Extron MBU 149 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Extron MBU 149 (3 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
Setup Guide — MBU 149
(Continued on reverse side)
The Extron® MBU 149 Under-Desk Mount Kit (part number
70-222-01) lets you attach an Extron 1U high device to the
underside of a desk or table, or to a wall. The brackets
extend approximately ¼" (6 mm) above the top surface of the
device, which allows an air space between the enclosure and
the mounting surface.
Installation
Step 1 — Attach brackets to device
Attach brackets to the device with the supplied machine
screws, as shown on the left side of the picture below.
Step 2 — Mark screw location
Hold the device with attached brackets against the
wall or the underside of the furniture, and
mark the screw hole locations (centers of
the brackets’ screw slots).
Step 3 — Drill holes
Drill four pilot
holes, each
3/32" (2 mm)
in diameter, ¼"
(6 mm) deep,
at the locations
marked in step .2
#8 Screw
(4 Places)
Each Side
Mounting Screws
(2 Places)
Each Side
Mounting
Bra tcke
Setup Guide — MBU 149, cont’d
Extron USA - West
Headquarters
+ 680 0.633.987
I Snside U A / C a anad Only
+1.71 04.4 91 .150
+1.71 74.491 .151 FAX
Extron USA - East
+ 6800.633.987
I Snside U A / C a anad Only
+1.919.86 3 .1794
+1.919.86 3 .1797 FAX
Extron Europe
+80 0.39 87.66 73
Inside E e urop Only
+31.3 5 03.4 3.404
+31.3 5 3.4 3.405 0 FAX
Extron Asia
+80 0.733 9.8766
Inside A a si Only
+65 .63 8 3.4400
+65 .63 8 3.46 64 FA X
Extron Japan
+81.3 .3511.7655
+81.3 .3511.7656 FAX
Extron China
+40 0 8 3.8 .156 8
Inside China Only
+86 .21.3 76 0.1568
+86 .21.3 76 0.1566 FAX
Extron Middle East
+971.4.2 991800
+971.4.2 99188 0 FAX
© 2009 Extron Electronics. All rights reserved.
68-704-01
Rev. B
09 09
Step 4 — Install screws
Insert the wood screws (provided) into the pilot holes. Fasten each screw into the furniture or
wall until the screw heads protrude slightly less than ¼" (6 mm) from the mounting surface.
Step 5 — Align brackets with screws
Align the screws with the slots in the mounting brackets and place the device against the
surface, with the screw heads through the bracket slots.
Step 6 — Adjust and fasten
Slide the device slightly forward or back, then tighten all screws to fasten it to the furniture or
wall, as shown on the right side of the diagram on the front of this guide.


Product specificaties

Merk: Extron
Categorie: Niet gecategoriseerd
Model: MBU 149

Heb je hulp nodig?

Als je hulp nodig hebt met Extron MBU 149 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Extron

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd