Elektrobock PT14-P Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Elektrobock PT14-P (12 pagina's) in de categorie Thermostaat. Deze handleiding was nuttig voor 112 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
Intended for:
•direct heaters
radiant panels
electric oor heating
2
INSTALLATION AND LOCATION
Install the thermostat at a suitable place where its operation cannot be affected by direct ow
of hot air from the heater, sunshine or other disturbing effects. Neither install it on an external
wall. The installation height should be approx. 1.5 m above the oor. Place the thermostat in
the “reference room”, such as the living room (the heating source will switch according to the
temperature in this room).
The installation must only be done by a properly qualifi ed person!
Before installation, disconnect the power supply!
1) Switch off the main circuit breaker.
2) Loosen the locking screw and remove the front part of the thermostat with the
electronics (Fig. 1).
3) Fix the back part of the thermostat to the wall (Fig. 2).
4) Connect the wires to the terminal board; take heed to proper tightening of the
terminals.
5) Put on the front part of the thermostat with LCD and ensure the thermostat with the
locking screw against splitting.
6) Switch on the main circuit breaker. If everything is OK, the LCD shows the current
temperature.
7) Set the thermostat parameters and the required temperature program according to the
instructions.
INSTALLATION PROCEDURE
PT14-P DESCRIPTION
When heating is
switched on,
LED is lit
entry into the menu (AUTO, MANU,
OFF, CLO, PROG, PAr)
short push = confi rmation (ENTER)
long push = step back
browsing the functions of
temperature setting, time, key
locking; see page 10
RESET button
backlit display
(active for 30 s after
you push any button)
internal temperature sensor
3
Fig.1 Loosen the locking screw and remove
the thermostat electronics.
Fig.2 Fix the back part of the thermostat
to the wall.
Fig.3 Connect the inlet wires according
to the diagram.
Fig.4 Put the electronics part onto the bottom
part and ensure it with the locking screw.
L
N
HEATING-
max. 16 A
UNUSED
holes for installation screws


Product specificaties

Merk: Elektrobock
Categorie: Thermostaat
Model: PT14-P

Heb je hulp nodig?

Als je hulp nodig hebt met Elektrobock PT14-P stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Thermostaat Elektrobock

Handleiding Thermostaat

Nieuwste handleidingen voor Thermostaat