GBC Velobind V800 Pro Handleiding

GBC Niet gecategoriseerd Velobind V800 Pro

Lees hieronder de 📖 handleiding in het Nederlandse voor GBC Velobind V800 Pro (6 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 114 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/6
1.0 INTRODUCTION
1.1 OPERATIONAL COMPONENTS LAYOUT
Figure 1-1
1-2
Pressure Bar
Handle
Housing
Base
Waste Tray
Punch Guide
Light
Bind Guide
Locating Pin
Backstop
Strip Recess
2.0 SPECIFICATIONS
DESCRIPTION: Punch/Binder
PUNCH CAPACITY:* 1/8 in. (3.2 mm) X 14 in. (355.6 mm)
25 sheets of 20 lb. bond paper
*Note: No more than 4 composition covers, or
3 plastic covers should be punched at one time.
Punching stacks of these materials may result
in damage to the punch mechanism.
BIND CAPACITY: 1 in. (25 mm) X 14 in. (355.6 mm)
250 pages of 20 lb. bond paper
ELECTRICAL REQUIREMENTS: 120 VAC 230 VAC 100 VAC
60 Hertz 50 Hertz 50 Hertz
3 Amps 1.5 Amps 1.5 Amps
409.56 B.T.U.'s per hour
3-wire grounded outlet
CYCLE SPEED: 2 second punch cycle
8-10 second bind cycle
DIMENSIONS: 20 in. (50.8 cm) wide
7 in. (17.8 cm) high
15 in. (38.1 cm) deep
WEIGHT: 28 lbs. (12.7 kg)
2-1
3.0 INSTALLATION PROCEDURE
3.1 Unpacking Instructions
To unpack the machine, carefully remove the staples and open the carton. Remove
the packing material from the top and around the machine, and lift the machine
straight up out of the carton. Place the machine on a table near a 120 VAC or 220-
240 VAC grounded outlet, and remove the plastic bag.
3.2 Power Cord Configuration
This machine is supplied with a power cord terminating in a conventional three
prong electrical plug. Under no circumstances should the grounding prong of the
power cord be removed to facilitate connection to a non-approved outlet.
3.3 Checking Machine Operation
The handle should operate with relative ease. Leave it in the "up" or starting
position after testing several times.
With the handle in the starting position, check the pressure bar to ensure it can
be easily lowered and raised by the operator. Leave it in the "up" position after
testing several times.
The machine is now ready to operate. Instruct operator in proper punching and
binding procedures. Point out the operating instructions found in the waste tray,
and leave the owner's guide for the customer. Be sure to stress the importance of
the document being properly placed on the locating pin for binding.
3-1


Product specificaties

Merk: GBC
Categorie: Niet gecategoriseerd
Model: Velobind V800 Pro

Heb je hulp nodig?

Als je hulp nodig hebt met GBC Velobind V800 Pro stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd GBC

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd