Gossen Metrawatt METRAHIT CAL Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Gossen Metrawatt METRAHIT CAL (36 pagina's) in de categorie Meetapparatuur. Deze handleiding was nuttig voor 10 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/36
METRAHITCAL
Calibrator 3-349-442-03
13/1.19
Operating Instructions
2 GMC-I Messtechnik GmbH
Operating Overview – Connections, Keys, Rotary Switch, Symbols
1 Display (LCD) (see page 3 for significance of symbols
2HOLD / CONT Pause/resume ramp/interval
Increase parameter values
Mode menu:
Selection of individual menu entries against direction of flow
3
ON / OFF | LIGHT
, key for switching device and display illumination on and off
4 OUT | ENTER
OUT: Switch calibrator output on and off
Mode menu: Acknowledge entry (ENTER)
5 Move cursor to the right
SELECT RANGE operating mode: ramp function selection
6Rotary switch for calibration functions and complete shutdown
7 DAkkS calibration mark
8 Connector jacks for calibrator output
9HOLD / CONT Pause/resume ramp/interval
Reduce parameter values
Mode menu:
Selection of individual menu entries in direction of flow
10 MEAS/CAL | SETUP
Key for switching back and forth between calibration and menu function
11 ZERO/SEL | ESC
Mode menu: Exit current menu level and
return to a higher level,
exit parameters configuration
without saving data.
Pause ramp/interval.
12 Move cursor to the left,
SELECT RANGE operating mode: interval function selection
13 Power pack connector jack (accessory: NA X-TRA)
14 Infrared interface (accessory interface adapter:
USB X-TRA)
1
3
4
14
5
6
12
10
2
12
9
13
7
Not a measurement input!
Do not apply interference voltage,
except with current sink.
!
8
GMC-I Messtechnik GmbH 3
Symbols used in the Digital Display 1 Battery level indicator
2 NUM: Numeric entry of the output signal
3 INT: Interval sequence active
4 RAMP: Ramp function active
5 SINK: Current sink is active
6 SOURCE: Current source is active
7 ON: The calibrator output is active
8 IR: Infrared interface display
9 Auxiliary display with decimal point and polarity display
10 Main display with decimal point and polarity display
11 Calibration unit of measure
12 : Simulator in continuous mode operation
13 Ni/Pt1000: Selected temperature sensor
14 Auxiliary display with decimal point and polarity display
1 2 8
9
10
12
12
14
654 7
15
3
Battery full
Battery OK
Battery weak
Battery (almost) dead, U < 1.8 V
Data transmission to / from calibrator is active
IR interface in standby mode
(ready to receive starting commands)
Battery Level Indicator
Interface Indicator (with selector switch setting OFF)


Product specificaties

Merk: Gossen Metrawatt
Categorie: Meetapparatuur
Model: METRAHIT CAL

Heb je hulp nodig?

Als je hulp nodig hebt met Gossen Metrawatt METRAHIT CAL stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Meetapparatuur Gossen Metrawatt

Handleiding Meetapparatuur

Nieuwste handleidingen voor Meetapparatuur