
procedures and codes.
Locate unit at the proper counter height in an area that is
convenient for use. Location should be level and strong
enough to support weight of unit and contents.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to unit.
All Built-In Ice Wells are shipped in a wooden frame for
protection and stability. Keep the unit in the wooden frame until
the unit and the installation site are completely prepared for the
unit to be installed.
1. Remove all external packaging from the unit.
2. Remove tape, protective packaging, and literature from all
surfaces of unit.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
3. Cut the appropriate opening in the countertop for the unit
being installed. Refer to “Countertop Cutout Dimensions”
in this section.
4. Make structural modifications or add bracing underneath
the countertop to ensure the countertop will support the
weight of the unit and its contents.
NOTE: The countertop must be level to ensure proper draining
of the well.
WARNING
CAUTION
NOTICE
5. Carefully lower unit into the countertop cutout. This step
requires two or more people, depending on the unit.
Installing an Ice Well
6. Apply National Sanitation Foundation-approved (NSF-
approved) silicone sealant around the edge of the unit to
seal it to the countertop.
7. Connect the 1" drain fitting to a trap and drain line. If a trap
and drain line are not available, a catch pan (not supplied)
must be used under the drain fitting to contain water
draining from the well enclosure.
NOTE: Consult a qualified plumber for proper trap and drain
installation that conforms to local plumbing codes.
8. Clean the well enclosure thoroughly in preparation for initial
operation. Refer to the MAINTENANCE section for proper
cleaning procedures.
NOTE: If a catch pan is used underneath the drain fitting, make
sure the pan is emptied regularly to prevent over-flowing.
Countertop
Cutout
Ice
Well
Symptom Probable Cause Corrective Action
Unit not cold enough. Food product not pre-chilled before loading in
unit.
Load unit with pre-chilled food product only.
Unit not filled with food pans/one or more open
pan positions.
Fill the well with food pans. The well will hold more efficiently
when filled with pans.
8Form No. IWBM-0816
TROUBLESHOOTING GUIDE
English
This unit must be serviced by qualified personnel only.
WARNING
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco for
assistance. To locate the nearest Service Agency, log onto the Hatco website at and click on www.hatcocorp.com
Find Service Agent, or contact the Hatco Parts and Service Team at:
Telephone: 800-558-0607 or 414-671-6350
e-mail: partsandservice@hatcocorp.com


Product specificaties

Merk: Hatco
Categorie: Koelkast
Model: IWB-4

Heb je hulp nodig?

Als je hulp nodig hebt met Hatco IWB-4 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Koelkast Hatco

Handleiding Koelkast

Nieuwste handleidingen voor Koelkast