Extron CCB 30 Handleiding

Extron Niet gecategoriseerd CCB 30

Lees hieronder de 📖 handleiding in het Nederlandse voor Extron CCB 30 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

68-2820-01 Rev. A

06 15

CCB 30 Installation Guide

The CCB 30 Contact Closure Remote for Cable Cubby Series/2 contains three contact closure

buttons to control input selection on Extron switchers and products with contact closure control

ports. Assemble the CCB 30 module and wire it to the control product as shown in this guide.

To wire the captive screw connectors:

1. Strip away 3 inches of the outer jacket

from the end of the cable, and 3/16 inch

(5 mm) of the inner jacket from the end of

each wire.

2. Secure the wires to the captive

screw connector as shown

at right. Follow the wiring

diagram on the left.

NOTE: See the table on the back to determine the

appropriate current-limiting resistor, if needed.

Step 1:

Assemble the CCB 30

module.

Use the module screws (2)

to secure the CCB 30 on the

connectivity bracket.

Step 2:

Wire the CCB 30 module to a switcher or control product.

Step 3:

Install the CCB 30 module in a Cable Cubby 700.

Insert the CCB 30

module into the

Cable Cubby.

Secure the module

using the provided

mounting screws (4)

and washers (4) on

the front and back

of the enclosure.

C NO NC

Contact Closure

Input with Tally Output

RESISTOR

Contact (C)

Ground (G)

Tally output (T)

Tally voltage (+V)

Wiring Diagram:

Momentary switch (single pole)

on captive screw terminal

Blue

1A @

24 VDC /

125 CVA

N/A 4.52 k 13 k

Product specificaties

Merk:	Extron
Categorie:	Niet gecategoriseerd
Model:	CCB 30
Kleur van het product:	Zwart
Gewicht:	90 g
Breedte:	107 mm
Diepte:	3 mm
Hoogte:	39 mm
Gewicht verpakking:	240 g
Breedte verpakking:	178 mm
Diepte verpakking:	137 mm
Hoogte verpakking:	67 mm
Montagewijze:	Schroef