Fellowes Powershred HS-440 Handleiding

Fellowes Niet gecategoriseerd Powershred HS-440

Lees hieronder de 📖 handleiding in het Nederlandse voor Fellowes Powershred HS-440 (8 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 242 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

Quality Office oducts Since 1917Pr

POWERSHRED

® HS-440

Please read these instructions before use.

Do not discard: keep for future reference.

Veuillez lire ces instructions avant d’utiliser l’appareil.

Ne pas jeter : conserver aﬁn de consulter les directives

ultérieurement, en cas de besoin.

Lea estas instrucciones antes del uso.

No las deseche: consérvelas como referencia futura.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

• Keepawayfromchildrenandpets.Keephandsawayfrom

paper entry. Always set to off or unplug when not in use.

• Keepforeignobjects–gloves,jewelry,clothing,hair,

etc.–awayfromshredderopenings.Ifobjectenterstop

opening, switch to Reverse ( ) to back out object.R

• Neveruseaerosolproducts,petroleumbasedlubricantsor

other flammable products on or near shredder. Do not use

canned air on shredder.

• Donotuseifdamagedordefective.Donotdisassemble

shredder. Do not place near or over heat source or water.

• ThisshredderhasaDisconnectPowerSwitch(C)inthedoor.Thedoor

must be closed to operate shredder. In case of emergency, open door.

This action will stop shredder immediately.

• Avoidtouchingexposedcuttingbladesundershredderhead.

• Shreddermustbepluggedintoaproperlygroundedwalloutletor

socket of the voltage and amperage designated on the label. The

grounded outlet or socket must be installed near the equipment and

easily accessible. Energy converters, transformers, or extension cords

should not be used with this product.

• Donotoperatethemachinewithoutthesafetyflapclosed(A).

Will shred: Paper only

Will not shred: Adhesive labels, continuous form paper, transparencies,

newspaper, junk mail, credit cards, CD/DVDs, staples, paper clips,

cardboard, laminates, file folders, X-rays or plastic other than noted above

Paper shred size:

High Security Micro-Cut (Din 6) 1/32 in. x 3/16 in. (0.8mm x 5.0mm)....

Maximum:

Sheets per pass ...................................................................................4*

Paper entry width 9-1/2 in. (241mm) ......................................................

* 8.5 in. x 11 in., 20lb., (75g) paper at 120V, 60 Hz, 3.2Amps; heavier

paper, humidity or other than rated voltage may reduce capacity.

Recommended maximum daily usage rates: 1,000 sheets per day.

4 sheets per pass.

*In order to perform at capacity, shredder must be plugged into

a dedicated 15Amp, 120V outlet and oiled every 15-30 minutes

of continuous use.

Stops automatically

when door is

opened. Symbols

flash alternately

Stops automatically

when bin is full.

Empty bag when

bag full indicator

lights up

H. Control Panel and LEDs

1. ON/OFF

2. Reverse

3. Bin full

4. Door open

5. Safety Flap Open

A. Safety Flap

B. Paper entry

C. Disconnect switch (open door)

D. Door

E. Wire Frame - paper (inside)

F. Casters

G. See safety instructions

Sleep Mode

Energy saving feature shuts down

the shredder after 1 hour of inactivity

ENGLISH

Model HS-440

KEY

INDICATOR LIGHTS

Stops automatically

if too much

paper is inserted.

Automatic reverse

if paper jams

Stops automatically

if safety flap is

opened. Symbols

flash alternately

Overload protection.

Machine stops to cool

down- approx. 10-15

minutes. Symbols

flash alternately

CAPABILITIES

ADVANCED PRODUCT FEATURES

All high security shredders require oil for peak performance. If not oiled,

a machine may experience diminished sheet capacity, intrusive noise when

shredding and could ultimately stop running. To avoid these problems, we

recommend you oil your shredder each time you empty your waste bin or

every 15-30 minutes of continuous use.

OILING SHREDDER

*Apply oil

across entry Press Reverse (R)

Set to Off ( )

and unplug

Important: For optimal shredding perfomance, use Fellowes High

Security oil (3505701). *Use of standard shredder oil is not

recommended.

SHREDDER SET-UP PAPER

Ensure access

to a dedicated

15Amp, 120V

outlet

41 3

Paper detection sensors are designed for maintenance free operation. However, on

rare occasions the sensors may become blocked by paper dust causing the motor to

run even if there is no paper present (Note: two paper detection sensors are located in the center

of the paper entry).

Turn off and

unplug shredder Locate Auto-start

infared sensor Clean any

contamination from

the paper sensors

12 3 4

Use thin, long-handled

brush to clean sensors.

Make sure brush is

clean and dry

Set to Off ( ) and empty bin. Replace bin and follow the below

procedures.

Stops automatically

if too much paper

is inserted.

Automatic reverse

if paper jams

2 3

Gently pull uncut

paper from

paper entry.

Machine runs for

a short time in

reverse. Repeat if

necessary

Fellowes is committed to giving our customers the support and service they deserve. That is why we offer several options for you to find technical

information, step-by-step assistance and personal attention.

•www.fellowes.com features an extensive on-line support section with a number of self-service options

•Ourcustomerserviceprofessionalsarededicatedtoresolveanyofyourissues

Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

Open the door

1 2 34

In sleep mode To get out of sleep

press ON ( ) insert paper

Shred One Sheet

BASIC SET-UP

BASIC PRODUCT MAINTENANCE AND TROUBLESHOOTING

CLEANING AUTO-START INFRARED SENSORS

PROBLEM STILL NOT SOLVED?

BASIC SHREDDING OPERATION

Place cutter head

into top of cabinet,

use 2 people

Plug in and make

sure door is closed Press ( ) ON to

activate When finished

shredding set to

( ) OFF

Feed paper

straight into paper

entry and release

Do nothing and

shredder will go

automatically to

sleep mode after

1 hour

Make sure safety

flap is securely

in place

PAPER JAM

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

WHEN IN SLEEP MODE

TO CLEAN THE SENSORS

Product specificaties

Merk:	Fellowes
Categorie:	Niet gecategoriseerd
Model:	Powershred HS-440

Heb je hulp nodig?

Als je hulp nodig hebt met Fellowes Powershred HS-440 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Fellowes

Fellowes 8038201 Handleiding

12 Maart 2024

Fellowes Office Suites 9140303 Handleiding

29 Mei 2023

Fellowes Hana Handleiding

21 Mei 2023

Fellowes Powershred HS-440 Handleiding

10 Mei 2023

Fellowes 8030901 Handleiding

1 Mei 2023

Fellowes 56211-73 TB 450 Handleiding

28 April 2023

Fellowes 8043401 Handleiding

24 April 2023

Fellowes 8043501 Handleiding

20 April 2023

Fellowes Astro A4 Handleiding

16 April 2023

Fellowes 8044101 Handleiding

9 April 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Blackburn Road Mirror Handleiding

18 December 2024

Blackburn Mountain Mirror Handleiding

18 December 2024

Hayter RANGER 48 PUSH Handleiding

18 December 2024

GPO Insight Handleiding

18 December 2024

AOpen DT3239D Handleiding

18 December 2024

AOpen WB5500 R Handleiding

18 December 2024

AOpen WT22M-FBG Handleiding

18 December 2024

Topeak Fixer 8 Handleiding

18 December 2024

Thermaltake The Tower 250 Handleiding

18 December 2024

Blackburn Multi-Mirror Handleiding

18 December 2024