Garmin GXM 54 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Garmin GXM 54 (8 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 266 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
GXMâ„¢ 54
INSTALLATION INSTRUCTIONS
Important Safety Information
Important Safety Information
Important Safety Information
Important Safety InformationImportant Safety Information
WARNING
The weather information provided through this product is subject to service interruptions and may contain
errors, inaccuracies, or outdated information, and consequently should not be relied upon exclusively. Always
use common sense while navigating, and check alternate weather information sources prior to making safety-
related decisions. You acknowledge and agree that you shall be solely responsible for use of the weather
information and all decisions taken with respect to navigating in weather. Garmin® will not be responsible for
any consequences of using SiriusXM® weather information.
When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or
product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the
product specifications. In addition, connecting the power cable without the appropriate fuse in place voids the
product warranty.
CAUTION
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
Software
Software
Software
SoftwareSoftware Update
Update
Update
Update Update
You must update the Garmin chartplotter software when you install this device. For instructions on updating
the software, see your chartplotter owner's manual at .support.garmin.com
GUID-D57F5CDC-08A4-43F8-90A0-2A457D4A398E v3July 2021
Antenna Mounting Considerations
Antenna Mounting Considerations
Antenna Mounting Considerations
Antenna Mounting ConsiderationsAntenna Mounting Considerations
You can mount the antenna on a flat surface or attach it to a standard 1 in. OD, 14 threads per inch, pipe-
threaded pole (not included). You can route the cable outside of the pole or through the pole. For best
performance, consider these guidelines when selecting the antenna mounting location.
• To ensure the best reception, the antenna should be mounted in a location that has a clear, unobstructed
view of the sky in all directions .
• The antenna should not be mounted where it is shaded by the superstructure of the boat , a radome
antenna, or the mast.
• The antenna should not be mounted near the engine or other sources of Electromagnetic Interference (EMI)
.
• If a radar is present, the antenna should be mounted above the path of the radar . If necessary, the
antenna may be mounted below the path of the radar .
• The antenna should not be mounted directly in the path of the radar .
• The antenna should be mounted at least 1 m (3 ft.) away from (preferably above) the path of a radar beam or
a VHF radio antenna .
Testing the Mounting Location
Testing the Mounting Location
Testing the Mounting Location
Testing the Mounting LocationTesting the Mounting Location
1Temporarily secure the antenna in the preferred mounting location and test it for correct operation.
2If you experience interference with other electronics, move the antenna to a different location, and test it
again.
3Repeat steps 1–2 until you observe full or acceptable signal strength.
4Permanently mount the antenna.
2
Surface Mounting the Antenna
Surface Mounting the Antenna
Surface Mounting the Antenna
Surface Mounting the AntennaSurface Mounting the Antenna
NOTICE
If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a
clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer
when the screws are tightened.
Before you permanently mount the antenna, you must test the mounting location for correct operation (Antenna
Mounting Considerations, page 2).
1Using the surface-mount bracket as your mounting template, mark the three pilot-hole locations and
trace the cable-hole in the center of the bracket.
2Set the surface-mount bracket aside.
Do not drill through the bracket.
3Drill the three 3.2 mm (1/8 in.) pilot holes.
4Drill the 25 mm (1 in.) cable hole in the center.
5Use the included M4 screws to secure the surface-mount bracket to the mounting surface.
6Route the cable through the center hole, and connect it to the antenna.
7Verify the large gasket is in place on the bottom of the antenna, place the antenna on the surface-mount
bracket, and twist it clockwise to lock it in place.
8Secure the antenna to the mounting bracket with the included M3 screw .
9Route the cable away from sources of electronic interference.
3


Product specificaties

Merk: Garmin
Categorie: Niet gecategoriseerd
Model: GXM 54

Heb je hulp nodig?

Als je hulp nodig hebt met Garmin GXM 54 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Garmin

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd