Greisinger T-Logg 100 Handleiding

Greisinger Niet gecategoriseerd T-Logg 100

Lees hieronder de 📖 handleiding in het Nederlandse voor Greisinger T-Logg 100 (6 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/6
E39.0.0X.6C-03
GREISINGER electronic GmbH
D - 93128 Regenstauf, Hans-Sachs-Straße 26
â„¡
â„¡â„¡
℡  +49 (0) 9402 / 9383-0 +49 (0) 9402 / 9383-33 | info@greisinger.de
Data logger for temperature
as of version V1.3 Operating Manual T-Logg 100
T-Logg 100
T-Logg 100 E
E39.0.0X.6C-03 Operating instruction T-Logg 100 and T-Logg 100 E page 2 of 6
1 General
The logger T-Logg 100 and T-Logg 100 E are designed as a cost-efficient solution for monitoring temperatures.
It enables an individual programming of the recording time. The last 16,000 measuring values can be stored in the
memory. In addition, the LCD-display indicates both the temperature measured at the moment and the operating
status of the logger.
2 Required accessory:
The USB interface of your PC is used to program, start and read out the T-Logg.
For this following accessory is required:
 Level converter USB 100 or USB 100 SL for direct connection to the USB port of the PC,
cable length approx. 1m.
 MINISOFT software (version 7.11 or later / free of charge) to start the logger and read out the logger data.
Notice! It’s also possible to use the T-Logg 100 with the comprehensive software GSOFT 40K
(version 7.11 or later).
3 Safety instructions:
This device has been designed and tested in accordance with the safety regulations for electronic devices.
However, its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures and
special safety advises given in this manual will be adhered to when using the device.
1. Trouble-free operation and reliability of the device can only be guaranteed if the device is not subjected to any
other climatic conditions than those stated under ‘Specification’
To protect the battery the max. permissible storage and transport temperature of the device is +85°C.
2. General instructions and safety regulations for electric, light and heavy current plants, including domestic safety
regulations (e.g. VDE), have to be observed.
3. If device is to be connected to other devices (e.g. via PC) the circuitry has to be designed most carefully. Internal
connection in third party devices (e.g. connection GND and earth) may result in not-permissible voltages
impairing or destroying the device or another device connected.
4. If there is a risk whatsoever involved in running it, the device has to be switched off immediately and to be
marked accordingly to avoid re-starting.
Operator safety may be a risk if:
- there is visible damage to the device.
- the device is not working as specified.
- the device has been stored under unsuitable conditions for a longer time.
In case of doubt, please return device to manufacturer for repair or maintenance.
5. Warning:
Do not use this product as safety or emergency stop devices, or in any other application where failure of the
product could result in personal injury or material damage.
Failure to comply with these instructions could result in death or serious injury and material damage!
E39.0.0X.6C-03 Operating instruction T-Logg 100 and T-Logg 100 E page 3 of 6
4 Connection
â– Assignment of the input jack
(front view to the pins):
Interface [–]
Not connected
Interface [+]
5 Advice regarding state of logger upon delivery:
Upon its delivery the logger is in a kind of 'sleeping state': The display does not show anything, the power
consumption is at its minimum.
The T-Logg 100 ‘wakes up’ as a communication link with a software has been established. After that the message
‘Stop‘ appears at display. The logger is ready for operation now.
6 Operating mode display:
The T-Logg 100 is equipped with a 10 mm LCD display.
The main purpose of the LCD display is to indicate the temperature. Depending on the operating mode of the
logger, other messages will be displayed as well.
STOP:
The T-Logg is ‘stopped’. No data are recorded. The logger memory is empty.
The logger is reset and can be restarted.
HALT:
The T-Logg has been ‘halted’. The stored data can be read.
The logger memory is not empty.
DISPLAY OF TEMPERATURE:
The small arrow is flashing The logger is active.
Temperature measurements are carried out at certain intervals. The temperature
measured will be stored.
START DELAY:
The logger is active, but no data are recorded.
As soon as the start delay time has expired, the logger will start recording in accordance
with the starting conditions programmed before.
START ALARM:
The logger is active, but no data are recorded. Recording will start as soon as the
temperature is within the min. and max. alarm limits.

Product specificaties

Merk: Greisinger
Categorie: Niet gecategoriseerd
Model: T-Logg 100

Heb je hulp nodig?

Als je hulp nodig hebt met Greisinger T-Logg 100 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Greisinger

Greisinger

Greisinger T-Logg 120 W Handleiding

19 December 2023
Greisinger

Greisinger EASYlog 80 CL Handleiding

19 December 2023
Greisinger

Greisinger T-Logg 120 K Handleiding

19 December 2023
Greisinger

Greisinger GHTU-1R Handleiding

8 Juni 2023
Greisinger

Greisinger GFTB 200 Handleiding

4 Juni 2023
Greisinger

Greisinger GMH 3181-07 Handleiding

2 Juni 2023
Greisinger

Greisinger GMH 3156 Handleiding

1 Juni 2023
Greisinger

Greisinger T-Logg 100 Handleiding

23 Mei 2023
Greisinger

Greisinger GRHU-1R Handleiding

21 Mei 2023
Greisinger

Greisinger GIA 20 EB Handleiding

19 Mei 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Inglesina

Inglesina Welcome Pad Handleiding

22 December 2024
Inglesina

Inglesina Front Handleiding

22 December 2024
Inglesina

Inglesina Newborn Winter Muff Handleiding

22 December 2024
Inglesina

Inglesina Stroller Winter Muff Handleiding

22 December 2024
Protector

Protector AS-5030.3 V2 Handleiding

21 December 2024
Sabrent

Sabrent AU-MMCW Handleiding

21 December 2024
Sabrent

Sabrent AU-2X35 Handleiding

21 December 2024
Sabrent

Sabrent CB-RS232 Handleiding

21 December 2024
Owon

Owon 500W Handleiding

21 December 2024
Owon

Owon 300W Handleiding

21 December 2024