Exibel FX-117 Handleiding


Lees hieronder de πŸ“– handleiding in het Nederlandse voor Exibel FX-117 (12 pagina's) in de categorie Walkie talkie. Deze handleiding was nuttig voor 51 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
PMR Kommunikasjonsradio
Ver. 200905
Art.no. Model
36-3210 FX-117
PMR Two-Way Radio
Art.nr: 36-3210 Modell: FX-117
2

ο€ˆ
ο€ˆ
ο€ˆ
ο€ˆ
ο€ˆ
ο€ˆ
ο€ˆ
ο€ˆ
ο€ˆ
ο€ˆ
1. LCD Screen
Channel Number. Changes from 1 to
8 as selected by the user.
CTCSS Code. Changes from 1 to 38
as selected by the user.
Displays the Battery change level.
When the bars are reduced, the
battery needs recharging.
Displayed when transmitting a signal. TX
RX Displayed when receiving a signal.
DCM Displayed when the Dual Watch function is turned ON.
DCS Displayed when the Digital Code System is turned On.
VOX Displayed when the VOX feature is enabled.
SC Displays when the PMR is scanning all channels.
Displayed when the Key Lock feature is activated.
Displays the current Speaker volume level.
Displays when the call signal is ON.
Displays when the vibrator function is activated.
ο€šο€ο€†ο€‡ο€ο€ο€…
LCD Screen
- Displays the
current channel
selection and other
radio symbols.
PTT (PUSH to
TALK) button
–Press and hold to
transmi
t.
CALL button
-Press to send
Ringing tone to
other PMR units.
MENU Button
-Press to change
To switch between
odes.
Speaker
Ear/Mic/Charge
jack
PWR(POWER)
Button – Press
and hold to turn
the unit ON or
OFF.
MIC (Microphone)
UP/DOWN
Buttons –
Press to change
channels, volume,
and to select
settings during
programming.
3
2. Installation
2.1 Removing the Belt Clip
a. Pull the Belt Clip latch forward
(away from the FX-117)
b. While pulling the Belt Clip
latch, push up the Belt Clip as
shown in Figure1.
2.2 Installing the Belt Clip
a. Slide the Belt Clip into the
slot as shown in Figure2.
A β€œclick” indicates the Belt
Clip is locked into position.
2.3 Installing the Battery pack
Caution: Observe the proper battery polarity orientation when
installing batteries. Incorrect positioning can damage both the
batteries and the unit.
a. Slide down the Battery Compartment Cover.
b. Install the rechargeable battery pack by following the orientation
as shown in Figure 3 (the arrow is showing and pointing upward.)
c. Replace the Battery Compartment Cover. See Figure 4.
Important
Read these Safety Warnings before you charge the batteries.
When placing the FX-117 in the charger, use only the power
supplies listed in the user instructions supplied with the FX-117.
Don’t try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in
place when you are charging the batteries.
Dispose of used batteries safely and in a way that will not harm
the environment- never try to burn them or put them anywhere, they
could get burnt or punctured.
Don’t leave dead batteries in your FX-117 units.
They might leak if you do.
2.4 Charging the battery pack
a. Insert the small plug on the end of the mains adaptor into the
Power-in Connection Jack at the back of the desktop charger.
b. Plug the mains adaptor into a 240V AC, 50Hz main socket with
the switch on the socket set to OFF.
c. Switch ON the main socket.
The FX-117 must be charged using the mains adaptor provided.
Using any other adaptor will result in non-compliance with
EN60950-1 and will invalidate any approvals & warranty.
Belt Clip latch
Figure 1
Figure 2
Figure 3
Figure 4


Product specificaties

Merk: Exibel
Categorie: Walkie talkie
Model: FX-117

Heb je hulp nodig?

Als je hulp nodig hebt met Exibel FX-117 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Walkie talkie Exibel

Handleiding Walkie talkie

Nieuwste handleidingen voor Walkie talkie