Garmin GPS 24xd NMEA 2000 Handleiding

Garmin Niet gecategoriseerd GPS 24xd NMEA 2000

Lees hieronder de 📖 handleiding in het Nederlandse voor Garmin GPS 24xd NMEA 2000 (36 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/36
GPS 24XD NMEA 2000®
INSTALLATION INSTRUCTIONS
Important Safety Information
Important Safety Information
Important Safety Information
Important Safety InformationImportant Safety Information
CAUTION
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
For the best performance and to avoid damage to your boat, read all installation instructions before
proceeding. Install the device per these instructions. Use the appropriate fasteners, tools, and mounts listed,
which are available at most marine dealers.
The Garmin® GPS 24xd NMEA 2000 high-sensitivity GPS antenna provides position information to your existing
NMEA 2000 network. If your boat does not have a NMEA 2000 network, you will need to install one.
For more information, go to .garmin.com
Tools Needed
Tools Needed
Tools Needed
Tools NeededTools Needed
• Drill
• 3.2 mm (1/8 in.) drill bit
• 19 mm (3/4 in.) drill bit for a pole-mount cable-hole
• 25 mm (1 in.) hole saw for a surface-mount cable-hole
• Countersink bit for mounting on fiberglass
• Screws for under-deck mounting
• Screwdriver, appropriate for the screw type
• Marine sealant (optional)
• Additional NMEA 2000 network components as needed
TA-2020/6796
GUID-28CE8C25-CFD8-4C12-B6D0-AD9CDF4D5084 v3June 2021
Mounting the Antenna
Mounting the Antenna
Mounting the Antenna
Mounting the AntennaMounting the Antenna
Antenna Mounting Considerations
Antenna Mounting Considerations
Antenna Mounting Considerations
Antenna Mounting ConsiderationsAntenna Mounting Considerations
CAUTION
Do not install or store the antenna near strong magnets, including speakers. A strong magnetic field can
damage the antenna.
You can mount the antenna on a flat surface or attach it to a standard 1 in. OD, 14 threads per inch, pipe-
threaded pole (not included). You can route the cable outside of the pole or through the pole. For best
performance, consider these guidelines when selecting the antenna mounting location.
• To ensure the best reception, the antenna should be mounted in a location that has a clear, unobstructed
view of the sky in all directions .
• The antenna should not be mounted where it is shaded by the superstructure of the boat , a radome
antenna, or the mast.
• The antenna should not be mounted near the engine or other sources of Electromagnetic Interference (EMI)
.
• The antenna should not be mounted near known ferrous metal objects such as a toolbox or compass.
• A handheld compass should be used to test for magnetic interference in the area where the antenna is to be
mounted. Your boat, motors, and devices must be on during the test.
If the needle on the handheld compass moves when you hold it where you intend to mount the antenna,
magnetic interference is present. You must choose another location and test again.
• Mounting screws are provided with the antenna. If you use mounting hardware other than the provided
screws, the hardware must be made of quality stainless steel or brass material to avoid magnetic
interference with the antenna.
NOTE: Test all mounting hardware with a handheld compass to make sure no magnetic fields are present in
the hardware.
• If a radar is present, the antenna should be mounted above the path of the radar . If necessary, the
antenna may be mounted below the path of the radar .
• The antenna should not be mounted directly in the path of the radar .
• The antenna should not be mounted within 1 m (3 ft.) of a VHF radio antenna or the path of a radar .
2
Testing the Mounting Location
Testing the Mounting Location
Testing the Mounting Location
Testing the Mounting LocationTesting the Mounting Location
1Temporarily secure the antenna in the preferred mounting location and test it for correct operation.
2If you experience interference with other electronics, move the antenna to a different location, and test it
again.
3Repeat steps 1–2 until you observe full or acceptable signal strength.
4Permanently mount the antenna.
3

Product specificaties

Merk: Garmin
Categorie: Niet gecategoriseerd
Model: GPS 24xd NMEA 2000

Heb je hulp nodig?

Als je hulp nodig hebt met Garmin GPS 24xd NMEA 2000 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Garmin

Garmin

Garmin dēzl Headset 210 Handleiding

13 November 2024
Garmin

Garmin Edge Power Mount Handleiding

2 Oktober 2024
Garmin

Garmin Approach Z30 Handleiding

23 Juli 2024
Garmin

Garmin Tacx NEO 3M Handleiding

25 Juni 2024
Garmin

Garmin Delta SE Handleiding

9 Juli 2023
Garmin

Garmin Foretrex 801 Handleiding

8 Juli 2023
Garmin

Garmin BMW Motorrad Navigator VI Handleiding

19 Juni 2023
Garmin

Garmin GSD 26 Handleiding

18 Juni 2023
Garmin

Garmin Dash Cam 54 Handleiding

15 Juni 2023
Garmin

Garmin Varia ERTL615 Handleiding

6 Juni 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Vitec

Vitec MGW Diamond-HX OG Handleiding

23 November 2024
Electrolux

Electrolux STA9 Handleiding

23 November 2024
Electrolux

Electrolux UMP3 Handleiding

23 November 2024
Electrolux

Electrolux ZS70GL Handleiding

23 November 2024
Bosch

Bosch HEZ8TK36UC Handleiding

23 November 2024
Bosch

Bosch HEZ8ZZ36UC Handleiding

23 November 2024
Bosch

Bosch HDZIT301 Handleiding

23 November 2024
Bosch

Bosch HEZBS301 Handleiding

23 November 2024
LG

LG LX-330 Handleiding

23 November 2024
Stamos

Stamos S-PLASMA 60U Handleiding

23 November 2024