Electia RCA-8N Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Electia RCA-8N (5 pagina's) in de categorie Alarm ringer. Deze handleiding was nuttig voor 17 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/5
RCA-8N
OWNERS MANUAL
Art. 36.2870
GB
Remote Controller (RCA-8N)
The Remote Controller is used to remotely arm or disarm the system, activate the panic alarm, and put the system in the "HOME"
mode.
î™ș
î™ș
I
Id
de
en
nt
ti
if
fy
yi
in
ng
g
t
th
he
e
p
pa
ar
rt
ts
s
BUTTON
Pressing this button will put the system into the Armed
mode.
BUTTON
Pressing this button for 3 seconds will trigger the panic
alarm regardless of whether the system is Armed,
Disarmed or Home.
BUTTON
Pressing this button will put the system into the Home mode.
BUTTON
Pressing this button will put the system into the Disarmed mode. If the alarm is sounding, pressing this button will stop
the alarm (except when the alarm situation was caused by pressing the Panic button on RCA-8N).
TX INDICATOR
BATTERY COMPARTMENT
1
2
3
4
5
6
î™ș
î™ș
TTXX IInnddiiccaattoorr
When any of these four buttons is hold the button until the TX LED is pressed, TX LED will on. Please
off to indicate the Remote Controller has successfully sent out a signal to the Main Unit.
<
<N
NO
OT
TE
E>
>
 Press & hold the Panic button for one second then release. The Tx LED will light on for one sec., press & hold the
Panic Button (one sec) again
î™ș
î™ș
“CR2032” 3V 230 mAh Lithium battery as its power source. Battery life is over 2 years in a
normal domestic environment.
sent to the Control Panel along with regular signal transmission, and, the Control Panel will
display the status accordingly.
B
Ba
at
tt
te
er
ry
y
The Remote Controller uses one
The low battery status will be
î™ș
î™ș
G
Ge
et
tt
ti
in
ng
g
S
St
ta
ar
rt
te
ed
d
tery facing down.
then select “Add Device” menu.
Please refer to the operation manual of your control panel under the section of “Device +/-“ to complete learn-in process.
î™ș Remove the battery cover by using a coin to turn counter-clockwise.
î™ș Insert the battery as shown in diagram, with unmarked side (negative) of the bat
î™ș Replace the battery cover – secure the cover by using a coin to turn clockwise.
î™ș Put the Control Panel into “Device +/-“ menu and
î™ș Press any buttons on the Remote Controller.
î™ș
SE
FjÀrrkontroll (RCA-8N)
FjĂ€rrkontrollen anvĂ€nds till för att larma pĂ„/av systemet, aktivering av överfalls larm, och stĂ€lla in systemet pĂ„ “Skalskydds” lĂ€ge.
î™ș
î™ș
F
Fj
jÀ
Ă€r
rr
rk
ko
on
nt
tr
ro
ol
ll
le
en
ns
s
o
ol
li
ik
ka
a
d
de
el
la
ar
r
KNAPP
Genom att trycka ned denna knapp larmar du pÄ
systemet.
KNAPP
Genom att trycka ned denna knapp I 3 sekunder utöses
ett överfalls larm oavsett om eller systemet Àr pÄlarmat,
avlarmat eller i skalskydds lÀge.
KNAPP
Genom att trycka ned denna knapp larmar du pÄ systemet i
Skalskydds lÀge.
KNAPP
Tryck ned denna knapp och systmet kommer att stÀlla in sig pÄ avlarmat lÀge. Om larmet ger ifrÄn sig ljud, kan du
stoppa larmet genom att trycka ned denna knapp. (förutom nÀr larm situationen orsakades genom att trycka ned
överfalls knappen pÄ (RCA-8N). OBS! För att kunna larma av kontrollpanelen med fjÀrrkontrollen mÄste
standardinstÀllningen under meny fjÀrrkontroll Àndras.
LED lampa
BATTERI LUCKA
1
2
3
4
5
6
î™ș
î™ș
T
TX
X
I
In
nd
di
ik
ka
at
to
or
r
NÀr nÄgon av de fyra knapparna trycks ned, sÀtts LED lampan pÄ. HÄll ned knappen till LED lampan slocknar, detta indikerar
att fjÀrrkontrollen lyckats sÀnda en godkÀnd signal till kontrollpanelen.
<
<N
NO
OT
TE
ER
RA
A>
>
 Tryck ned & hÄll nere överfalls knappen I en sekund innan den frigörs. Tx LED kommer att lysa upp i en sek.,
tryck ned & hÄll överfalls knappen (en sek) igen
î™ș
î™ș
r ett “CR2032” 3V 230 mAh Litium batteri som dess strömkĂ€lla. Batteriets livslĂ€ngd Ă€r över 2 Ă„r i en
s till Kontroll Panelen med regelbundna signal överföringar, och, Kontroll Panelen kommer
att visa status pÄ displayen dÀrefter.
B
Ba
at
tt
te
er
ri
i
FjÀrrkontrollen anvÀnde
normal hemma miljö.
LĂ„gt batteri status kommer att skicka
î™ș
î™ș
K
Ko
om
mm
ma
a
i
ig
gÄ
Ă„n
ng
g
nedÄt.
n och vĂ€lj sedan menyn “LĂ€gg till sensor”.
ar god lĂ€s din manual för din Kontroll Panel under sektionen av “Sensor +/-“ för att fullfölja testprocessen.
î™ș Ta bort batteriluckan genom att anvĂ€nda ett mynt som vrids moturs.
î™ș SĂ€tt I batterierna som visas av diagrammet, med den omĂ€rkta sidan (negativa) pĂ„ batteriet
î™ș SĂ€tt tillbaka batteriluckan – sĂ€ker stĂ€ngning genom att anvĂ€nda myntet och vrida medurs.
î™ș StĂ€ll in Kontroll Panelen pĂ„ “Sensor +/-“ meny
î™ș Tryck ned valfri knapp pĂ„ fjĂ€rrkontrollen.
V


Product specificaties

Merk: Electia
Categorie: Alarm ringer
Model: RCA-8N

Heb je hulp nodig?

Als je hulp nodig hebt met Electia RCA-8N stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Alarm ringer Electia

Handleiding Alarm ringer

Nieuwste handleidingen voor Alarm ringer